Advertisement

Design and Analysis of Stringer on the Chassis Frame in Load Carrying Vehicle

  • B. StalinEmail author
  • M. Ravichandran
  • C. Ramesh Kannan
  • K. Sathiya Moorthi
Conference paper
Part of the Lecture Notes in Mechanical Engineering book series (LNME)

Abstract

In this paper, design and analysis of stringer for the chassis frame in load carrying vehicles is reported. In order to resist the shock, twist, and other stresses, the chassis must be a very hard one. In addition to the strength, the chassis should withstand adequate bending and torsional stiffness. Here, the work performed towards the analysis of stringer in chassis with the constraints of stiffness and strength by using finite element analysis software. Results show that hat stringer is stronger than C-stringer when the stringer is in bending conditions.

Keywords

Stringer Design Mechanical properties Finite element analysis 

References

  1. 1.
    Patel AS, Srivastava A (2016) Modeling, analysis & optimization of TATA 2518 TC truck chassis frame using CAE tools. Int J Eng Res Technol 5:10Google Scholar
  2. 2.
    Patel RL, Gawande KR, Morabiya DB (2014) Design and analysis of chassis frame of TATA 2516TC. Int J Res Appl Sci Eng Technol 2:IIIGoogle Scholar
  3. 3.
    Patel RL, Divyesh Morabiya B, Anil Rathour N (2014) Weight optimization of chassis frame using Pro-Mechanica. SSRG Int J Mech Eng (SSRG-IJME) 1:8Google Scholar
  4. 4.
    Mat MH, Ghani ARA (2012) Design and analysis of ‘Eco’ car chassis. Procedia Eng 41:1756–1760CrossRefGoogle Scholar
  5. 5.
    Nor MA, Rashid H, Mahyuddin WM, Azlan MA, Mahmud J (2012) Stress analysis of a low loader chassis. Procedia Eng 41:995–1001CrossRefGoogle Scholar
  6. 6.
    Ellobody E (2012) Nonlinear analysis of cellular steel beams under combined buckling modes. Thin-Walled Struct 52(1):66–79CrossRefGoogle Scholar
  7. 7.
    Ellobody E (2011) Interaction of buckling modes in castellated steel beams. J Constr Steel Res 67(5):814–825CrossRefGoogle Scholar
  8. 8.
    Firat M (2011) A computer simulation of four-point bending fatigue of a rear axle assembly. Eng Fail Anal 18(8):2137–2148CrossRefGoogle Scholar
  9. 9.
    Veloso V, Magalhaes HS, Bicalho GI, Palma ES (2009) Failure investigation and stress analysis of a longitudinal stringer of an automobile chassis. Eng Fail Anal 16(5):1696–1702CrossRefGoogle Scholar

Copyright information

© Springer Nature Singapore Pte Ltd. 2019

Authors and Affiliations

  • B. Stalin
    • 1
    Email author
  • M. Ravichandran
    • 2
  • C. Ramesh Kannan
    • 3
  • K. Sathiya Moorthi
    • 1
  1. 1.Department of Mechanical EngineeringAnna University, Regional Campus MaduraiMaduraiIndia
  2. 2.Department of Mechanical EngineeringK. Ramakrishnan College of EngineeringSamayapuram, TrichyIndia
  3. 3.Department of Mechanical EngineeringKarpagam Academy of Higher EducationCoimbatoreIndia

Personalised recommendations