Abstract
Due to particular requirement for implant prostheses to mechanical stability and biocompatibility for regeneration of hard tissues injuries, bioresorbable metallic implants have attracted special place in orthopedics in recent years because of excluding secondary surgery for extracting them. While magnesium is one of the most vital elements in body metabolism and revival of harmed bones, its corrosion rate in chloride solutions such as human body fluid is too high and this matter would have unpleasant consequences as a supporting implant. In this study, a magnesium-based alloy (AZ91) was used as a substrate and coated with nanostructured hydroxyapatite (n-HA) via a sol–gel method in order to achieve releasing Mg2+ ions gradually which assists osteoblast cells to regenerate injured bones. Potentiodynamic plots revealed that the corrosion resistance behavior of the coated substrates had been increased significantly comparing with uncoated specimens. Also, in vitro immersion test evaluation in simulated body fluid solution at 37 ± 1°C within 28 days of immersion discovered significant decrease in evolved gas for n-HA coated against bare AZ91 specimens which indicated that n-HA coating has been considerably successful in developing the controlled barricade of Mg2+ ion releasing and indicated that the n-HA coating could decrease the substrate degradation rate to half versus bare substrate.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
References
Geng, F., Tan, L.L., Jin, X.X., Yang, J.Y., Yang, K.: The preparation, cytocompatibility, and in vitro biodegradation study of pure beta-TCP on magnesium. J. Mater. Sci. Mater. Med. 20, 1149–1157 (2009)
Yan, T., Tan, L., Xiong, D., Liu, X., Zhang, B., Yang, K.: Fluoride treatment and in vitro corrosion behavior of an AZ31B magnesium alloy. Mater. Sci. Eng. C. 30, 740–748 (2010)
Razavi, M., Fathi, M.H., Meratian, M.: Microstructure, mechanical properties and bio-corrosion evaluation of biodegradable AZ91-FA nanocomposites for biomedical applications. Mater. Sci. Eng. A. 527, 6938–6944 (2010)
Kim, S., Lee, J., Kim, Y., Riu, D., Jung, S., Lee, Y.: Synthesis of Si, Mg substituted hydroxyapatites and their sintering behaviors. Biomaterials 24, 1389–1398 (2003)
Dai, K.: Rational utilization of the stress shielding effect of implants. In: Poitout, D.G. (ed.) Biomechanics and Biomaterials in Orthopedics, 1st edn. Springer, New york (2004)
Hulskes, R.: Stress shielding and bone resorption in THA : clinical versus computer-simulation studies. Acta Orthop. Belg. 59(1), 118–129 (1993)
Sealy, M.P., Guo, Y.B.: Surface integrity and process mechanics of laser shock peening of novel biodegradable magnesium-calcium (Mg-Ca) alloy. J. Mech. Behav. Biomed. Mater. 3, 488–496 (2010)
Li, Z., Gu, X., Lou, S., Zheng, Y.: The development of binary Mg-Ca alloys for use as biodegradable materials within bone. Biomaterials 29, 1329–1344 (2008)
Song, G.L., Atrens, A.: Corrosion mechanisms of magnesium alloys. Adv. Eng. Mater. 1, 11–33 (1999)
Razavi, M., Fathi, M.H., Meratian, M.: Bio-corrosion behavior of magnesium-fluorapatite nanocomposite for biomedical applications. Mater. Lett. 64, 2487–2490 (2010)
Yang, J., Cui, F., Lee, I.: Plasma surface modification of magnesium alloy for biomedical application. Surf. Coat. Technol. 205, S182–S187 (2010)
Fathi, M.H., Hanifi, A.: Evaluation and characterization of nanostructure hydroxyapatite powder prepared by simple sol–gel method. Mater. Lett. 61, 3978–3983 (2007)
Bose, S., Dasgupta, S., Tarafder, S., Bandyopadhyay, A.: Microwave-processed nanocrystalline hydroxyapatite: simultaneous enhancement of mechanical and biological properties. Acta Biomater. 6, 3782–3790 (2010)
