Abstract
Slope stability has gained more and more attention in geotechnical engineering, where the surcharge on the crest of slope may trigger slope failures. In this paper, the cemented-soil slope failure induced by footing surcharge was carefully studied using the two dimensional distinct element method (DEM). The main focus is on the effects of the footing position, footing roughness and slope angle on the slope failure mode and the bearing capacity. In addition, the micro-characteristics such as bond breakage were also examined to shed light on the underlying micro-mechanics. The simulation results show that the ultimate bearing capacity of the footing on the top of slope increases with the increase of the horizontal distance from the footing to the slope crest and the decrease of the slope angle. Once the surcharge is applied, the soils below the footing are compressed forming a triangular failure area. Simultaneously, cracks originate from the bottom of the footing and slope toe or slope surface, and then extend toward the middle part of the slope until a circular slip surface is formed eventually.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
References
Meyerhof, G.G.: The ultimate bearing capacity of foundations on slopes. In: 4th Conference on Soil Mechanics and Foundation Engineering, vol. 1, pp. 384–386 (1957)
Yoo, C.: Laboratory investigation of bearing capacity behavior of strip footing on geogrid-reinforced sand slope. Geotext. Geomembr. 19(5), 279–298 (2001)
Aiban, S.A., Znidarcic, D.: Centrifugal modeling of bearing capacity of shallow foundations on sands. J. Geotech. Eng. 121(10), 704–712 (1995)
Baker, R., Garber, M.: Theoretical analysis of the stability of slopes. Géotechnique 28(4), 395–411 (1978)
Blatz, J.A., Bathurst, R.J.: Limit equilibrium analysis of large-scale reinforced and unreinforced. Can. Geotech. J. 40(6), 1084–1092 (2003)
Sawwaf, M.A.E.: Behavior of strip footing on geogrid-reinforced sand over a soft clay slope. Geotext. Geomembr. 25(1), 50–60 (2007)
Sharafi, H., Sojoudi, Y.: Experimental and numerical study of pile-stabilized slopes under surface load conditions. Int. J. Civ. Eng. 14(4), 221–232 (2016)
Cundall, P., Strack, O.: A discrete numerical model for granular assemblies. Geotechnique 29(1), 47–65 (1979)
Jiang, M.J., Zhu, F., Liu, F., et al.: A bond contact model for methane hydrate-bearing sediments with interparticle cementation. Int. J. Numer. Anal. Methods Geomech. 38(17), 1823–1854 (2014)
Jiang, M.J., Yu, H.S., Harris, D.: Bond rolling resistance and its effect on yielding of bonded granulates by DEM analyses. Int. J. Numer. Anal. Methods Geomech. 30(8), 723–761 (2006)
Jiang, M.J., Konrad, J.M., Leroueil, S.: An efficient technique for generating homogeneous specimens for DEM studies. Comput. Geotech. 30(7), 579–597 (2003)
The Rock Soil Engineering Reconnaissance Specification (GB50021-2001)
Sharafi, H., Sojoudi, Y.: Experimental and numerical study of pile-stabilized slopes under surface load conditions. Int. J. Civ. Eng. 14(4), 221–232 (2016)
Nadaf, M.B., Mandal, J.N.: Behavior of reinforced fly ash slopes with cellular mattress and strips under strip loading. J. Hazard. Toxic Radioact. Waste 21(4), 4017019 (2017)
Acknowledgement
The research was financially supported by the National Natural Science Foundation of China with Grant Nos. 51639008 and 51579178, which are sincerely appreciated.
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2018 Springer Nature Singapore Pte Ltd.
About this paper
Cite this paper
Jiang, M., Zhang, X., Du, W., Zhang, A. (2018). DEM Analysis of the Cemented-Soil Slope Failure Caused by Surcharge. In: Zhou, A., Tao, J., Gu, X., Hu, L. (eds) Proceedings of GeoShanghai 2018 International Conference: Fundamentals of Soil Behaviours. GSIC 2018. Springer, Singapore. https://doi.org/10.1007/978-981-13-0125-4_27
Download citation
DOI: https://doi.org/10.1007/978-981-13-0125-4_27
Published:
Publisher Name: Springer, Singapore
Print ISBN: 978-981-13-0124-7
Online ISBN: 978-981-13-0125-4
eBook Packages: Earth and Environmental ScienceEarth and Environmental Science (R0)