3D printing of biomedically relevant polymer materials and biocompatibility
Authors (first, second and last of 8)
Collection
Polymers for Addtive Manufacturing
Special Issue published in April 2021, Vol. 11, No. 2 of MRS Communications
Editors
-
Jamie Messman
Kansas City National Security Campus, USA
-
Daniel E. Bowen
Kansas City National Security Campus, USA
-
Rigoberto C. Advincula
MRS Communications Editor-in-Chief Case Western Reserve University, USA
Articles (14 in this collection)
-
-
-
Effect of micron-scale manufacturing flaws on the tensile response of centimeter sized two-photon polymerization microlattices
Authors (first, second and last of 4)
-
Comparing polarized Raman spectroscopy and birefringence as probes of molecular scale alignment in 3D printed thermoplastics
Authors (first, second and last of 5)
-
-
-
Direct ink writing techniques for in situ gelation and solidification
Authors (first, second and last of 5)
-
Structural response of 3D-printed rubber lattice structures under compressive fatigue
Authors (first, second and last of 11)
-
New “all-in-one” silicone pastes for additive manufacturing of elastomer parts
Authors (first, second and last of 5)
-
-
Selective laser sintering (SLS)-printable thermosetting resins via controlled conversion
Authors (first, second and last of 4)
-
Novel polymer materials systems to expand the capabilities of FDM™-type additive manufacturing
Authors
-
Mechanical and thermal properties of 3D-printed epoxy composites reinforced with boron nitride nanobarbs
Authors (first, second and last of 8)
-
