Abstract
Injection moulding is a commonly operated melt process, more extensively applied to thermoplastics other than PVC than to PVC itself, chiefly because of two inherent features especially appertaining to the unplasticised PVC compounds. These features are thermal instability and high melt viscosity, both of which create situations which those responsible for the process must anticipate and control carefully. There is little doubt that as moulding technology improves and as the position with regard to VCM becomes less hazardous the injection moulding of PVC will extend.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
Preview
Unable to display preview. Download preview PDF.
References
Tulley, F. T. and Harris, B. C. (1979). In Encyclopedia of PVC, (Ed. L. I. Nass ), Marcel Dekker, New York, Ch. 24, p. 1313.
Shah. P. L. (1979). Ibid, Ch. 22, p. 1153.
ASTM D 3364-74 (Rcapproved 1979). Flow rates for poly (vinyl chloride) and rheologically unstable thermoplastics.
Glenn, W. B. (1980). Plast. Technol., 26 (10), 73–5.
Haworth, B., Sandilands, G. J. and White, J. R. (1980). Plast. Rubb. Int., 5 (3), 109–13.
Gilbert, M., Marshall, D. E,, Voyvoda. J. C. and Copsey, C. J. (1979). Plasl. Rub.: Process., 3, 96.
The Principles of Injection Moulding,’ ICI Technical Service Note G 103 (2nd edn), ICI Plastics Division. Welwyn Garden City, Herts, England.
Brown, J. (1979). Injection Moulding of Plastic Components—A Guide to Efficiency, Fault Diagnosis and Cure. McGraw-Hill Book Co. ( UK) Ltd, London.
Ireland. R. A. and Smith, J. B. (1977). Plast. Rubb. Int.. 2(5), 225–7.
Huber, M. (1977). Plast. Rubb. Wkly, 18th February, pp. 20–23.
Technical Bulletins 8/73, Ethyl Corporation, Polymer Division, Baton Rouge, Louisiana, USA.
Ingham, P. H. J. (1979). Plast. Rubb. Int., 4 (5). 211–15.
Whelan, A. (1981). Brit. Plast. Rubb., April, p. 25.
Murrey, J. L. and Dito. A. J. (1981). Plast. Technol., 27 (12), 79–82.
Anon. (1981). Mod. Plast. Int., 11 (11), 36.
Rights and permissions
Copyright information
© 1984 Elsevier Applied Science Publishers Ltd
About this chapter
Cite this chapter
Turner, L.W. (1984). Injection Moulding of PVC. In: PVC Technology. Springer, Dordrecht. https://doi.org/10.1007/978-94-009-5614-8_15
Download citation
DOI: https://doi.org/10.1007/978-94-009-5614-8_15
Publisher Name: Springer, Dordrecht
Print ISBN: 978-94-010-8976-0
Online ISBN: 978-94-009-5614-8
eBook Packages: Springer Book Archive