Advertisement

Analysis and Evaluation for B-Double Vehicles Handling Stability

  • Hong-guo Xu
  • Guo-jun Wang
  • Hong-fei Liu
  • Yi-hua Zhang
Conference paper
Part of the Lecture Notes in Electrical Engineering book series (LNEE, volume 503)

Abstract

An analytical method was introduced and used to solve the dynamics equation set which could simplify computational process, and four degrees of freedom (DOF) linear models were developed for B-double vehicles. Under the condition of tractor’s steering wheel angle as the step input, motion state variables, steady-state yaw rate gain, and understeer gradient for each vehicle unit were solved with MATLAB. It was analyzed that the correspondence between understeer gradient and steady-state relative yaw angle gain whose impacts on handling stability for vehicle unit were evaluated. With the variation of mass and rear axle tire cornering stiffness, location of mass center and wheelbase, location of articulated point for each vehicle unit, and the effects on the understeer gradient were analyzed. Handling stability was evaluated by the variation of vehicle’s operating condition and structural parameters. The results indicate that increasing mass and rear axle tire cornering stiffness properly, moving forward mass center and increasing wheelbase properly, moving backward articulated points, and decreasing mass properly could increase the understeer gradient which lead to the improvement of handling stability. It could provide theoretical basis for B-double vehicles stability tests.

Keywords

Vehicle dynamics B-double vehicles Handling stability Steady-state yaw rate gain Understeer gradient Structural parameters 

Notes

Acknowledgements

This research was supported by the National Natural Science Foundation of research on vehicle driving stability region based on driving torque and steering angle bifurcation (51475199) and open project of Key Laboratory of Transportation Industry for safe technology in vehicle operation (KFKT2016-01).

References

  1. 1.
    Li J (2013) B-double modular vehicle combinations shown on Logistics Expo. Commercial Veh News 38:4Google Scholar
  2. 2.
    Ying CY (2016) The introduction of national standard Limits of dimensions, axle load and masses for motor vehicles, trailers and combination vehicles revised edition (GB 1589-2016). Auto Saf (08):90–94Google Scholar
  3. 3.
    Fancher PS (1979) Simulation of the directional response characteristics of tractor-semitrailer vehicles. Final reportGoogle Scholar
  4. 4.
    Fancher PS (1985) The static stability of articulated commercial vehicles. Veh Syst Dyn 14(4–6):201–227CrossRefGoogle Scholar
  5. 5.
    Xie L (1984) Simulation of tractor-trailer system stability. M.S. thesis, Iowa State UniversityGoogle Scholar
  6. 6.
    Chen WW, Wang RG, Sun J (1994) Computer simulation of handling stability of tractor-semitrailer. Tractor 3:23–29Google Scholar
  7. 7.
    Chen C, Tomizuka M (1995) Dynamic modeling of tractor-semitrailer vehicles in automated highway systems. California Partners for Advanced Transit and Highways (PATH)Google Scholar
  8. 8.
    Pauwelussen JP (2001) Excessive yaw behaviour of commercial vehicles, a fundamental approach. In: 17th International Technical Conference on the Enhanced Safety of Vehicles (ESV-17), Amsterdam, The Netherlands, 4–7 June 2001Google Scholar
  9. 9.
    Dahlberg E, Wideberg J (2004) Influence of the fifth-wheel location on heavy articulated vehicle handling. In: 8th International Symposium on Heavy Vehicle Weights & Dimensions. Johannesburg, South AfricaGoogle Scholar
  10. 10.
    Liu HF (2005) Study on the simulation and control strategy for yaw motion dynamics of tractor-semi trailer. Jilin University, ChangchunGoogle Scholar
  11. 11.
    Guan ZZ, Liu HF (2006) Study on distinguish method for tractor-semitrailer steady state cornering performance. J Tianjin Univ Technol Educ 16(1):1–3MathSciNetGoogle Scholar
  12. 12.
    Yang XJ, Li XT (2012) A study on the handling characteristics and lateral stability of tractor-semitrailer combination. Autom Eng 12:1107–1113Google Scholar
  13. 13.
    Barbieri N, de Melo RP, Barbieri R (2005) Analysis of the lateral stability of cargo vehicles combinations-CVCS. In: Proceedings of the COBEM 2005: 18th International Congress of Mechanical EngineeringGoogle Scholar
  14. 14.
    Wei CY (2008) Research on the handling stability of caravans. Jiangsu University, ZhenjiangGoogle Scholar
  15. 15.
    Salaani MK (2009) The application of understeer gradient in stability analysis of articulated vehicles. Int J Heavy Veh Syst 16(1–2):3–25CrossRefGoogle Scholar
  16. 16.
    Yang XJ (2009) Research on the nonlinear dynamics and active control for vehicle cornering destabilization in critical situations. Shandong University, JinanGoogle Scholar
  17. 17.
    Ji-hua B, Jin-liang L, Yan Y (2011) Lateral stability analysis of the tractor/full trailer combination vehicle. In: 2011 International Conference on Electric Information and Control Engineering (ICEICE). IEEE, pp 2294–2298Google Scholar
  18. 18.
    Ren YY, Zheng XL, Li XS (2012) Handling stability of tractor semitrailer based on handling diagram. Discrete Dynamics in Nature and Society, vol 2012, Article ID 350360, 16 pp.  https://doi.org/10.1155/2012/350360CrossRefGoogle Scholar
  19. 19.
    Tabatabaei SH, Zahedi A, Khodayari A (2012) The effects of the cornering stiffness variation on articulated heavy vehicle stability. In: 2012 IEEE International Conference on Vehicular Electronics and Safety (ICVES). IEEE, pp 78–83Google Scholar
  20. 20.
    Ou CJ, Zhou G, Liu XD et al (2015) Simulation and analysis on handling stability of tractor-semitrailer. In: 2015 International Conference on Transportation Information and Safety (ICTIS). IEEE, pp 94–101Google Scholar

Copyright information

© Springer Nature Singapore Pte Ltd. 2019

Authors and Affiliations

  • Hong-guo Xu
    • 1
  • Guo-jun Wang
    • 1
  • Hong-fei Liu
    • 1
  • Yi-hua Zhang
    • 1
  1. 1.School of TransportationJilin UniversityChangchunChina

Personalised recommendations