Development of a Superconducting Solenoid Magnet System for the B-Factory Detector (BELLE)

  • Y. Makida
  • H. Yamaoka
  • Y. Doi
  • J. Haba
  • F. Takasaki
  • A. Yamamoto
Part of the Advances in Cryogenic Engineering book series (ACRE, volume 43)

Abstract

A large superconducting solenoid magnet has been designed and fabricated for the BELLE particle detector, which will be installed in the KEKB colliding beam ring. It provides a central magnetic field of 1.5 T at 4000 A in a cylindrical volume of 3.4 m in diameter and 4.1m in length. The stored energy is calculated to be 42 MJ. The coil is wound with aluminum stabilized superconductor, after which aluminum strips are laminated on the coil for quench protection. The coil cold mass is approximately 7 tons with an estimated thermal load of 22 W at 4.2 K. A refrigerator of 240 W at 4.2 K is attached. The coil is indirectly cooled by forced flow of 2 phase helium through a cooling tube on the coil support cylinder. This method is preferred in order to avoia explosive boiling which may happen if a pool cooling method was used. A line in the solenoid is designed to allow the stored helium in the top buffer tank to circulate gravitationally in case of a suspension of cryogen, producing slow discharge without induced quench. This report presents the design and fabrication of the BELLE superconducting solenoid magnet.

Keywords

Vacuum Vessel Radiation Shield Superconducting Solenoid Solenoid Magnet Phase Helium 
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

References

  1. 1.
    “KEKB B-factory Design Report”, KEK Report 95–7, (1995).Google Scholar
  2. 2.
    K. Tsuchiya, The superconducting magnet system for KEKB B-factory, in: “Proceedings of the 5th European Accelerator Conference (EPAC 96)”, (1996), p.2287.Google Scholar
  3. 3.
    I.S. Hughes, “Elementary Particles”, Cambridge University Press, New York (1972).Google Scholar
  4. 4.
    H. Desportes et al., Construction and test of the CELLO thin-wall solenoid, in: “Advances in Cryogenic Engineering Vol. 25”, D-2(1980), p. 194.Google Scholar
  5. 5.
    H. Minemura et al., Construction and testing of a 3 m diameter X 5 m superconducting solenoid for the Fermilab Collider Detector Facility (CDF), Nuclear Instrument and Method in Physics Research A23:18 (1985)CrossRefGoogle Scholar
  6. 6.
    M. Wake et al., A large superconducting thin solenoid magnet for Tristan Experiment (VENUS) at KEK, IEEE Transaction on Magnetics, MAG-21 No.2:494 (1985)Google Scholar
  7. 7.
    A. Yamamoto et al., Test results of TOPAZ thin superconducting solenoid, in: “Proc. of 9th Int.Conf. on Mag. Technology (MT-9)”, Zürich (1985), p. 167.Google Scholar
  8. 8.
    J.M. Baze et al., Design, construction and test of the large superconducting solenoid ALEPH, in: “Proc. of 10th Int. Conf. on Mag. Technology (MT-10)”, Boston (1987), p.1260Google Scholar
  9. 9.
    P. Clee et al., Towards the realization of two 1.2 tesla superconducting solenoids for particle physics experiments, in: “Proc. of 11th Int. Conf. on Mag. Technology (MT-11)”, Tskuba (1989), p. 201.Google Scholar
  10. 10.
    A. B. Oliva et al., Zeus magnet constructions status Report, in: “Proc. of 11th Int. Conf. on Mag. Technology (MT-11)”, Tskuba (1989), p. 229.Google Scholar
  11. 11.
    J. Haba, KEKB and BELLE experiment, Nuclear Instrument and Method in Physics Research, A 368:74 (1995).CrossRefGoogle Scholar
  12. 12.
    A. Yamamoto et al., Development of a prototype thin superconducting solenoid for the SDC detector, IEEE Transaction on Applied Superconductivity, Vol. 5 No. 2:849.Google Scholar
  13. 13.
    Y. Makida et al., Performance of a thin superconducting solenoid for particle astrophysics, in: “Advances in Cryogenic Engineering 37 A”, (1991), p. 401.Google Scholar
  14. 14.
    M. N. Wilson, “Superconducting Magnet”, Oxford University Press, New York (1983).Google Scholar

Copyright information

© Springer Science+Business Media New York 1998

Authors and Affiliations

  • Y. Makida
    • 1
  • H. Yamaoka
    • 1
  • Y. Doi
    • 1
  • J. Haba
    • 1
  • F. Takasaki
    • 1
  • A. Yamamoto
    • 1
  1. 1.KEKHigh Energy Accelerator Research OrganizationTsukuba, Ibaraki, 305Japan

Personalised recommendations