1. Quantitative methods for estimating the anisotropy of the strength properties and the phase composition of Mg-Al alloys

   • S. Ya. Betsofen
   • Yu. R. Kolobov
   • I. I. Voskresenskaya

   Physical Foundations of Strength and Plasticity 04 August 2015 Pages: 257 - 263

2. Plastic deformation of ultrafine-grained metallic materials

   • E. V. Kozlov
   • N. A. Popova
   • N. A. Koneva

   Physical Foundations of Strength and Plasticity 04 August 2015 Pages: 264 - 268

3. Cyclic character of the evolution of the defect structure and the properties of metallic materials during megaplastic deformation

   • L. S. Metlov
   • A. M. Glezer
   • V. N. Varyukhin

   Physical Foundations of Strength and Plasticity 04 August 2015 Pages: 269 - 273

4. Physical criterion for the time-temperature stability of the mechanical behavior of amorphous alloys

   • A. M. Glezer
   • E. N. Blinova
   • N. A. Shurygina

   Physical Foundations of Strength and Plasticity 04 August 2015 Pages: 274 - 277

5. Modification of the microstructure of TiN-based columnar coatings in indentation zones

   • S. V. Ovchinnikov
   • A. D. Korotaev
   • Yu. P. Pinzhin

   Promising Materials and Technologies 04 August 2015 Pages: 278 - 284

6. Wear products that form during tribological tests of aluminum-matrix composite materials

   • I. E. Kalashnikov
   • L. K. Bolotova
   • A. G. Kolmakov

   Promising Materials and Technologies 04 August 2015 Pages: 285 - 289

7. Structure and properties of amorphous finemet alloy microwires produced by the Ulitovskii-Taylor method

   • V. V. Molokanov
   • T. R. Chueva
   • A. N. Shalygin

   Promising Materials and Technologies 04 August 2015 Pages: 290 - 294

8. Effect of the fraction and direction of high-pressure torsion deformation in a Bridgman cell on the structure and mechanical properties of commercial-purity iron

   • A. M. Glezer
   • A. A. Tomchuk
   • T. V. Rassadina

   Structure and Properties of the Deformed State 04 August 2015 Pages: 295 - 300

9. Evolution of the microstructure of a VT6 alloy during friction stir welding

   • S. Yu. Mironov

   Structure and Properties of the Deformed State 04 August 2015 Pages: 301 - 308

10. Mechanical properties of a pipe workpiece at the stages of JCOE pipe forming

    • I. P. Shabalov
    • D. M. Solov’ev
    • O. V. Livanova

    Applied Problems of Strength and Plasticity 04 August 2015 Pages: 309 - 316

11. Low-cycle fatigue of a VZh175 high-temperature alloy under elastoplastic deformation conditions

    • M. S. Belyaev
    • V. F. Terent’ev
    • M. A. Gol’dberg

    Applied Problems of Strength and Plasticity 04 August 2015 Pages: 317 - 323

12. Structural changes and damage of single-crystal turbine blades during life tests of an aviation gas turbine engine

    • O. G. Ospennikova
    • M. R. Orlov
    • R. M. Nazarkin

    Applied Problems of Strength and Plasticity 04 August 2015 Pages: 324 - 331

13. Effect of internal nitriding on the fatigue strength of ferritic corrosion-resistant steel

    • S. O. Rogachev
    • S. A. Nikulin
    • R. O. Savicheva

    Applied Problems of Strength and Plasticity 04 August 2015 Pages: 332 - 337