Abstract
With the development of automation industry, more and more manufacture depends on automation to improve production efficiency. After welded the electric meter, it is necessary to clean up dust in the dial plate. At present, there have been some manufacturers began to design automatic dust removal equipment in order to improve the efficiency of the industry. Because of these reasons, it designed a set of meter dust removal device, the device used the SCM ATmega16 as the control core, through the selection of components, and hardware and software design, to achieve the automatic dust removing function for electric meter. After tested, the dust removal device runs stably and reliably, the result of dust removal is clean, so as to avoid polluting the air.
This is a preview of subscription content, log in via an institution to check access.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
Preview
Unable to display preview. Download preview PDF.
References
Li, W., Lv, J., Wang, L.: The Utility Model Dust Removal Device—Ring-bar Power Dirt Catcher. Heat Energy Power Engineering 17(4), 420–422 (2002)
Chen, D.: Principle and Development Guidance of ATmega16 SCM. Mechanical Industry Press, Beijing (2006)
Yang, Q.J., Li, G.H.: Dust Controller Design based on Single-chip Microcomputer. Instrument Technique 3, 56–57 (2006)
Xie, Z.M.: Design, Experiment and Test of Electronic Circuit. Huazhong University of Science and Technology Press, Wuhan (2006)
Yuan, T.: Advanced C Language Program Design and Application for SCM. Beijing University of Aeronautics and Astronautics Press, Beijing (2002)
Shen, W., Zhan, W.Q.: Introduction to C Language Development for AVR Single-chip Microcomputer. Tsinghua University Press, Beijing (2003)
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2012 Springer-Verlag Berlin Heidelberg
About this paper
Cite this paper
Chen, Z., Tian, L., Li, M., Zhang, J., Guan, B. (2012). Design of Dust Removal Device for Electric Meter. In: Jin, D., Lin, S. (eds) Advances in Mechanical and Electronic Engineering. Lecture Notes in Electrical Engineering, vol 177. Springer, Berlin, Heidelberg. https://doi.org/10.1007/978-3-642-31516-9_39
Download citation
DOI: https://doi.org/10.1007/978-3-642-31516-9_39
Publisher Name: Springer, Berlin, Heidelberg
Print ISBN: 978-3-642-31515-2
Online ISBN: 978-3-642-31516-9
eBook Packages: EngineeringEngineering (R0)