Abstract
In this paper, mean stress influence and cooperative effects associated with light water reactor (LWR) environmental factors were studied through load-controlled fatigue tests with cylindrical hollow specimens. Positive (+10, +50 MPa) and negative (−10, −20 MPa) mean stresses were applied and both showed beneficial influence on fatigue life due to cyclic hardening, which results in smaller strain amplitude under the same stress amplitude. The increase in fatigue life was found to depend on mean stress and testing environments. The increase (1.8–2.2x) in fatigue life with +50 MPa mean stress in boiling water reactor/hydrogen water chemistry (BWR/HWC) is smaller than that in air (3.0–3.4x), while the increase with −20 MPa mean stress in both environments is approximately similar. −20 MPa mean stress enhances the resistance to crack initiation as observed with optical microscopy (OM) observations of fracture surfaces and wall cross-sections of tested specimens.
This is a preview of subscription content, log in via an institution to check access.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
References
Vincent L, Roux JCL, Taheri S (2012) On the high cycle fatigue behavior of a type 304L stainless steel at room temperature. Int J Fatigue 38:84–91
Bae KH, Kim HH, Lee SB (2011) A simple life prediction method for 304L stainless steel structures under fatigue-dominated thermo-mechanical fatigue loadings. Mater Sci Eng A 529:370–377
Miksch M, Lenz E, Löhberg R (1985) Loading conditions in horizontal feedwater pipes of LWRs influenced by thermal shock and thermal stratification effects. Nucl Eng Des 48(2):179–187
Metzner KJ, Wilke U (2005) European THERFAT project—thermal fatigue evaluation of piping system “Tee”-connections. Nucl Eng Des 235(2–4):473–484 (2005)
Miura N (2006) High-cycle fatigue behavior of type 316 stainless steel at 288 °C including mean stress effect. Int J Fatigue 11(28):1618–1625
Kamaya M (2017) Influence of strain range on fatigue life reduction of stainless steel in PWR primary water. Fatigue Fract Eng Mater Struct 12(40):2194–2203
Magnus D, Bremberg D (2012) Fatigue margins for austinitic stainless steels in ASME boiler and pressure vessel code—a literature study. Swedish Radiation Safety Authority, Sweden
Kamaya M, Kawakubo M (2015) Mean stress effect on fatigue strength of stainless steel. Int J Fatigue 74:20–29
Facheris G (2014) Cyclic plastic material behavior leading to crack initiation in stainless steel under complex fatigue loading conditions. Doctoral thesis, diss. ETH NO. 21696, ETH Zurich
Midmore L (2011) Environmentally assisted fatigue gap analysis and roadmap for future research, 1st edn. Electric Power Research Institute, Palo Alto, California
Gerber WZ (1874) Calculation of the allowable stresses in iron structures. Z Bayer Arch Ing-Ver 6:101–110
Bae KH (2011) A simple life prediction method for 304L stainless steel structures under fatigue-dominated thermo-mechanical fatigue loadings. Mater Sci Eng A, Struct Mater Prop Microstruct Process (529):370–377
Soderberg CR (1930) Factor of safety and working stress. Trans ASME 52(2):13–28 (1930)
Spätig P (2015) Mean stress effect on fatigue life of 316L austenitic steel in air and simulated boiling water reactor hydrogen water chemistry environment. In: 17th international conference on environmental degradation of materials in nuclear systems—water reactors. TMS, Ottawa
Solomon HD (2005) Influence of mean stress on the fatigue behavior of 304L SS in air and PWR water. In: ASME 2005 pressure vessels and piping conference. ASME, Colorado, pp 87–97
Solomon HD (2011) Fatigue limit and hysteresis behavior of type 304L stainless steel in air and PWR water, at 150 °C and 300 °C. In: 15th international conference on environmental degradation. TMS, Colorado, pp 583–603
Leber HJ, Ritter S, Seifert HP (2013) Thermo-mechanical and isothermal low-cycle fatigue behavior of type 316L stainless steel in high-temperature water and air. Corros 69(10):1012–1023
Acknowledgements
This work was conducted within the frame of the SAFE-II and LEAD research projects and grateful acknowledge goes to the financial support of the Swiss Federal Nuclear Inspectorate (ENSI). The technical assistance and contribution to the mechanical testing of R. Schwenold at Paul Scherrer Institute is appreciated.
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2019 Springer Nature Switzerland AG
About this paper
Cite this paper
Chen, W., Spätig, P., Seifert, H.P. (2019). Mean Stress Effect on Fatigue Behavior of Austenitic Stainless Steel in Air and LWR Conditions. In: Correia, J., De Jesus, A., Fernandes, A., Calçada, R. (eds) Mechanical Fatigue of Metals. Structural Integrity, vol 7. Springer, Cham. https://doi.org/10.1007/978-3-030-13980-3_8
Download citation
DOI: https://doi.org/10.1007/978-3-030-13980-3_8
Published:
Publisher Name: Springer, Cham
Print ISBN: 978-3-030-13979-7
Online ISBN: 978-3-030-13980-3
eBook Packages: EngineeringEngineering (R0)