Volume 49, Issue 18

Search all Journal of Materials Science articles

September 2014

Filter by

Volume:

Sort by

Date published:

New to old Old to new

32 articles in this issue

Review: the characterization of electrospun nanofibrous liquid filtration membranes
Satinderpal Kaur
Subramanian Sundarrajan
Seeram Ramakrishna
Review 23 May 2014 Pages: 6143 - 6159
The effect of fast annealing treatment on the interface structure and electrical properties of Au/Hg₃In₂Te₆ contact
Jie Sun
Li Fu
Zongwen Liu
OriginalPaper 19 June 2014 Pages: 6160 - 6166
Discontinuous reactions in melt-spun Cu–10 at. %Co alloys and their effect on magnetic anisotropy
N. M. Suguihiro
Y. T. Xing
I. G. Solórzano
OriginalPaper 17 June 2014 Pages: 6167 - 6179
Effect of processing parameters on the structure and multi-functional performance of epoxy/GNP-nanocomposites
B. Ahmadi-Moghadam
F. Taheri
OriginalPaper 10 June 2014 Pages: 6180 - 6190
Adsorption characteristics of noble metals on the strongly basic anion exchanger Purolite A-400TL
A. Wołowicz
Z. Hubicki
OriginalPaper Open access 12 June 2014 Pages: 6191 - 6202
Molybdenum ion: a structural probe in lithium–antimony–germanate glass system by means of dielectric and spectroscopic studies
R. Vijay
P. Ramesh Babu
N. Veeraiah
OriginalPaper 14 June 2014 Pages: 6203 - 6216
Graphene sheets decorated with ZnO nanoparticles as anode materials for lithium ion batteries
Ling-Li Xu
Shao-Wei Bian
Kang-Lin Song
OriginalPaper 07 June 2014 Pages: 6217 - 6224
Controlling foam morphology of polystyrene via surface chemistry, size and concentration of nanosilica particles
Seyed Esmaeil Zakiyan
Mohamad Hossein Navid Famili
Mohammad Ako
OriginalPaper 11 June 2014 Pages: 6225 - 6239
Influence of plastic deformation on the precipitation of Cr in copper
A. Chbihi
X. Sauvage
D. Blavette
OriginalPaper 12 June 2014 Pages: 6240 - 6247
Fe dopants enhancing ethanol sensitivity of ZnO thin film deposited by RF magnetron sputtering
M. Mehedi Hassan
Wasi Khan
S. S. Islam
OriginalPaper 13 June 2014 Pages: 6248 - 6256
Keratins extracted from Merino wool and Brown Alpaca fibres as potential fillers for PLLA-based biocomposites
A. Aluigi
C. Tonetti
J. M. Kenny
OriginalPaper 12 June 2014 Pages: 6257 - 6269
Tetracycline hydrochloride (TCH)-loaded drug carrier based on PLA:PCL nanofibre mats: experimental characterisation and release kinetics modelling
Hazim J. Haroosh
Yu Dong
Kin-Tak Lau
OriginalPaper 10 June 2014 Pages: 6270 - 6281
Air-gap-enhanced pearlescent effect in periodic stratified bilayers of Perna viridis shell
Chutiparn Lertvachirapaiboon
Thiluksakorn Jirapisitkul
Sanong Ekgasit
OriginalPaper 14 June 2014 Pages: 6282 - 6289
Surface ligand influenced free radical protection of superparamagnetic iron oxide nanoparticles (SPIONs) toward H9c2 cardiac cells
Faruq Mohammad
Nor Azah Yusof
OriginalPaper 14 June 2014 Pages: 6290 - 6301
Impact of different silkworm dietary supplements on its silk performance
Daniel Nicodemo
Juliano E. Oliveira
Gustavo H. D. Tonoli
OriginalPaper 13 June 2014 Pages: 6302 - 6310
The rheological behaviour of concentrated dispersions of graphene oxide
Cristina Vallés
Robert J. Young
Ian A. Kinloch
OriginalPaper Open access 17 June 2014 Pages: 6311 - 6320
Densification of La_0.6Sr_0.4Co_0.2Fe_0.8O₃ ceramic by flash sintering at temperature less than 100 °C
Anshu Gaur
Vincenzo M. Sglavo
OriginalPaper 14 June 2014 Pages: 6321 - 6332
Enhanced thermomechanical properties of long and short glass fiber-reinforced polyamide 6,6/polypropylene mixtures by tuning the processing procedures
Namil Kim
Dae-Yoon Kim
Kwang-Un Jeong
OriginalPaper 10 June 2014 Pages: 6333 - 6342
Synthesis and characterization of paclitaxel-imprinted nanoparticles for recognition and controlled release of an anticancer drug
Fatemeh Azizi Ishkuh
Mehran Javanbakht
Fatemeh Atyabi
OriginalPaper 17 June 2014 Pages: 6343 - 6352
Phase assembly and electrical conductivity of spark plasma sintered CeO₂–ZrO₂ ceramics
Rosalía Poyato
Sylvia A. Cruz
José A. Odriozola
OriginalPaper 11 June 2014 Pages: 6353 - 6362
First-principles study of A-site substitution in ferroelectric bismuth titanate
Kan-Hao Xue
Leonardo R. C. Fonseca
Yoshio Nishi
OriginalPaper 13 June 2014 Pages: 6363 - 6372
Simple one-step method to produce titanium dioxide–polycaprolactone composite films with increased hydrophilicity, enhanced cellular interaction and improved degradation for skin tissue engineering
Phong A. Tran
Dhee P. Biswas
Andrea J. O’Connor
OriginalPaper 11 June 2014 Pages: 6373 - 6382
Synthesis, characterization and photocatalytic behavior of TiO₂–SiO₂ mesoporous composites in hydrogen generation from water splitting
P. S. Niphadkar
S. K. Chitale
S. V. Awate
OriginalPaper 10 June 2014 Pages: 6383 - 6391
Enhanced photovoltaic performance of solar cell based on front-side illuminated CdSe/CdS double-sensitized TiO₂ nanotube arrays electrode
Zhen Li
Libo Yu
Shuqing Sun
OriginalPaper 10 June 2014 Pages: 6392 - 6403
Swift heavy ion induced structural, optical and luminescence modification in NaSrBO₃:Dy³⁺ phosphor
A. K. Bedyal
Vinay Kumar
H. C. Swart
OriginalPaper 10 June 2014 Pages: 6404 - 6412
Phase stabilization principle and precipitate-host lattice influences for Al–Mg–Si–Cu alloy precipitates
F. J. H. Ehlers
S. Wenner
R. Holmestad
OriginalPaper 17 June 2014 Pages: 6413 - 6426
Tensile behaviour of multi-layered braided structures
Harshvardhan Saraswat
Amit Rawal
Rajendra Singh
OriginalPaper 19 June 2014 Pages: 6427 - 6436
Nanofibrillated cellulose in wood coatings: mechanical properties of free composite films
Franziska Grüneberger
Tina Künniger
Martin Arnold
OriginalPaper 18 June 2014 Pages: 6437 - 6448
Permeability of natural fiber reinforcement for liquid composite molding processes
Van Hau Nguyen
Mylène Lagardère
Stéphane Panier
OriginalPaper 17 June 2014 Pages: 6449 - 6458
Studies of ferroelectric and magnetic phase transitions in multiferroic PbFe_0.5Ta_0.5O₃–PbTiO₃ solid solution ceramics
I. P. Raevski
V. V. Titov
S. I. Shevtsova
OriginalPaper 19 June 2014 Pages: 6459 - 6466
An investigation into the relationship between processing, structure and properties for high-modulus PBO fibres: part 3: analysis of fibre microstructure using transmission electron microscopy
Tooru Kitagawa
Kazuyuki Yabuki
Robert. J. Young
OriginalPaper 17 June 2014 Pages: 6467 - 6474
Alpha and deuteron irradiation effects on silica nanoparticles
A. Alessi
S. Agnello
I. Vâţă
OriginalPaper 17 June 2014 Pages: 6475 - 6484

