Volume 28, issue 1, January 2015
23 articles in this issue
-
-
-
Atlas based kinematic optimum design of the Stewart parallel manipulator
Authors (first, second and last of 4)
-
Biomimetic shoulder complex based on 3-PSS/S spherical parallel mechanism
Authors (first, second and last of 4)
-
Design and analysis of the Gemini chain system in dual clutch transmission of automobile
Authors (first, second and last of 6)
-
-
Multi-parameter sensitivity analysis and application research in the robust optimization design for complex nonlinear system
Authors (first, second and last of 4)
-
Semi-active sliding mode control of vehicle suspension with magneto-rheological damper
Authors (first, second and last of 6)
-
Experiments and simulation of thermal behaviors of the dual-drive servo feed system
Authors (first, second and last of 6)
-
Error compensation of thin plate-shape part with prebending method in face milling
Authors (first, second and last of 5)
-
Feature extraction and recognition for rolling element bearing fault utilizing short-time Fourier transform and non-negative matrix factorization
Authors (first, second and last of 4)
-
Approximate solution of oil film load-carrying capacity of turbulent journal bearing with couple stress flow
Authors (first, second and last of 6)
-
Analysis of the pump-turbine S characteristics using the detached eddy simulation method
Authors (first, second and last of 5)
-
Electromagnetic characteristic of twin-wire indirect arc welding
Authors (first, second and last of 4)
-
Effects of service condition on rolling contact fatigue failure mechanism and lifetime of thermal spray coatings—A review
Authors (first, second and last of 5)
-
Heat treatment effect on microstructure, hardness and wear resistance of Cr26 white cast iron
Authors (first, second and last of 4)
-
-
Friction and wear performance of boron doped, undoped microcrystalline and fine grained composite diamond films
Authors (first, second and last of 4)
-
Force feedback coupling with dynamics for physical simulation of product assembly and operation performance
Authors (first, second and last of 4)
-
New knowledge network evaluation method for design rationale management
Authors (first, second and last of 6)
-
Intelligent optimization methods for the design of an overhead travelling crane
Authors (first, second and last of 4)
-
Three-stage method for identifying the dynamic model parameters of stranded wire helical springs
Authors (first, second and last of 5)
-
Effects of target and distractor saturations on the cognitive performance of an integrated display interface
Authors (first, second and last of 4)