A Copying System for Low Batch Quantity Hydraulic Metal Spinning

  • A. Younger
  • C. C. Brown


A potentially low cost copying system has been developed for hydraulically assisted metal spinning. The method uses a simple feedback system and a two track cassette tape recorder. The use of this system for batch production is discussed. Results are presented indicating greater reproducibility of copied components than those manually produced.


Tool Path Deep Drawing Voltage Control Oscillator Tool Post Chromium Dioxide 
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.


Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.


  1. 1.
    B. AVITZUR, and C.T. YANG, (1960), Analysis of Power Spinning of Cones, Trans. Amer. Soc. Mech. Engrs. Ser. B, J. Engng. for Ind., 82, p. 231.Google Scholar
  2. 2.
    M. ATKEY, (1979) Spinning Shapes up to Today’s Demands, Mech. and Prod. Eng. 34, No. 3443, p. 13.Google Scholar
  3. 3.
    C.L. PACKAM, (1977) Metal Spinning and Shear and Flow Forming, Sheet Metal Ind. 54, (4) P. 382.Google Scholar
  4. 4.
    A. YOUNGER and A.J. FOSTER, (1976), An Investigation into Power Assisted Metal Spinning, Proc. 17th Intern. Mech. Tool Des. and Res. Conf. University of Birmingham.Google Scholar

Copyright information

© The Department of Mechanical Engineering, University of Birmingham 1980

Authors and Affiliations

  • A. Younger
    • 1
  • C. C. Brown
    • 1
  1. 1.Hatfield PolytechnicHatfield, HertsUK

Personalised recommendations