Abstract
This chapter describes the equipment required for manual adhesive bonding processes. For some readers, the comments about equipment may seem trivial, but they are important as nonobservance of these points can in practice lead to flawed bonded joints.
The individual components which make up mixing and dosing systems have been described and their special features outlined in an attempt to quantify the hitherto qualitative descriptions that have prevailed in the literature.
Thereafter, some basics of automation and robotics are outlined with a special excursion on the topic parameters affecting accuracy. Terminal opportunities of accelerated curing are explained using the examples of UV radiation and inductive heating.
This is a preview of subscription content, log in via an institution to check access.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
References
With the exception of articles in a few technical journals, little has been published about industrial adhesive bonding technology. Anyone wishing to acquire a deeper understanding of this topic is recommended to refer to the two books listed below
Cognard P (ed) (2006) Adhesive and sealants, handbook of adhesives and sealants, vol 2. Elsevier, Amsterdam
Endlich W (1998) Kleb- und Dichtstoffe in der modernen Technik; ein Praxishandbuch der Kleb- und Dichtstoffanwendung. Vulkan-Verlag, Essen
Sauer J (1989) Neue Aspekte der Qualitätssicherung bei der Herstellung von Klebeverbindungen mit zweikomponentigen Klebstoffen. Heinrich Vogel Fachzeitschrift GmbH, Aachen
Acknowledgments
The presented findings were made within ZeDeMAB. Project 18155 N ZeDeMAB (project term: 01.05.2014 – 30.04.2016) of the Forschungsvereinigung Schweißen und verwandte Verfahren e.V. of the DVS, Aachener Straße 172, 40223 Düsseldorf, was funded via the AiF under the CORNET program of the Federal Ministry of Economics and Technology following a decision by the German Parliament. We are most grateful for this financial support.
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2018 Springer International Publishing AG, part of Springer Nature
About this entry
Cite this entry
Peschka, M. (2018). Equipment for Adhesive Bonding. In: da Silva, L., Öchsner, A., Adams, R. (eds) Handbook of Adhesion Technology. Springer, Cham. https://doi.org/10.1007/978-3-319-55411-2_38
Download citation
DOI: https://doi.org/10.1007/978-3-319-55411-2_38
Published:
Publisher Name: Springer, Cham
Print ISBN: 978-3-319-55410-5
Online ISBN: 978-3-319-55411-2
eBook Packages: EngineeringReference Module Computer Science and Engineering