The use of corrostion-resistant steels for dies R. R. FaskhutdinovV. N. ZhuravlevO. I. Nikolaeva Tool Steels Pages: 231 - 237
Influence of the original structure, heat-treatment cycles, and deformation on the mechanical properties of Kh12M steel V. A. EvstratovV. I. EreminV. M. Pivovarov Tool Steels Pages: 237 - 239
The impact-fatigue strength of cast and wrought high-speed steels V. E. CherkasovN. M. YakshinI. M. Kavitskii Tool Steels Pages: 240 - 244
Effect of heat treatment method on the properties of steel ON6 B. P. SharovN. I. KarchevskayaV. V. Pavlov Structural Steels Pages: 245 - 248
Effect of controlled rolling on the mechanical properties of low-alloy steel H-beams V. M. FarberV. N. DavydovE. G. Zudov Structural Steels Pages: 248 - 251
Ratio Mn:C and impact toughness of high manganese steel S. E. KondratyukB. B. VinokurO. G. Kasatkin Structural Steels Pages: 251 - 255
Kinetics of austenite transformation and internal stresses in bainitic hardening of bearing steel A. N. KulakovA. S. KaganA. A. Kapyrin Structural Steels Pages: 255 - 257
Proneness to hot embrittlement of welded joints in steel 09G2S V. M. GoritskiiG. R. ShneiderovE. M. Basko Structural Steels Pages: 258 - 261
Solubility of sulfur in steel 100Kh13M in the presence of manganese and silicon E. F. PetrovaL. A. ShvartsmanYu. P. Konnov Structural Steels Pages: 262 - 265
Steels for cryogenic power engineering B. S. ErmakovA. Ya. NikolaichV. A. Oparin Structural Steels Pages: 265 - 267
Effect of zirconium on the structure and phase composition of steel 03Kh8SYu V. A. TarzhumanovaA. V. RyabchenkovA. V. Shatunova Stainless Steels Pages: 268 - 272
Effect of nitrogen on the phase composition and physical and mechanical properties of stainless austenitic-pearlitic steels G. G. KolchinN. V. KorolevB. S. Ermakov Stainless Steels Pages: 272 - 276
Solubility of titanium and niobium carbides in high-chromium ferrite N. A. GorokhovaV. I. SarrakS. O. Suvorova Stainless Steels Pages: 276 - 279
Magnetic transformation in chronium-magnesium steel Kh15G16N2Yu2 O. A. BannykhP. E. MerinovS. D. Éntin Stainless Steels Pages: 280 - 281
Alloying capacity for the solid solution of alloys obtained by crystallizing under pressure T. N. Lipchin Nonferrous Metals and Alloys Pages: 282 - 285
The effect of microalloying on the structure and properties of Al−Zn−Mg−Cu alloys I. N. FeidlanderE. A. TkachenkoE. N. Matveets Nonferrous Metals and Alloys Pages: 285 - 290
The effect of phosphorus on the structure and strength of Cu−Ni alloys V. N. KlimenkoV. A. MaslyukL. I. Tsygankova Nonferrous Metals and Alloys Pages: 290 - 293
Formation of the structure of brass L80 foil N. K. MochalinZ. K. Zastol'skayaL. A. Lisitskaya Nonferrous Metals and Alloys Pages: 294 - 296
The influence of autofrettage on the structure of gears G. A. ZhuravlevA. I. AgeevL. D. Zaguskina Strength Properties Pages: 297 - 301
Crack resistance as a criterion of the effectiveness of roll steel M. Ya. BelkinV. Z. KamalovL. M. Belkin Strength Properties Pages: 302 - 306
The mechanical properties and character of failure of steel after repeated thermomechanical strengthening of the surface layer N. K. Kryuchkov Strength Properties Pages: 307 - 310