Volume 49, Issue 18

Review: the characterization of electrospun nanofibrous liquid filtration membranes

The effect of fast annealing treatment on the interface structure and electrical properties of Au/Hg₃In₂Te₆ contact

Discontinuous reactions in melt-spun Cu–10 at. %Co alloys and their effect on magnetic anisotropy

Effect of processing parameters on the structure and multi-functional performance of epoxy/GNP-nanocomposites

Adsorption characteristics of noble metals on the strongly basic anion exchanger Purolite A-400TL

Molybdenum ion: a structural probe in lithium–antimony–germanate glass system by means of dielectric and spectroscopic studies

Graphene sheets decorated with ZnO nanoparticles as anode materials for lithium ion batteries

Controlling foam morphology of polystyrene via surface chemistry, size and concentration of nanosilica particles

Influence of plastic deformation on the precipitation of Cr in copper

Fe dopants enhancing ethanol sensitivity of ZnO thin film deposited by RF magnetron sputtering

Keratins extracted from Merino wool and Brown Alpaca fibres as potential fillers for PLLA-based biocomposites

Tetracycline hydrochloride (TCH)-loaded drug carrier based on PLA:PCL nanofibre mats: experimental characterisation and release kinetics modelling

Air-gap-enhanced pearlescent effect in periodic stratified bilayers of Perna viridis shell

Surface ligand influenced free radical protection of superparamagnetic iron oxide nanoparticles (SPIONs) toward H9c2 cardiac cells

Impact of different silkworm dietary supplements on its silk performance

The rheological behaviour of concentrated dispersions of graphene oxide

Densification of La_0.6Sr_0.4Co_0.2Fe_0.8O₃ ceramic by flash sintering at temperature less than 100 °C

Enhanced thermomechanical properties of long and short glass fiber-reinforced polyamide 6,6/polypropylene mixtures by tuning the processing procedures

Synthesis and characterization of paclitaxel-imprinted nanoparticles for recognition and controlled release of an anticancer drug

Phase assembly and electrical conductivity of spark plasma sintered CeO₂–ZrO₂ ceramics

First-principles study of A-site substitution in ferroelectric bismuth titanate

Simple one-step method to produce titanium dioxide–polycaprolactone composite films with increased hydrophilicity, enhanced cellular interaction and improved degradation for skin tissue engineering

Synthesis, characterization and photocatalytic behavior of TiO₂–SiO₂ mesoporous composites in hydrogen generation from water splitting

Enhanced photovoltaic performance of solar cell based on front-side illuminated CdSe/CdS double-sensitized TiO₂ nanotube arrays electrode

Swift heavy ion induced structural, optical and luminescence modification in NaSrBO₃:Dy³⁺ phosphor

Phase stabilization principle and precipitate-host lattice influences for Al–Mg–Si–Cu alloy precipitates

Tensile behaviour of multi-layered braided structures

Nanofibrillated cellulose in wood coatings: mechanical properties of free composite films

Permeability of natural fiber reinforcement for liquid composite molding processes

Studies of ferroelectric and magnetic phase transitions in multiferroic PbFe_0.5Ta_0.5O₃–PbTiO₃ solid solution ceramics

An investigation into the relationship between processing, structure and properties for high-modulus PBO fibres: part 3: analysis of fibre microstructure using transmission electron microscopy

Alpha and deuteron irradiation effects on silica nanoparticles

Navigation