Encyclopedia of Continuum Mechanics

Living Edition
| Editors: Holm Altenbach, Andreas Öchsner

Singular Solutions in Plane Strain Plasticity

  • Sergei AlexandrovEmail author
Living reference work entry
DOI: https://doi.org/10.1007/978-3-662-53605-6_367-1

Synonyms

Definitions

  1. 1.

    The maximum friction law demands that the friction stress is equal to the shear yield stress in the case of pressure-independent models considered,

     
  2. 2.

    The maximum friction law demands that the friction surface coincides with a stress characteristic or an envelope of stress characteristics in the case of the double-shearing model,

     
  3. 3.

    The maximum friction surface is a surface with maximum friction,

     
  4. 4.

    The strain rate intensity factor is the coefficient of the leading term in a series expansion of the quadratic invariant of the strain rate tensor in the vicinity of maximum friction surfaces.

     
The definition for the maximum friction law above applies at sliding.

Introduction

The successful mathematical modelling of the material behavior in the...

This is a preview of subscription content, log in to check access.

Notes

Acknowledgements

This work was made possible by grant 17-01-00624 from RFBR (Russia).

References

  1. Alexandrov S, Harris D (2006) Comparison of solution behaviour for three models of pressure-dependent plasticity: a simple analytical example. Int J Mech Sci 48(7):750–762CrossRefGoogle Scholar
  2. Alexandrov S, Jeng Y-R (2013) Singular rigid/plastic solutions in anisotropic plasticity under plane strain conditions. Cont Mech Therm 25(5):685–689MathSciNetCrossRefGoogle Scholar
  3. Alexandrov S, Mishuris G (2009) Qualitative behaviour of viscoplastic solutions in the vicinity of maximum-friction surfaces. J Eng Math 65(2):143–156MathSciNetCrossRefGoogle Scholar
  4. Alexandrov S, Richmond O (2001) Singular plastic flow fields near surfaces of maximum friction stress. Int J Non-Linear Mech 36(1):1–11MathSciNetCrossRefGoogle Scholar
  5. Facchinetti M, Miszuris W (2016) Analysis of the maximum friction condition for green body forming in an ANSYS environment. J Eur Cer Soc 36:2295–2302CrossRefGoogle Scholar
  6. Griffiths B (1987) Mechanisms of white layer generation with reference to machining and deformation processes. ASME J Trib 109(3):525–530CrossRefGoogle Scholar
  7. Hill R (1950) The mathematical theory of plasticity. Clarendon Press, OxfordzbMATHGoogle Scholar
  8. Spencer A (1964) A theory of the kinematics of ideal soils under plane strain conditions. J Mech Phys Solids 12:337–351MathSciNetCrossRefGoogle Scholar

Copyright information

© Springer-Verlag GmbH Germany, part of Springer Nature 2019

Authors and Affiliations

  1. 1.Ishlinsky Institute for Problems in MechanicsRussian Academy of SciencesMoscowRussia

Section editors and affiliations

  • Sergey Alexandrov
    • 1
  1. 1.Ishlinsky Institute for Problems in MechanicsRussian Academy of SciencesMoscowRussia