1. The use of corrostion-resistant steels for dies

   • R. R. Faskhutdinov
   • V. N. Zhuravlev
   • O. I. Nikolaeva

   Tool Steels Pages: 231 - 237

2. Influence of the original structure, heat-treatment cycles, and deformation on the mechanical properties of Kh12M steel

   • V. A. Evstratov
   • V. I. Eremin
   • V. M. Pivovarov

   Tool Steels Pages: 237 - 239

3. The impact-fatigue strength of cast and wrought high-speed steels

   • V. E. Cherkasov
   • N. M. Yakshin
   • I. M. Kavitskii

   Tool Steels Pages: 240 - 244

4. Effect of heat treatment method on the properties of steel ON6

   • B. P. Sharov
   • N. I. Karchevskaya
   • V. V. Pavlov

   Structural Steels Pages: 245 - 248

5. Effect of controlled rolling on the mechanical properties of low-alloy steel H-beams

   • V. M. Farber
   • V. N. Davydov
   • E. G. Zudov

   Structural Steels Pages: 248 - 251

6. Ratio Mn:C and impact toughness of high manganese steel

   • S. E. Kondratyuk
   • B. B. Vinokur
   • O. G. Kasatkin

   Structural Steels Pages: 251 - 255

7. Kinetics of austenite transformation and internal stresses in bainitic hardening of bearing steel

   • A. N. Kulakov
   • A. S. Kagan
   • A. A. Kapyrin

   Structural Steels Pages: 255 - 257

8. Proneness to hot embrittlement of welded joints in steel 09G2S

   • V. M. Goritskii
   • G. R. Shneiderov
   • E. M. Basko

   Structural Steels Pages: 258 - 261

9. Solubility of sulfur in steel 100Kh13M in the presence of manganese and silicon

   • E. F. Petrova
   • L. A. Shvartsman
   • Yu. P. Konnov

   Structural Steels Pages: 262 - 265

10. Steels for cryogenic power engineering

    • B. S. Ermakov
    • A. Ya. Nikolaich
    • V. A. Oparin

    Structural Steels Pages: 265 - 267

11. Effect of zirconium on the structure and phase composition of steel 03Kh8SYu

    • V. A. Tarzhumanova
    • A. V. Ryabchenkov
    • A. V. Shatunova

    Stainless Steels Pages: 268 - 272

12. Effect of nitrogen on the phase composition and physical and mechanical properties of stainless austenitic-pearlitic steels

    • G. G. Kolchin
    • N. V. Korolev
    • B. S. Ermakov

    Stainless Steels Pages: 272 - 276

13. Solubility of titanium and niobium carbides in high-chromium ferrite

    • N. A. Gorokhova
    • V. I. Sarrak
    • S. O. Suvorova

    Stainless Steels Pages: 276 - 279

14. Magnetic transformation in chronium-magnesium steel Kh15G16N2Yu2

    • O. A. Bannykh
    • P. E. Merinov
    • S. D. Éntin

    Stainless Steels Pages: 280 - 281

15. Alloying capacity for the solid solution of alloys obtained by crystallizing under pressure

    • T. N. Lipchin

    Nonferrous Metals and Alloys Pages: 282 - 285

16. The effect of microalloying on the structure and properties of Al−Zn−Mg−Cu alloys

    • I. N. Feidlander
    • E. A. Tkachenko
    • E. N. Matveets

    Nonferrous Metals and Alloys Pages: 285 - 290

17. The effect of phosphorus on the structure and strength of Cu−Ni alloys

    • V. N. Klimenko
    • V. A. Maslyuk
    • L. I. Tsygankova

    Nonferrous Metals and Alloys Pages: 290 - 293

18. Formation of the structure of brass L80 foil

    • N. K. Mochalin
    • Z. K. Zastol'skaya
    • L. A. Lisitskaya

    Nonferrous Metals and Alloys Pages: 294 - 296

19. The influence of autofrettage on the structure of gears

    • G. A. Zhuravlev
    • A. I. Ageev
    • L. D. Zaguskina

    Strength Properties Pages: 297 - 301

20. Crack resistance as a criterion of the effectiveness of roll steel

    • M. Ya. Belkin
    • V. Z. Kamalov
    • L. M. Belkin

    Strength Properties Pages: 302 - 306

21. The mechanical properties and character of failure of steel after repeated thermomechanical strengthening of the surface layer

    • N. K. Kryuchkov

    Strength Properties Pages: 307 - 310