Abstract
Various thermal-hydrologic models have been developed to simulate thermal-hydrologic conditions in emplacement drifts and surrounding host rock for the proposed high-level nuclear waste repository at Yucca Mountain, Nevada. The modeling involves two-phase (liquid and gas) and two-component (water and air) transport in a fractured-rock system, which is conceptualized as a dual-permeability medium. Simulated hydrologic processes depend upon calibrated system parameters, such as the van Genuchten α and m, which quantify the capillary properties of the fractures and rock matrix. Typically, these parameters are not calibrated for strongly heat-driven conditions, i.e., conditions for which boiling and rock dryout occur. The objective of this study is to modify the relationship between capillary pressure and saturation, P c(S), for strongly heated conditions that drive saturation below the residual saturation (S → 0). We offer various extensions to the van Genuchten capillary-pressure function and compare results from a thermal-hydrologic model with data collected during the Drift-Scale Test, an in situ thermal test at Yucca Mountain, to investigate the suitability of these various P c extension methods. The study suggests that the use of extension methods and the imposition of a capillary-pressure cap (or maximum) improve the agreement between Drift-Scale Test data and model results for strongly heat-driven conditions. However, for thermal-hydrologic models of the Yucca Mountain nuclear waste repository, temperature and relative humidity are insensitive to the choice of extension method for the capillary-pressure function. Therefore, the choice of extension method applied to models of drift-scale thermal-hydrologic behavior at Yucca Mountain can be made on the basis of numerical performance.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Birkholzer J.T.: Estimating liquid fluxes in thermally perturbed fractured rock using measured temperature profiles. J. Hydrol. 327, 496–515 (2006)
Birkholzer J.T., Tsang Y.W.: Modeling the thermal-hydrologic processes in a large-scale underground heater test in partially saturated fractured tuff. Water Resour. Res. 36(6), 1431–1447 (2000)
Brooks R.H., Corey A.T.: Properties of porous media affecting fluid flow. J. Irrig. Drain. Div. Am. Soc. Civ. Eng. 92, 61–87 (1996)
Buscheck T.A., Rosenberg N.D., Gansemer J., Sun Y.: Thermohydrologic behavior at an underground nuclear waste repository. Water Resour. Res. 38(3), 1431–1447 (2002)
Buscheck, T.A., Sun, Y., Hao, Y.: Multiscale thermohydrologic model supporting the license application for the Yucca Mountain Repository, American Nuclear Society, La Grange Park, IL. In: Proceedings 2006 International High-Level Radioactive Waste Management Conference, Las Vegas, 30 April–4 May 2006
Campbell G.S.: A simple method for determining unsaturated conductivity from moisture retention data. Soil Sci. 117, 311–314 (1974)
Campbell, G.S., Shiozawa, S.: Prediction of hydraulic properties of soils using particle-size distribution and bulk density data. In: International Workshop on Indirect Methods for Estimating the Hydraulic Properties of Unsaturated Soils, University of California, Riverside, CA (1992)
Fayer M.J., Simmon C.S.: Modified soil water retention functions for all matric suctions. Water Resour. Res. 31(5), 1233–1238 (1995)
Finsterle S.: iTOUGH Command Reference. Lawrence Berkeley National Laboratory, LBNL-40041, Berkeley (2002)
Flint, L.E.: Characterization of hydrogeologic units using matrix properties, Yucca Mountain, Nevada, U.S. Geological Survey Water Resources Investigations Report, 98–4243, 64 pp (1998)
Glascoe L.G., Buscheck T.A., Gansemer J., Sun Y., Lee K.: Multiscale thermohydrologic model analyses of heterogeneity and thermal-loading factors for a proposed nuclear waste repository. Nucl. Technol. 48, 125–137 (2004)
Khlosi M., Cornelis W.M., Gabriels D., Sin G.: Simple modification to describe the soil water retention curve between saturation and oven dryness. Water Resour. Res. 42(12), W11501 (2006). doi:10.1029/2005WR004699
Kolditz O., De Jonge J.: Non-isothermal two-phase flow in low-permeable porous media. Comput. Mech. 33, 345–364 (2004)
Kosugi K.: General model for unsaturated hydraulic conductivity for soils with log-normal pore-size distribution. Soil Sci. Soc. Am. J. 63, 270–277 (1999)
Li, K., Horne, R.N.: Steam-water capillary pressure. In: Proceedings of the World Geothermal Congress, Antalya, Turkey, 24–29 April 2005
