Skip to main content

An Acoustic Emission Study of Deformation Behavior of Wrought Mg Alloys

  • Conference paper
  • First Online:
Magnesium Technology 2017

Abstract

The influence of the pre-compression level on subsequent tensile deformation behavior has been investigated for two extruded Mg alloys with a different grain size distribution. The Mg–Zn–R are earth alloy has homogeneous microstructure, while the Mg–Al–Zn alloy exhibits bimodal microstructure. Deformation tests were performed at room temperature and at a constant strain rate of 10−3 s−1. Three pre-compression stress levels were chosen to receive microstructure containing a low number of twins, partially and fully twinned grains, respectively. The concurrent acoustic emission (AE) measurement provides real time information about collective dislocation motion and twin nucleation. Active deformation mechanisms during tensile loading are discussed in term of the AE response.

This is a preview of subscription content, log in via an institution to check access.

Access this chapter

Institutional subscriptions

References

  1. C.J. Bettles, M.A. Gibson, Current wrought magnesium alloys: strengths and weakness. JOMJ. Min. Met. Mat. S. 57, 46–49 (2005)

    Google Scholar 

  2. X.Y. Lou, M. Li, R.K. Boger, S.R. Agnew, R.H. Wagoner, Hardening evolution of AZ31B Mg sheet. Int. J. Plast. 23, 44–86 (2007)

    Article  Google Scholar 

  3. S. Begum, D.L. Chen, S. Xu, A.A. Luo, Low cycle fatigue properties of an extruded AZ31 magnesium alloy. Int. J. Fatigue 31, 726–735 (2009)

    Article  Google Scholar 

  4. J. Koike, N. Fujiyama, D. Ando, Y. Sutou, Roles of deformation twinning and dislocation slip in the fatigue failure mechanism of AZ31 Mg alloys. Scripta Mater. 63, 747–750 (2010)

    Article  Google Scholar 

  5. C.R. Heiple, S.H. Carpenter, Acoustic emission produced by deformation of metals and alloys—a review: Part I. J. Acoust. Emission 6, 177–204 (1987)

    Google Scholar 

  6. C.R. Heiple, S.H. Carpenter, Acoustic emission produced by deformation of metals and alloys—a review: Part II. J. Acoustic Emission 6, 215–237 (1987)

    Google Scholar 

  7. A. Vinogradov, D. Orlov, A. Danyuk, Y. Estrin, Effect of grain size on the mechanisms of plastic deformation in wrought Mg–Zn–Zr alloy revealed by acoustic emission measurements. Acta Mater. 61, 2044–2056 (2013)

    Article  Google Scholar 

  8. J. Čapek, K. Máthis, B. Clausen, J. Stráská, P. Beran, P. Lukáš, Study of the loading mode dependence of the twinning in random textured cast magnesium by acoustic emission and neutron diffraction methods. Mat. Sci. Eng. A-Struct. 602, 25–32 (2014)

    Article  Google Scholar 

  9. Y.P. Li, M. Enoki, Deformation and anelastic recovery of pure magnesium and AZ31B alloy investigated by AE. Mater. Trans. 48(9), 2343–2348 (2007)

    Google Scholar 

  10. A. Vinogradov, E. Vasilev, M. Linderov, D. Merson, In situ observations of the kinetics of twinning–detwinning and dislocation slip in magnesium. Mater. Sci. Eng. A 676, 351–360 (2016)

    Article  Google Scholar 

  11. J. Bohlen, P. Dobroň, L. Nascimento, K. Parfenenko, F. Chmelík, D. Letzig, The effect of reversed loading conditions on the mechanical behaviour of extruded magnesium alloy AZ31. Acta Phys. Pol. A 122, 444–449 (2012)

    Article  Google Scholar 

  12. D. Drozdenko, J. Bohlen, S. Yi, P. Minárik, F. Chmelík, P. Dobroň, Investigating a twinning-detwinning process in wrought Mg alloys by the acoustic emission technique. Acta Mater. 110, 103–113 (2016)

    Article  Google Scholar 

  13. J.W. Christian, S. Mahajan, Deformation twinning. Prog. Mater Sci. 39, 1–157 (1995)

    Article  Google Scholar 

  14. J.P. Toronchuk, Acoustic emission during twinning of zinc single crystals. Mater. Eval. 51–53 (1977)

    Google Scholar 

  15. P. Dobroň, F. Chmelík, S. Yi, K. Parfenenko, D. Letzig, J. Bohlen, Grain size effects on deformation twinning in an extruded magnesium alloy tested in compression. Scripta Mater. 65(5), 424–427 (2011)

    Article  Google Scholar 

Download references

Acknowledgements

This work received support from the Czech Science Foundation under grant 13—19812S.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Patrik Dobroň .

Editor information

Editors and Affiliations

Rights and permissions

Reprints and permissions

Copyright information

© 2017 The Minerals, Metals & Materials Society

About this paper

Cite this paper

Dobroň, P., Drozdenko, D., Yi, S., Bohlen, J. (2017). An Acoustic Emission Study of Deformation Behavior of Wrought Mg Alloys. In: Solanki, K., Orlov, D., Singh, A., Neelameggham, N. (eds) Magnesium Technology 2017. The Minerals, Metals & Materials Series. Springer, Cham. https://doi.org/10.1007/978-3-319-52392-7_84

Download citation

Publish with us

Policies and ethics