Advertisement

Cutting the Parts II

  • Patrick Hood-Daniel
  • James Floyd Kelly
Chapter
  • 2.6k Downloads

Abstract

We’re going to pick up right where we left off in Chapter 4. At this point, you should have a total of seven pieces of your 3D printer cut out. These pieces are raw in form—just a specific length and width with no special cuts or holes drilled yet.

Keywords

Drive Pulley Plastic Extruder Rail Support Table Bearing Scrap Piece 
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

Copyright information

© Patrick Hood-Daniel, James Floyd Kelly 2011

Authors and Affiliations

  • Patrick Hood-Daniel
  • James Floyd Kelly

There are no affiliations available

Personalised recommendations