Abstract
Sensor network terminals are installed in large numbers in the field and transmit data periodically by radio. Such terminals must be miniaturized, and save power so that each device can operate by battery for several years. As one way to satisfy these two conditions, in this research we propose a terminal design which eliminates the receiver circuit. Because there is no receiver circuit, circuitry can be miniaturized, and power can be saved because there is no need to consume power to receive signals. However, the terminals cannot perform carrier detection and reception acknowledgement because there is no receiver circuit. We propose following two new protocols to solve this problem.
-
1
Terminal transmission times are randomized to prevent frequent collisions between specific terminals due to the lack of carrier detection.
-
2
Since all packet losses due to collision cannot be prevented with 1, data from a number of past transmissions is included in each packet so that a later packet can provide transmission data even if a packet is lost.
In this report, we describe the proposed protocol, and evaluate its performance by simulation. Furthermore, we actually prototype the system and evaluate the prototypefs performance.
This is a preview of subscription content, log in via an institution to check access.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
Preview
Unable to display preview. Download preview PDF.
References
Kahn, J.M., Katz, R.H., Pister, K.S.J.: Mobile Networking for Smart Dust. In: ACM/IEEE Intl. Conf. on Mobile Computing and Networking (MobiCom 1999), Seattle (1999)
Ye, W., Heidemann, J., Estrin, D.: An Energy-Efficient MAC Protocol for Wireless Sensor Networks. In: IEEE INFOCOM, New York, pp. 1567–1576 (2002)
Dam, T.V., Langendoen, K.: An adaptive energy-efficient MAC protocol for wireless sensor networks. In: ACM SenSys, Los Angeles, pp. 171–180 (2003)
Lu, G., Krishnamachari, B., Raghavendra, C.S.: An adaptive energy-efficient and low-latency MAC for data gatherring in wireless sensor networks. In: IEEE IPDPS, New Mexico, pp. 224–231 (2004)
Du, S., Saha, A.K., Jhonson, D.B.: RMAC:A routing-enhanced duty-cycle MAC protocol for wireless sensor networks. In: IEEE INFOCOM, Alaska, vol. 3, pp. 1478–1486 (2007)
Watanabe, T., Morito, T., Minami, M., Morikawa, H.: Design and implementation of a synchronous, battery-less, wireless sensor network using a radio clock. IEICE Technical Report, pp. 113–118, Mobile Multimedia Communications 107(39) (2007)
Polastre, J., Hill, J., Culler, D.: Versatile low power media access for wireless sensor netwoeks. In: ACM SenSys, Maryland, pp. 95–107 (2004)
Buettner, M., Yee, G.V., Anderson, E., Han, R.: X-MAC: A short preamble MAC protocol for duty-cycle wireless sensor networks. In: ACM SenSys, Colorado, pp. 307–320 (2006)
Lin, E.A., Rabaey, J.M.: Power-efficient rendezvous schemes for dense wireless sensor networks. In: IEEE ICC, Paris, pp. 3769–3776 (2004)
ZigBee Alliance, http://www.zigbee.org/en/
Author information
Authors and Affiliations
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2010 ICST Institute for Computer Science, Social Informatics and Telecommunications Engineering
About this paper
Cite this paper
Nose, H. et al. (2010). Terminal Design without Using Receiver Circuits for Wireless Sensor Networks. In: Zheng, J., Simplot-Ryl, D., Leung, V.C.M. (eds) Ad Hoc Networks. ADHOCNETS 2010. Lecture Notes of the Institute for Computer Sciences, Social Informatics and Telecommunications Engineering, vol 49. Springer, Berlin, Heidelberg. https://doi.org/10.1007/978-3-642-17994-5_9
Download citation
DOI: https://doi.org/10.1007/978-3-642-17994-5_9
Publisher Name: Springer, Berlin, Heidelberg
Print ISBN: 978-3-642-17993-8
Online ISBN: 978-3-642-17994-5
eBook Packages: Computer ScienceComputer Science (R0)