Mohammadi Zahrani, E., Fathi, M.H., Alfantazi, A.M.: Sol-gel derived nanocrystalline fluoridated hydroxyapatite powders and nanostructured coatings for tissue engineering applications. Metall. Mater. Trans. A. 42, 3291–3309 (2010)
Ratner, B., Haffman, A. S., Schoen, F. J., Lemons, J. E.: Biomaterials Science: An Introduction to Materials in Medicine, 2nd edn. Elsevier Academic Press, New york (1996)
Fathi, M.H., Hanifi, A., Mortazavi, V.: Preparation and bioactivity evaluation of bone-like hydroxyapatite nanopowder. J. Mater. Process. Technol. 202, 536–542 (2008)
Bohner, M., Lemaitre, J.: Can bioactivity be tested in vitro with SBF solution? Biomaterials 30, 2175–2179 (2009)
Kokubo, T., Takadama, H.: How useful is SBF in predicting in vivo bone bioactivity? Biomaterials 27, 2907–2915 (2006)
Fathi, M.H., Doostmohammadi, A.: Preparation and characterization of sol–gel bioactive glass coating for improvement of biocompatibility of human body implant. Mater. Sci. Eng. A. 474, 128–133 (2008)
Stephen Tait, W.: An introduction to electrochemical corrosion testing for practicing engineers and scientists. PairDocs Publications, Racine (1994)
Panda, R., Hsieh, M., Chung, R., Chin, T.S.: FTIR, XRD, SEM and solid state NMR investigations of carbonate-containing hydroxyapatite nano-particles synthesized by hydroxide-gel technique. J. Phys. Chem. Solids 64, 193–199 (2003)
Tadic, D., Epple, M.: Mechanically stable implants of synthetic bone mineral by cold isostatic pressing. Biomaterials 24, 4565–4571 (2003)
Wei, M., Evans, J.H., Bostrom, T., Grøndahl, L.: Synthesis and characterization of hydroxyapatite, fluoride-substituted hydroxyapatite and fluorapatite. J. Mater. Sci. Mater. Med. 14, 311–320 (2003)
Medved, J., Mrvar, P., Vončina, M.: Oxidation resistance of AM60, AM50, AE42 and AZ91 magnesium alloys, Magnesium alloys-corrosion and surface treatments, Czerwinski, F. (ed), InTech. http://www.intechopen.com/books/magnesium-alloys-corrosion-and-surface-treatments/oxidation-resistance-of-am60-am50-ae42-and-az91-magnesium-alloys (2011)
Aung, N.N., Zhou, W.: Effect of grain size and twins on corrosion behaviour of AZ31B magnesium alloy. Corros. Sci. 52, 589–594 (2010)
Song, G.: Control of biodegradation of biocompatible magnesium alloys. Corros. Sci. 49, 1696–1701 (2007)
Witte, F., Hort, N., et al.: Degradable biomaterials based on magnesium corrosion. Curr. Opin. Solid State Mater. Sci. 12, 63–72 (2008)
Kokubo, T.: Design of bioactive bone substitutes based on biomineralization process. Mater. Sci. Eng C. 25, 97–104 (2005)
Zhang, S., Zhang, X., et al.: Research on an Mg-Zn alloy as a degradable biomaterial. Acta Biomater. 6, 626–640 (2010)
Acknowledgments
The authors are grateful for support of this research by Biomaterials Research Group of Isfahan University of Technology.
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2013 Springer International Publishing Switzerland
About this chapter
Cite this chapter
Rojaee, R., Fathi, M.H., Raeissi, K. (2013). Nanostructured Hydroxyapatite Coating for Biodegradability Improvement of Magnesium-based Alloy Implant. In: Ochsner, A., Altenbach, H. (eds) Advances in Bio-Mechanical Systems and Materials. Advanced Structured Materials, vol 40. Springer, Cham. https://doi.org/10.1007/978-3-319-00479-2_3
Download citation
DOI: https://doi.org/10.1007/978-3-319-00479-2_3
Published:
Publisher Name: Springer, Cham
Print ISBN: 978-3-319-00478-5
Online ISBN: 978-3-319-00479-2
eBook Packages: Chemistry and Materials ScienceChemistry and Material Science (R0)