Advertisement

Current Measurement of Engine Oils Under Various Voltage Application

  • Benedick Conolius
  • Norlin Pauzi
  • Mohd Herwan Sulaiman
  • Mohd Razali Daud
  • Kadowaki Kazunori
  • Amir Izzani MohamedEmail author
Conference paper
Part of the Lecture Notes in Electrical Engineering book series (LNEE, volume 538)

Abstract

This paper presents the conduction current measurement of engine oil of a vehicle during engine oil usage. A motorcycle and car engine oil is the sample in this study. For motorcycle engine oil, sample was taken between 0 and 1500 km while for car engine oil, it was taken between 0 and 9000 km. The electrode was printed to PCB board and the oil was placed between electrode with 1 mm gap. The current was measured by a microammeter under voltage applied from 0.2 to 1.0 kV. From the result it is understood that the current decreases with the increase in travelling distance of each vehicle. Motorcycle engine oil shows a higher current decreasing rate as compares to car engine oil.

Keywords

Engine oil Current High voltage 

References

  1. 1.
    Soleimani, M.: Thick film sensors for engine oil acidity detection. University of Southampton, Faculty of Engineering and the Environment, Doctoral Thesis (2014)Google Scholar
  2. 2.
    Thom, A.C.G.: Diesel engines diagnosis through analysis of lubricating oil. In: International Conference on Systems, Man, and Cybernetics (SMC), pp. 2751–2756. IEEE (2014)Google Scholar
  3. 3.
    Kardoš, S., Pietriková, A., Tóthová, J.: Possibilities of motor oil continuous diagnostics. In: 38th International on Spring Seminar on Electronics Technology, pp. 277–282. IEEE (2015)Google Scholar
  4. 4.
    Idros, M.F.M., Ali, S., Islam, M.S.: Quantitative analysis of spectroscopy’s study for engine oil degradation monitoring due to temperature effect. In: Third International Conference on Intelligent Systems Modelling and Simulation, pp. 278–282. IEEE (2012)Google Scholar
  5. 5.
    Al-ghouti, M.A., Al-atoum, L.: Virgin and recycled engine oil differentiation: a spectroscopic study. J. Environ. Manage. 90(1), 187–195 (2009)CrossRefGoogle Scholar
  6. 6.
    Idros, M.F.M., Ali, S., Islam, M.S.: Optical behavior of transmission oil lubricant for degradation monitoring. In: IEEE Student Conference on Research and Development, pp. 225–228 (2011)Google Scholar
  7. 7.
    Dikarev, B.N., Ostaperiko, A.A. Karasev, G.G.: Viscosity dependence of dielectric liquids on electric field. In: 11th International Conference on Conduction and Breakdown in Dielectric Liquids (ICDL), pp. 1–5 (1993)Google Scholar
  8. 8.
    Romanets, R., Dikarev, B.N., Ostaperiko, A.A., Karasev, G.G.: Relaxation currents in dielectric liquids. In: 10th International Conference on Conduction and Breakdown in Dielectric Liquids, pp. 196–200 (1990)Google Scholar
  9. 9.
    Jwo, C., Jeng, L., Chang, H., Teng, T.: Experiment study on thermal conductivity of lubricant containing nanoparticles. Rev. Adv. Mater. Sci. 18(7), 660–666 (2008)Google Scholar

Copyright information

© Springer Nature Singapore Pte Ltd. 2019

Authors and Affiliations

  • Benedick Conolius
    • 1
  • Norlin Pauzi
    • 2
  • Mohd Herwan Sulaiman
    • 1
  • Mohd Razali Daud
    • 1
  • Kadowaki Kazunori
    • 3
  • Amir Izzani Mohamed
    • 1
    Email author
  1. 1.FKEE, Universiti Malaysia PahangPekanMalaysia
  2. 2.FKKSA, Universiti Malaysia PahangGambangMalaysia
  3. 3.Electrical and Electronic EngineeringEhime UniversityMatsuyamaJapan

Personalised recommendations