Failure Analysis on Perforation of Cr28Ni48W5 Alloy Heat Radiant Tube

Conference paper

Abstract

An electric radiant tube in continuous annealing furnace was manufactured by using Cr28Ni48W5 heat resistant alloy with the built-in electric resistance bars of 0Cr27Al7Mo2 supported by the insulation of high-temperature ceramic disk. The radiant tube was found to be perforated during the annual routine inspection. In this study, a failure analysis of the radiant tube was performed by carefully visual inspection of the failed tube, scanning electron microscopy observation of perforation samples, and energy-dispersive X-ray spectroscopy analysis of the tube metals and oxide scales. The used materials were prepared by centrifugal casting. The analysis showed that there exhibited the microstructure characteristic of melting and solidification near the perforation hole, and the serious oxidation had occurred. It is inferred that under the condition of prolonged high-temperature heating, the creep deformation caused the electric resistance bar bend to contact the tube inner surface, and then electrical discharge took place and further melted the tube inner matrix through continuous heating by the release of electrical arc.

Keywords

Heat resistant steel Electric radiant tube Perforation Arc discharge erosion 

References

  1. 1.
    A Alvino, D Lega, F Giacobbe, V Mazzocchi, A Rinaldi, Damage characterization in two reformer heater tubes after nearly 10 years of service at different operative and maintenance conditions, Engineering Failure Analysis, 17(2010) 1526–1541.Google Scholar
  2. 2.
    G Dini, S Vaghefi, M Lotfiani, M Jafari, M Safaei-Rad, M Navabib, S Abbasi, Computational and experimental failure analysis of continuous-annealing furnace radiant tubes exposed to excessive temperature, Engineering Failure Analysis. 15 (2008) 445–457.Google Scholar
  3. 3.
    L Feng, J Zhou, Q Zhang, Development of CSP furnace roller ring, Science &Technology of Baotou Steel (Group) Corporation. 30 (2004) 70–72.Google Scholar
  4. 4.
    L Wang, Analysis and coutermeasure of radiant tube damage cause for the continuous annealing heating furnace set in 1550 unit, 6 (2003) 44–46.Google Scholar
  5. 5.
    K B Yoon, D G Jeong, Oxidation failure of radiant heater tubes, Engineering Failure Analysis. 6 (1998) 101–112.Google Scholar
  6. 6.
    A Ul-Hamid, HM. Tawancy, A I. Mohammed, N M. Abbas, Failure analysis of furnace radiant tubes exposed to excessive temperature, Engineering Failure Analysis. 13 (2006) 1005–1021.Google Scholar
  7. 7.
    Michael K. Budinski, Failure analysis of a bearing in a helicopter turbine engine due to electrical discharge damage, Case Studies in Engineering Failure Analysis. 2 (2014) 127–137.Google Scholar

Copyright information

© Springer Nature Singapore Pte Ltd. 2018

Authors and Affiliations

  1. 1.Shanghai Research Institute of MaterialsShanghaiChina
  2. 2.Baoshan Iron and Steel Co. Ltd.ShanghaiChina
  3. 3.State Key Laboratory of Advanced Special SteelsShanghai UniversityShanghaiChina

Personalised recommendations