Abstract
Torque Vectoring (TV) has the objective to substitute the need of a mechanical differential, while improving the handling and response of the wheeled vehicle. This work addresses the design of a torque vectoring system in an rear wheel driven formula student prototype. The proposed solution resorts to a PID controller for yaw rate tracking with an evenly distributed torque to each wheel. Also an LQR scheme is discussed, for tracking the yaw rate and the lateral velocity. To assess and design, first a 7 degree of freedom (DOF) non linear model is constructed, followed by a linear 2 DOF model, both validated with real data. The linear model, is used to design and simulate the proposed controllers. When the controller is within the desired parameters it is tested in the non linear model. Tests with the vehicle are performed to verify the contribution of the controller to the overall performance of the vehicle.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
References
Passengers cars - Steady-state circular driving behaviour - Open-loop test methods ISO 4138:2004. 4th edn., June 2012
Jazar, R.N.: Vehicle Dynamics: Theory and Application, 2nd edn. Springer (2014), ISBN:978-1-4614-8544-5
Anwar, S.: Yaw stability control of an automotive vehicle via generalized predictive algorithm. In: Proceedings of the 2005, American Control Conference, pp. 435–440, June 2005, https://doi.org/10.1109/ACC.2005.1469974
Di Cairano, S., Tseng, H.E., Bernardini, D., Bemporad, A.: Vehicle yaw stability control by coordinated active front steering and differential braking in the tire sideslip angles domain. IEEE Trans. Control Syst. Technol. 21(4), 1236–1248 (2013), 1063-6536
Schramm, D., Hiller, M., Bardini, R.: Vehicle Dynamics: Modelling and Simulation, 1st edn. Springer (2014), ISBN 978-3-540-36045-2
Ghosh, J., Tonoli, A., Amati, N.: A torque vectoring strategy for improving the performance of a rear wheel drive electric vehicle. In: 2015 IEEE Vehicle Power and Propulsion Conference (VPPC), pp. 1–6, October 2015, https://doi.org/10.1007/11823285_121
Kaiser, G., Holzmann, F., Chretien, B., Korte, M., Werner, H.: Torque vectoring with a feedback and feed forward controller – applied to a through the road hybrid electric vehicle. In: 2011 IEEE Intelligent Vehicles Symposium (IV), vol. 4128, pp. 448–453, June 2011
Kaiser, G., Liu, Q., Hoffmann, C., Korte, M., Werner, H.: Torque vectoring for an electric vehicle using an LPV drive controller and a torque and slip limiter. In: 2012 IEEE 51st IEEE Conference on Decision and Control (CDC), pp. 5016–5021, December 2012, https://doi.org/10.1109/CDC.2012.6426553
De Novellis, L., Sorniotti, A., Gruber, P., Pennycott, A.: Comparison of feedback control techniques for torque-vectoring control of fully electric vehicles. IEEE Trans. Veh. Technol. 63(8), 3612–3623 (2014), https://doi.org/10.1007/11823285_121
Rajamani, R.: Vehicle Dynamics and Control, Mechanical Engineering Series, 1st edn. Springer (2005), ISBN:978-0387263960
Rubin, D., Arogeti, S.: Vehicle yaw stability control using rear active differential via Sliding mode control methods. In: 21st Mediterranean Conference on Control and Automation, pp. 317–322, June 2013, https://doi.org/10.1109/MED.2013.6608740
Stoop, A.: Design and Implementation of Torque Vectoring for the Forze Racing Car. Master’s thesis, Delft Center for Systems and Control (2014)
Kiencke, U., Nielsen, L.: Automotive Control Systems: For Engine, Driveline and Vehicle, 2nd edn. Springer (2005), ISBN:978-3-540-26484-2
Zhao, C., Xiang, W., Richardson, P.: Vehicle Lateral Control and Yaw Stability Control through Differential Braking, pp. 384–389, July 2006, https://doi.org/10.1109/ISIE.2006.295624
Acknowledgments
This work was supported by FCT, through IDMEC, under LAETA, project UID/EMS/50022/2013. The authors thank the prompt and fruitful cooperation of the IST Formula Student team, FST Lisboa and ISR - Dynamical Systems and Ocean Robotics Lab, namely the assistance of Bruno Cardeira.
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2018 Springer International Publishing AG
About this paper
Cite this paper
Antunes, J., Cardeira, C., Oliveira, P. (2018). Torque Vectoring for a Formula Student Prototype. In: Ollero, A., Sanfeliu, A., Montano, L., Lau, N., Cardeira, C. (eds) ROBOT 2017: Third Iberian Robotics Conference. ROBOT 2017. Advances in Intelligent Systems and Computing, vol 694. Springer, Cham. https://doi.org/10.1007/978-3-319-70836-2_35
Download citation
DOI: https://doi.org/10.1007/978-3-319-70836-2_35
Published:
Publisher Name: Springer, Cham
Print ISBN: 978-3-319-70835-5
Online ISBN: 978-3-319-70836-2
eBook Packages: EngineeringEngineering (R0)