Advertisement

The Impact of the Deformation Redistribution on the Special Narrowing Force

  • Mirna NožićEmail author
  • Himzo Đukić
Conference paper
Part of the Lecture Notes in Networks and Systems book series (LNNS, volume 76)

Abstract

The paper presents the results of experimental investigations of the special narrowing process with two variants of tool construction in the production of the same workpiece. Both tools had three narrowing operations. Deformation analysis was obtained through logarithmic deformation and narrowing ratio, and was performed after each narrowing operation. In laboratory conditions, a deformation force was recorded on a hydraulic test machine with custom manufacturing tools. For the experiments, cylindrical preparations, obtained by deep drawing with the reduction of wall thickness from steel and brass, were used.

Keywords

Special narrowing Die Narrowing press Deformation redistribution Special narrowing force 

References

  1. 1.
    Đukić, H., Nožić, M.: Limit values of maximal logarithmics strain in multi-stage cold forming operations. J. Technol. Plast. 40(1) (2015)Google Scholar
  2. 2.
    Nožić, M., Đukić, H.: Eksperimentalno određivanje graničnih stupnjeva deformacije u procesima proširivanja i sužavanja. In: International Conference on MATRIB 2018, Vela Luka, Hrvatska (2018)Google Scholar
  3. 3.
    Gagula, E.: Istraživanje uticajnih parametara izrade košuljice zrna različitih kalibara, magistarski rad. Mašinski fakultet Mostar (2017)Google Scholar
  4. 4.
    Audoly, B., Hutchinson, J.W.: Analysis of necking based on a one-dimensional model. J. Mech. Phys. Solids 97, 68–91 (2016)MathSciNetCrossRefGoogle Scholar
  5. 5.
    Audoly, B., Hutchinson, J.W.: One-dimensional modeling of necking in rate-dependent materials. J. Mech. Phys. Solids 123, 149–171 (2019). ISSN 0022–5096MathSciNetCrossRefGoogle Scholar
  6. 6.
    Zhang, Z.L., Hauge, M., Odegard, J.O., Thaulow, C.: Determining material true stress-strain curve from tensile specimens with rectangular cross-section. Int. J. Solids Struct. 36, 3497–3516 (1999)CrossRefGoogle Scholar
  7. 7.
    Kim, H.S., Kim, S.H.,. Ryu, W.-S.: Finite element analysis of the onset of necking and the post-necking behaviour during uniaxial tensile testing. Mater. Trans. 46(10), 2159–2163 (2005)CrossRefGoogle Scholar
  8. 8.
    van den Boogaard, A.H., Huetink, H.: Prediction of sheet necking with shell finite element models. In: 6th International ESAFORM Conference on Material Forming, Salerno, Italy (2003)Google Scholar
  9. 9.
    Đukić, H., Nožić, M.: Obrada deformisanjem, drugo izdanje. Univerzitet “Džemal Bijedić”, Mašinski fakultet Mostar (2018)Google Scholar
  10. 10.
    Nožić, M., Đukić, H.: Projektovanje tehnologija obrade deformisanjem. Univerzitet “Džemal Bijedić” Mašinski fakultet Mostar (2016)Google Scholar

Copyright information

© Springer Nature Switzerland AG 2020

Authors and Affiliations

  1. 1.Faculty of Mechanical EngineeringUniversity “DžemalBijedić” of MostarMostarBosnia and Herzegovina

Personalised recommendations