Advertisement

Vane Shear Tests to Evaluate in Situ Stress State of a Soil-Bentonite Slurry Trench Wall

  • Jeffrey C. Evans
  • Yu-Ling Yang
  • Daniel G. Ruffing
Conference paper
Part of the Environmental Science and Engineering book series (ESE)

Abstract

Soil-bentonite slurry trench cutoff walls have been employed widely in the US as engineered barriers to control groundwater flow and contaminant migration in the subsurface. The hydraulic conductivity of the soil-bentonite backfill is stress dependent and to better understand the in-situ stress state of soil-bentonite slurry trench walls, a wall with a length of 194 m, depth of 7 m, and width of 0.9 m was constructed, instrumented, and investigated in-situ. As a part of the in-situ investigation, vane shear tests were conducted at different locations and depths to evaluate the shear strength distribution within the wall. The results indicate that the peak undrained shear strength value, Su, exhibits a consistent trend with increasing depth. In general, two stages of Su were observed: (1) at depth from 1 to 2.5 m, the Su decreases as depth increases, presumably due to the effects of the cover soil and groundwater level; (2) at depth of 2.5 to 7 m, the Su shows insignificant change with depth and falls into the range of 5 to 10 kPa. Using a constant shear strength to effective stress ratio, Su/σ′, the stresses predicted from the vane shear strength tests were in good agreement with those measured using earth pressure sensors embedded at the time of wall construction.

Keywords

Bentonite Shear strength Slurry wall State of stress Vane shear 

Notes

Acknowledgements

The financial support of the National Science Foundation (Grant No. 1463198) is greatly appreciated. The authors would like to thank Central Builders Supply (Montandon, PA), CETCO (Hoffman Estates, IL) and Geo-Solutions, Inc. (New Kensington, PA) for their resources, bentonite supply and wall construction for this study. Special thanks goes to James Gutelius, Director of Laboratories for the Department of Civil and Environmental Engineering, Bucknell University, as well as Landon Barlow, graduated student of Bucknell University for their great assistance and contribution on data collection. Finally, the authors appreciate the financial support through the generosity of Michael and Laureen Costa, which enabled Yuling Yang’s postdoctoral research on this study.

References

  1. D’Appolonia DJ (1980) Soil-bentonite slurry trench cutoffs. J Geotech Eng Div 106(4):399–417Google Scholar
  2. Evans JC (1993) Vertical cutoff walls. In: Daniel DE (ed) Geotechnical practice for waste disposal. Chapman and Hall, LondonGoogle Scholar
  3. Evans JC (1994) Hydraulic conductivity of vertical cutoff walls. In: Hydraulic conductivity and waste contaminant transport, ASTM STP 1142, pp 79–94 (1994)Google Scholar
  4. Evans JC, Huang H (2016) Hydraulic conductivity of soil bentonite slurry walls. In: Proceedings of ASCE GeoChicago 2016 sustainability, energy, and the geoenvironment, ASCE GSP, Reston, VA, pp 548–577Google Scholar
  5. Evans JC, Ruffing DG (2017) Design and construction of an experimental soil-bentonite cutoff wall. In: ASCE geotechnical frontiers 2017, ASCE GSP, Reston, VA, pp 164–174Google Scholar
  6. Evans JC, Ryan CR (2005) Time-dependent strength behavior of soil-bentonite slurry wall backfill. In: Geo-frontiers congress 2005, waste containment and remediation, ASCE GSP, Reston, VA, pp 1–9Google Scholar
  7. Evans J, Orobia M, Gutelius J, Ruffing D, Barlow L, Malusis M (2017) Soil-bentonite slurry trench cutoff wall lateral deformations, consolidation, stress transfer and hydraulic conductivity. In: Proceedings of the 2nd symposium on coupled phenomena in environmental geotechnics (CPEG2), Leeds, UK, pp 1–6Google Scholar
  8. Filz et al (2001) Determining hydraulic conductivity of soil-bentonite using the API filter press. ASTM Geotech Test J 24(1):61–71CrossRefGoogle Scholar
  9. Holtz RD, Kovacs WD (1981) An introduction to geotechnical engineering. Prentice-Hall, Inc., Upper Saddle River, New JerseyGoogle Scholar
  10. Lambe TW, Witman RV (1969) Soil mechanics, SI version. John Wiley and Sons, Inc., New YorkGoogle Scholar
  11. Malusis MA., Evans JC, Gutelius J, Jacob RW, Ruffing DG, Barlow LC, Barchiori A (2017) Construction and monitoring of an instrumented soil-bentonite cutoff wall: field research case study. In: Proceedings of the 29th central Pennsylvania geotechnical conference proceedings, Hershey, PA, 25–27 January 2017Google Scholar
  12. Ruffing DG, Evans JC (2010) In situ evaluation of a shallow soil bentonite slurry trench cutoff wall. In: Proceedings of the 6th international congress on environment geotechnics, New Delhi, India, Tata McGraw-Hill, pp 758–763. ISBN 13:9780070707108Google Scholar
  13. Ruffing DG, Evans JC, Malusis MA (2010) Prediction of earth pressures in soil-bentonite cutoff walls. In: ASCE GeoFlorida 2010 advances in analysis, modeling and design GSP 199, ASCE GSP, Reston, VA, pp 2416–2425Google Scholar
  14. Ruffing DG, Evans JC, Malusis MA (2011) Evaluations of lateral earth pressure in a soil-bentonite slurry trench cutoff wall. In: 14th Pan-American conference on soil mechanics and geotechnical engineering. CD-ROM. ISBN 978-0-920505-47-2Google Scholar
  15. Ruffing DG, Evans JC, Ryan CR (2015) Strength and stress estimation in soil bentonite slurry trench cutoff walls using cone penetration test data. In: Proceedings of the international foundations congress and equipment expo, ASCE GSP, Reston, VA, pp 2567–2576Google Scholar
  16. Ruffing DG, Evans JC (2015) Strength and stress estimation in soil bentonite slurry trench cutoff walls using cone penetration test data. In: The international foundations congress and equipment expo, San Antonio Texas ASCE GSP 256, pp 2567–2576Google Scholar
  17. Shackelford CD (1994) Waste-soil interactions that alter hydraulic conductivity, ASTM STP, Reston, VA, pp 111–168Google Scholar
  18. Sharma HD, Reddy KR (2004) Geoenvironmental engineering: site remediation, waste containment, and emerging waste management technologies. John Wiley & Sons Inc, Hoboken, New JerseyGoogle Scholar

Copyright information

© Springer Nature Singapore Pte Ltd. 2019

Authors and Affiliations

  • Jeffrey C. Evans
    • 1
  • Yu-Ling Yang
    • 1
  • Daniel G. Ruffing
    • 2
  1. 1.Department of Civil and Environmental EngineeringBucknell UniversityLewisburgUSA
  2. 2.Geo-Solutions, Inc.New KensingtonUSA

Personalised recommendations