Advertisement

Effect of a Passive Exoskeleton on Muscle Activity and Posture During Order Picking

  • R. Motmans
  • T. Debaets
  • S. Chrispeels
Conference paper
Part of the Advances in Intelligent Systems and Computing book series (AISC, volume 820)

Abstract

Order picking is a standard task in logistics that is difficult to fully automate due to the variety of products. A passive exoskeleton can therefore be a strategy to support the order picker. This field study investigated the effect on muscle activity and posture of the back and shoulders.

Ten operators performed the task of order picking cheese in real life conditions 1,5 h without and 1,5 h with exoskeleton. The electromyography (EMG) of m. Erector Spinae and m. Trapezius pars descendens was measured. The posture of the back and upper arms were recorded by motion sensors. The subjective experience was questioned on a 5 point scale.

During order picking the back muscle activity was 9 and 12% lower when wearing the exoskeleton, respectively for the left and right side. The back was bent more than 30° for 26% of the time with exoskeleton and 23% without. The difference was not significant. The muscle activity and postures in the right and left shoulder also didn’t show meaningful differences. Subjectively the physical load was experienced positively with the exoskeleton. However, fatigue and safety require some attention.

The practical implication of an exoskeleton in the prevention of low back pain is discussed. Due to the rather small benefit this will probably not be the only solution to reduce the physical load of a job.

Keywords

Exoskeleton Muscle activity EMG Posture 

References

  1. 1.
    de Looze MP, Bosch T, Krause F, Stadler KS, O’Sullivan LW (2016) Exoskeletons for industrial application and their potential effects on physical work load. Ergonomics 59(5):671–681CrossRefGoogle Scholar
  2. 2.
    Abdoli-Eramaki M, Agnew MJ, Stevenson JM (2006) An on-body personal lift augmentation device (PLAD) reduces EMG amplitude of Erector Spinae during lifting tasks. Clin Biomech 21(5):456–465CrossRefGoogle Scholar
  3. 3.
    Abdoli-Eramaki M, Stevenson JM (2008) The effect of on-body lift assistive device on the lumbar 3D dynamic moments and EMG during asymmetric freestyle lifting. Clin Biomech 23:372–380CrossRefGoogle Scholar
  4. 4.
    Frost DM, Abbodli-Eramaki M, Stevenson JM (2009) PLAD (personal lift assistive device) Stiffness affects the lumbar flexion/extension moment and the posterior chain EMG during symmetrical lifting tasks. J Electromyogr Kinesiol 19(6):403–412CrossRefGoogle Scholar
  5. 5.
    Graham RB, Agnew MJ, Stevenson JM (2009) Effectiveness of an on-body lifting aid at reducing low back physical demands during an automotive assembly task: assessment of EMG response and user acceptability. Appl Ergon 40(5):936–942CrossRefGoogle Scholar
  6. 6.
    Ulrey BL, Fathallah FA (2013) Subject-specific whole-body models of the stooped posture with a personal weight transfer device. J Electromyogr Kinesiol 23(1):206–215CrossRefGoogle Scholar
  7. 7.
    Whitfield BH, Costigan PA, Stevenson JM, Smallman CL (2014) Effect of an on-body ergonomic aid on oxygen consumption during a repetitive lifting task. Int J Ind Erg 44(1):39–44CrossRefGoogle Scholar
  8. 8.
    Bosch T, van Eck J, Knitel K, de Looze M (2016) The effects of a passive exoskeleton on muscle activity, discomfort and endurance time in forward bending. Apll Ergon 54:212–217CrossRefGoogle Scholar
  9. 9.
    Lotz CA, Agnew MJ, Godwin AA, Stevenson JM (2009) The effect of an on-body personal lift assist device (PLAD) on fatigue during a repetitive lifting task. J Electromyogr Kinesiol 19(2):331–340CrossRefGoogle Scholar
  10. 10.
    Godwin A, Stevenson JM, Agnew MJ, Twiddy AL, Abdoli-Eramaki M, Lotz CA (2009) Testing the efficacy of an ergonomic lifting aid at diminishing muscular fatigue in women over a prolonged period of lifting. Int J Ind Erg 39:121–126CrossRefGoogle Scholar
  11. 11.
    Abdoli-Eramaki M, Stevenson JM, Reid A, Bryant TJ (2007) Mathematical and empirical proof of principle for an on-body personal lift augmentation device (PLAD). J Biomech 40(8):1694–1700CrossRefGoogle Scholar
  12. 12.
    Muramatsu Y, Kobayashi H, Sato Y, Jiaou H, Hashimoto T, Kobayashi H (2011) Quantitative performance analysis of exoskeleton augmenting devices – Muscle Suit – for manual worker. Int J Autom Tech 5(4):559–567CrossRefGoogle Scholar
  13. 13.
    Kobayashi H, Nozaki H (2007) Development of muscle suit for supporting manual worker. In: IEEE/RSJ international conference on intelligent robots and systems, San Diego, pp 1769–1774Google Scholar
  14. 14.
    Sadler EM, Graham RB, Stevenson JM (2011) The personal lift-assist device and lifting technique: a principal component analysis. Ergonomics 54(4):392–402CrossRefGoogle Scholar

Copyright information

© Springer Nature Switzerland AG 2019

Authors and Affiliations

  1. 1.Department Health and Safety at WorkColruyt GroupHalleBelgium

Personalised recommendations