Abstract
This investigation examines the application of low frequency Lamb waves for the detection of delaminations in thick composite laminates. Surface mounted piezoelectric devices were excited with a tone burst of few cycles generating a stress wave that propagates along the structure. Experiments were carried out on composite beam specimens where wave propagation distances over 2 m were achieved and artificially induced delaminations as small as 1 cm2 were successfully identified. The resonance spectrum method, which is based on the study of spectra obtained by forced mechanical resonance of samples using sine-sweep excitation, was used for measuring the Ao Lamb mode phase velocity. Finite element analyses of wave generation and propagation in wide laminated plates are also presented. The feasibility of employing piezoelectric devices for the development of smart structures, where a small and lightweight transducer system design is required, has been demonstrated.
This is a preview of subscription content, log in via an institution to check access.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
Preview
Unable to display preview. Download preview PDF.
References
Percival, W.J. and Birt, E.A.: A study of Lamb wave propagation in carbon-fibre composites, Insight, 39 (10), pp. 728–735, 1997.
Monkhouse, R.S.C., Wilcox, P.D. and Cawley, P.: Flexible interdigital PVDF lamb wave transducers, for the development of smart structures, Ultrasonics, 35 (7), pp. 489–498, 1997.
Wilcox, P.D., Cawley, P., and Lowe, M.J.S.: Acoustic fields from PVDF interdigital transducers, IEE Proc.-Sci. M.as. Technol., 145 (5), pp. 250–259, 1998.
Degertekin, F.L. and Khuri-Yakub, B.T.: Hertzian contact transducers for nondestructive evaluation, J. Acoust. Soc. Amer., 99 (1), pp. 299–308, 1996.
Farlow, R. and Hayward, G.: Real-time ultrasonic techniques suitable for implementing non-contact NDT systems employing piezoceramic composite transducers, Insight, 36 (12), pp. 926–935, 1994.
Pierce, S.G., Culshaw, B., Philp, W.R., Lecuyer, F., Farlow, R.: Broadband Lamb wave measurements in aluminium and carbon/glass fibre reinforced composite materials using non-contacting laser generation and detection, Ultrasonics, 35, pp. 105–114, 1997.
Alleyne, D. and Cawley, P.: Optimization of Lamb wave inspection techniques, NDT & E International, 25 (1), pp. 11–22, 1992.
Birt, A.: Damage detection on carbon-fibre composites using ultrasonic Lamb waves, Insight, 40 (5), pp. 335–339, 1998.
Diaz Valdés, S.H. and Soutis, C.: Application of the rapid frequency sweep technique for delamination detection in composite laminates, Advanced Composites Letters, 8 (1), pp. 19–23, 1999.
Diaz Valdés, S.H. and Soutis, C.: Delamination detection in composite laminates from variations of their modal characteristics, Journal of Sound and Vibration, 228 (1), pp. 1–9, 1999.
Mackinley, C.P.: Compressive failure of CFRP laminates containing pin-loaded holes, Ph.D. thesis, Imperial College, Department of Aeronautics, 2000.
Viktorov, I.A.: Rayleigh and Lamb waves- Physical Theory and Applications, Plenum press, New York, 1967.
Pialucha, T., Guyott, C.C.H., and Cawley, P.: An amplitude spectrum method for the measurement of phase velocity, Ultrasonics, 27, pp. 270–279, 1989.
Sachse, W. and Pao, Y.H.: On determination of phase and group velocities of dispersive waves in solids, J. Appl. Phys., 49 (8), pp. 4320–4327, 1978.
Diaz Valdés, S.H. and Soutis, C.: Real-time nondestructive evaluation of fibre composite laminates using low-frequency Lamb waves, J. Acoust. Soc. Am., 11 (5), pp. 2026–2033, 2002.
White R.G. and Pinnington R.J: Practical application of the rapid frequency sweep technique for structural frequency response measurement. Aeronautical Journal, 86, pp.179–199, 1982.
Blevins, R.D.: Formulas for Natural Frequency and Mode Shape, Krieger Publishing Co., 1984.
Datoo, M.H.: Mechanics of Fibrous Composites, Elsevier Science Publisher Ltd., 1991.
Tang B., E.G. Henneke, II, and R.C. Stiffler: Low frequency flexural wave propagation in laminated composite plates,Proceedings of Acousto-Ultrasonics: Theory and Application, ed. J.C. Duke, Jr., 1988, pp 45–65. Plenum press, New York, N.Y.
Guo, N. and Cawley, P.: Lamb wave reflection for quick nondestructive evaluation of large composite laminates, Materials evaluation, 52 (3), pp. 404–411, 1994.
Hitchings, D.: Finite Element Package FE77, Iperial College, Department of Aeronautics, 1997.
Author information
Authors and Affiliations
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2003 Springer Science+Business Media Dordrecht
About this chapter
Cite this chapter
Soutis, C., Díaz Valdés, S.H. (2003). Delamination Detection in Laminated Composites Using Lamb Waves. In: Gdoutos, E.E., Marioli-Riga, Z.P. (eds) Recent Advances in Composite Materials. Springer, Dordrecht. https://doi.org/10.1007/978-94-017-2852-2_10
Download citation
DOI: https://doi.org/10.1007/978-94-017-2852-2_10
Publisher Name: Springer, Dordrecht
Print ISBN: 978-90-481-6294-9
Online ISBN: 978-94-017-2852-2
eBook Packages: Springer Book Archive