Abstract
The objective of this study is to show experimentally the intermittency of the phase transformation in a shape memory alloy using a kinematical full-field measurement method. The specimen is a Cu-Al-Be single crystal with Ms = −2 °C. A uniaxial loading was applied by using a device based on gravity. In practice, a drop-by-drop device controlled by water pumps enabled us to apply a perfectly monotonic loading with very small force increments. The grid method was used to measure the strain fields on the specimen surface during the test. It is observed that the plateau which is classically obtained when the specimen transforms from austenite to martensite is actually characterized by an intermittency of the phase change. It means that the events, in terms of appearance of martensite needles and propagation, occur with an irregular alternation. The paper presents the experimental setup, the image processing and some typical results.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
References
Bhattacharya K (2003) Microstructure of martensite: why it forms and how it gives rise to the shape-memory effect. Oxford University Press, Oxford
James RD, Hane KF (2000) Martensitic transformations and shape memory materials. Acta Mater 48:197–222
Balandraud X, Delpueyo D, Grédiac M, Zanzotto G (2010) Almost compatible microstructures in shape memory alloys. Acta Mater 58:4559–4577
Zhang X, Xou T, Sun QP, Tong P (1997) On the full-field deformation of single crystal Cu-Al-Ni shape memory alloys-stress-induced β1-γ1′ martensitic transformation. J Phys IV 11:555–560
Sutton M, Orteu JJ, Schreier H (2009) Image correlation for shape, motion, and deformation measurements: basic concepts, theory and applications. Springer, New York
Efstathiou C, Sehitoglu H (2008) Local transformation strain measurements in precipitated NiTi single crystals. Scr Mater 59:1263–1266
Merzouki T, Collard C, Bourgeois N, Zineb TB, Meraghni F (2010) Coupling between measured kinematic fields and multicrystal SMA finite element calculations. Mech Mater 42:72–95
Daly S, Ravichandran G, Bhattacharya K (2007) Stress-induced martensitic phase transformation in thin sheets of nitinol. Acta Mater 55:3593–3600
Daly S, Rittel D, Bhattacharya K, Ravichandran G (2009) Large deformation of nitinol under shear dominant loading. Exp Mech 49:225–233
Sanchez-Arevalo F, Garcia-Fernandez T, Pulos G, Villagran-Muniz M (2009) Use of digital speckle pattern correlation for strain measurements in a Cu-Al-Be shape memory alloy. Mater Charact 60(8):775–782
Surrel Y (2000) Fringe analysis. In: Rastogi PK (ed) Photomechanics, vol 77, Topic applied physics. Springer, New York, pp 55–102
Delpueyo D, Grédiac M, Balandraud X, Badulescu C (2012) Investigation of martensitic microstructures in a monocrystalline Cu-Al-Be shape memory alloy with the grid method and infrared thermography. Mech Mater 45:34–51
Badulescu C, Grédiac M, Mathias J-D (2009) Investigation of the grid method for accurate in-plane strain measurement. Meas Sci Technol 20(9):095102
Badulescu C, Grédiac M, Mathias J-D, Roux D (2009) A procedure for accurate one-dimensional strain measurement using the grid method. Exp Mech 49(6):841–854
Niemann R, Baro J, Heczko O, Schultz L, Fahler S, Vives E, Manosa L, Planes A (2012) Tuning avalanche criticality: acoustic emission during the martensitic transformation of a compressed Ni-Mn-Ga single crystal. Phys Rev B 86(21):214101
Planes A, Manosa L, Vives E (2013) Acoustic emission in martensitic transformations. J Alloys Compd 577(1):S699–S704
Carrillo L, Ortin J (1997) Avalanches in the growth of stress-induced martensites. Phys Rev B 56(18):11508
Piro JL, Grédiac M (2004) Producing and transferring low-spatial-frequency grids for measuring displacement fields with moiré and grid methods. Exp Tech 28(4):23–26
Sur F, Grédiac M (2014) Towards deconvolution to enhance the grid method for in-plane strain measurement. Inverse Probl Imaging 8:259–291
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2015 The Society for Experimental Mechanics, Inc.
About this paper
Cite this paper
Barrera, N., Balandraud, X., Grédiac, M., Biscari, P., Zanzotto, G. (2015). Study of Phase Transformation Intermittency in S.M.A. Using the Grid Method. In: Carroll, J., Daly, S. (eds) Fracture, Fatigue, Failure, and Damage Evolution, Volume 5. Conference Proceedings of the Society for Experimental Mechanics Series. Springer, Cham. https://doi.org/10.1007/978-3-319-06977-7_20
Download citation
DOI: https://doi.org/10.1007/978-3-319-06977-7_20
Published:
Publisher Name: Springer, Cham
Print ISBN: 978-3-319-06976-0
Online ISBN: 978-3-319-06977-7
eBook Packages: EngineeringEngineering (R0)