Skip to main content
Log in

Radial forces in a centrifugal compressor; Experimental investigation by using magnetic bearings and static pressure distribution

  • Published:
Journal of Thermal Science Aims and scope Submit manuscript

Abstract

The volute of a centrifugal compressor causes a non-uniform pressure distribution which leads to a radial force on the impeller. This force was measured using magnetic bearings. In addition, the radial force was estimated using the static pressure distribution measured at the impeller outlet. The impeller force was found to be the highest at choke, the lowest at the design flow and moderate at stall. The radial force determined from the pressure measurements was only slightly different from the force obtained from the bearing measurements. The rotational speed was seen to affect the force to some extent.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

References

  1. Sorokes, J M, Borer, J C, Koch, J M. Investigation of the Circumferential Static Pressure Non-Uniformity Caused by a Centrifugal Compressor Discharge Volute. ASME Paper No.98-GT-326, 1998

  2. Fatsis, A, Pierret, S, Van den Braembussche, R. Three-Dimensional Unsteady Flow and Forces in Centrifugal Impellers With Circumferential Distortion of the Outlet Static Pressure. Journal of Turbomachinery, 1997, 119: 94–102

    Article  Google Scholar 

  3. Hagelstein, D, Van den Braembussche, R, Keiper, R, et al. Experimental Investigation of the Circumferential Static Pressure Distortion in Centrifugal Compressor Stages. ASME Paper No.97-GT-50, 1997

  4. Hillewaert, K, Van den Braembussche, R. Numerical Simulation of Impeller — Volute Interaction in Centrifugal Compressors. Journal of Turbomachinery, 1999, 121: 603–608

    Article  Google Scholar 

  5. Moore, J J, Flathers, M B. Aerodynamically Induced Radial Forces in a Centrifugal Gas Compressor: Part 1 — Experimental Measurement. Journal of Engineering for Gas Turbines and Power, 1998, 120: 383–390

    Google Scholar 

  6. Sideris, M, Van den Braembussche, R. Influence of a Circumferential Exit Pressure Distortion on the Flow in an Impeller and Diffuser. Journal of Turbomachinery, 1987, 109: 48–54

    Article  Google Scholar 

  7. Reunanen, A. Experimental and Numerical Analysis of Different Volutes in a Centrifugal Compressor. Acta Universitatis Lappeenrantaensis 118, Diss., Lappeenranta, Finland, 2001

  8. Reunanen, A, Larjola, J. Experimental analysis of radial forces in a centrifugal Compressor. In: Proc. of the 5th European conference on Turbomachinery, Praha, 2003. 85–94

  9. Turunen-Saaresti, T. Computational and Experimental Analysis of Flow Field in the Diffusers of Centrifugal Compressors. Acta Universitatis Lappeenrantaensis 192, diss., Lappeenranta 2004. 103

  10. Wesche, W. Measurements on the Volute Casing of a Centrifugal Pump. World Pumps, 1987. 321–324

  11. Iversen, H W, Rolling, R E, Carlson, J J. Volute Pressure Distribution, Radial Force on the Impeller, and Volute Mixing Losses of a Radial Flow Centrifugal Pump. Journal of Engineering for Power, 1960, 82(2): 136–144

    Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Rights and permissions

Reprints and permissions

About this article

Cite this article

Reunanen, A., Larjola, J. Radial forces in a centrifugal compressor; Experimental investigation by using magnetic bearings and static pressure distribution. J. of Therm. Sci. 14, 1–8 (2005). https://doi.org/10.1007/s11630-005-0032-0

Download citation

  • Received:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11630-005-0032-0

Keywords

CLC Number

Navigation