Abstract
Electrical and acoustical measurements are made on transducers to determine performance characteristics and parameters for comparison with goals and theoretical models when the latter are available. In this chapter we discuss the procedures and means for making such measurements [1–]. Admittance or impedance measurements are normally made first under air loading (which simulates a vacuum) and then under water loading, often at various hydrostatic pressures, temperatures, and drive levels. Measurements of the transmitting response, source level, efficiency, receiving response, beam patterns, and harmonic distortion of transducers and transducer arrays are usually made in the far field, where spherical spreading holds. However, in some cases measurements can be made in the near field and projected to the far field through extrapolation formulas. Measurement is the important final step in evaluating the performance of all transducers.
This is a preview of subscription content, log in via an institution to check access.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
Preview
Unable to display preview. Download preview PDF.
References
R.J. Bobber, Underwater Electroacoustic Measurements, Naval Research Laboratory, Washington, DC, 1969
L.L. Beranek, Acoustical Measurements, American Institute of Physics, Woodbury, NY, 1988
H.B. Miller, Ed. Acoustical Measurements, Hutchinson Ross Publishing Company, Stroudsburg, PA, 1982
D. Stansfield, Underwater Electroacoustic Transducers, Bath University Press, Bath, UK, 1990
O.B.Wilson, Introduction to Theory and Design of Sonar Transducers, Peninsula Publishing Co., Los Altos, CA, 1988
F.V. Hunt, Electroacoustics, Harvard University Press, N.Y. 1954
R.S. Woollett, Sonar Transducer Fundamentals, Naval Underwater Systems Center, Newport, RI, undated
L.F. Kinsler, A.R. Frey, A.B. Coppens, and J.V. Sanders, Fundamentals of Acoustics, Fourth Edition, Ch. 14 “Transduction,” John Wiley & Sons, Inc., New York, 2000
Private communication with Frank Massa.
H.F. Olson, Acoustical Engineering, D. Van Nostrand Company, Inc., Princeton, N.J., 1967
L.L. Beranek, Acoustics, McGraw-Hill Book Company, Inc., New York, 1954
K.S. Van Dyke, “The Piezoelectric resonator and its equivalent network,” Proc. IRE, 16, 742–764 (1928)
W.J. Marshall and G.A. Brigham, “Determining equivalent circuit parameters for low figure of merit transducers,” J. Acoust. Soc. Am., ARLO 5(3), 106–110 July (2004)
D.A. Berlincourt, D.R. Curran, and H. Jaffe, “Piezoelectric and piezomagnetic materials and their function in transducers,” Physical Acoustics, Vol. 1, Part A, Edited by W.. Mason, Academic Press, New York, 1964
J. deLaunay and P.L. Smith, “Aging of Barium Titanate and Lead Zirconate–Titanate Ferroelectric Ceramics,” Naval Research Laboratory Report 7172, 15 October 1970
D. Rife and J. Vanderkooy, “Transfer-function measurements with maximum-length sequences,” J. Audio Eng. Soc., 37, 419–443 (1989) See also, J. D’Appolito, Testing Loudspeakers, (Audio Amateur Press, Peterborough, NH, 1998)
B.B. Bauer, L.A. Abbagnaro, J. Schumann, “Wide-range calibration system for pressure-gradient hydrophones,” J. Acoust. Soc. Am., 51, 1717–1724 (1972)
D.B. Keele, Jr. “Low-frequency loudspeaker assessment by near-field sound pressure measurements,” J. Audio. Eng. Soc., 22, 154–162 (1974)
J.L. Butler and C.H. Sherman, “Near-field far-field measurements of loudspeaker response,” J. Acoust. Soc. Am., 108, 447–448 (2000)
A. Silbiger, “Radiation from circular pistons of elliptical profile,” J. Acoust. Soc. Am., 33, 1515–1522 (1961)
D.D. Baker, “Determination of far-field characteristics of large underwater sound transducers from near-field measurements,” J. Acoust. Soc. Am., 34, 1737–1744 (1962)
J.L. Butler, “Solution of Acoustical-Radiation Problems by Boundary Collocation,” J. Acoust. Soc. Am., 48, 325–336 (1970)
W.J. Trott, “Underwater-sound-transducer calibration from nearfield data,” J. Acoust. Soc. Am., 36, 1557–1568 (1964)
H.F. Olson, “Direct radiator loudspeaker enclosure,” J. Audio Eng. Soc., 17, 22–29 (1969)
G.C. Muller, R. Black, and T.E. Davis, “The diffraction produced by cylindrical and cubical obstacles and by circular and square plates,” J. Acoust. Soc. Am., 10, 6–13 (1938)
J.R. Wright, “Fundamentals of diffraction,” J. Audio Eng. Soc., 45, 347–356 (1997)
M.R. Urban, et al., “The distributed edge dipole (DED) model for cabinet diffraction effects,” J. Audio Eng. Soc., 52, 1043–1059 (2004)
Author information
Authors and Affiliations
Rights and permissions
Copyright information
© 2007 Springer Science+Business Media New York
About this chapter
Cite this chapter
Sherman, C.H., Butler, J.L. (2007). Transducer Evaluation and Measurement. In: Transducers and Arrays for Underwater Sound. Monograph Series in Underwater Acoustics. Springer, New York, NY. https://doi.org/10.1007/978-0-387-33139-3_12
Download citation
DOI: https://doi.org/10.1007/978-0-387-33139-3_12
Publisher Name: Springer, New York, NY
Print ISBN: 978-0-387-32940-6
Online ISBN: 978-0-387-33139-3
eBook Packages: Physics and AstronomyPhysics and Astronomy (R0)