Lin, W., Sun, Y.: Thermal hydrological processes in the drift-scale thermal test at Yucca Mountain, Nevada. Lawrence Livermore National Laboratory, California, UCRL-JRNL-219897 (2006)
Liu H.H., Doughty C., Bodvarsson G.S.: An active fracture model for unsaturated flow and transport in fractured rocks. Water Resour. Res. 34(10), 2633–2646 (1988)
Luckner L., van Genuchten M.T.H., Nielson D.R.: A consistent set of parametric models for the two-phase flow of immiscible fluids in the subsurface. Water Resour. Res. 25, 2187–2193 (1989)
Morel-Seytoux H.J., Nimmo J.R.: Soil water retention and maximum capillary drive from saturation to oven dryness. Water Resour. Res. 35(7), 2031–2041 (1999)
Mukhopadhyay S., Tsang Y., Birkholzer J.T.: Estimation of field-scale thermal conductivities of unsaturated rock from in situ temperature data. Water Resour. Res. 43, W09418 (2007). doi:10.1029/2006WR005283
Nieber J.L., Dautov R.Z., Egorov A.G., Sheshukov A.Y.: Dynamic capillary pressure mechanism for instability in gravity-driven flows: review and extension to very dry conditions. Transp. Porous Med. 58, 147–172 (2005)
Nitao, J.J.: User’s Manual for the USNT Module of the NUFT Code, Version 2 (NP-phase, NC-component, thermal). Lawrence Livermore National Laboratory, UCRL-MA-130653 (1998)
Nitao J.J., Bear J.: Potentials and their role in transport in porous media. Water Resour. Res. 32(2), 225–250 (1996)
Ross P.J., Williams J., Bristow K.L.: Equation for extending water-retention curves to dryness. Soil Sci. Soc. Am. J. 55, 923–927 (1991)
Rossi C., Nimmo J.R.: Modeling of soil water retention from saturation to oven dryness. Water Resour. Res. 30(3), 701–708 (1994)
Rutqvist J., Barr D., Datta R., Gens A., Millard A., Olivella S., Tsang C.-F., Tsang Y.: Coupled thermal-hydrological-mechanical analyses of the Yucca Mountain Drift Scale Test–Comparison of field measurements to predictions of four different numerical models. Int. J. Rock Mech. Min. Sci. 42, 680–697 (2005)
Sandia National Laboratories (SNL): Multiscale Thermohydrologic Model. ANL-EBS-000049 REV 03 AD 01, Las Vagas, Nevada (2007)
Spycher N.F., Sonnenthal E.L., Apps J.A.: Fluid flow and reactive transport around potential nuclear waste emplacement tunnels at Yucca Mountain, Nevada. J. Contam. Hydrol. 62–63, 653–673 (2003)
Sun, Y., Buscheck, T.A., Hao, Y.: Influence of hydrologic heterogeneity on thermal-hydrologic conditions in emplacement drifts, American Nuclear Society, La Grange Park, IL. In: Proceedings 2006 International High-Level Radioactive Waste Management Conference, Las Vegas, 30 April–4 May 2006
van Genuchten M.T.H.: A closed-form equation for predicting the hydraulic conductivity of unsaturated soils. Soil Sci. Soc. Am. J. 44, 892–898 (1980)
Webb S.W.: A simple extension of two-phase characteristic curves to include the dry region. Water Resour. Res. 36(6), 1425–1430 (2000)
Zhou Q., Liu H.H., Bodvarsson G.S., Oldenburg C.M.: Flow and transport in unsaturated fractured rock: effect of multiscale heterogeneity of hydrogeologic properties. J. Contam. Hydrol. 60, 1–30 (2003)
Acknowledgments
This study was performed under the auspices of the U.S. Department of Energy by Lawrence Livermore National Laboratory under Contract No. DE-AC52-07NA27344. Sandia is a multiprogram laboratory operated by Sandia Corporation, a Lockheed Martin Company, for the United States Department of Energy’s National Nuclear Security Administration under contract DE-AC04-94AL85000. The authors wish to thank anonymous reviewers for their careful review and helpful comments that have led to an improved manuscript.
Open Access
This article is distributed under the terms of the Creative Commons Attribution Noncommercial License which permits any noncommercial use, distribution, and reproduction in any medium, provided the original author(s) and source are credited.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
Open Access This is an open access article distributed under the terms of the Creative Commons Attribution Noncommercial License (https://creativecommons.org/licenses/by-nc/2.0), which permits any noncommercial use, distribution, and reproduction in any medium, provided the original author(s) and source are credited.
About this article
Cite this article
Sun, Y., Buscheck, T.A., Lee, K.H. et al. Modeling Thermal-Hydrologic Processes for a Heated Fractured Rock System: Impact of a Capillary-Pressure Maximum. Transp Porous Med 83, 501–523 (2010). https://doi.org/10.1007/s11242-009-9459-1
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11242-009-9459-1