Advertisement

Comparative Energy, Exergy, and Environmental Analyses of Parabolic Trough Solar Thermal Power Plant Using Nanofluids

  • Abid Muhammad
  • T. A. H. Ratlamwala
  • Atikol Ugur
Chapter
Part of the Green Energy and Technology book series (GREEN)

Abstract

This comparative study focuses on energy, exergy, and environmental analyses of parabolic trough solar thermal power plant working on four different fluids. Two of the four fluids used are nanofluids, aluminum oxide (Al2O3) and ferrous oxide (Fe2O3). The other two fluids are glycerol and Therminol 66 which are oils. Two operating parameters, ambient temperature (T0) and solar irradiance (Gb), are varied to observe their effect on the heat rate produced, net power produced, energy efficiency, exergy efficiency, and environmental impact of parabolic trough solar thermal power plant (PTSTPP). The results obtained show that the energy and exergy efficiencies increase by increasing the solar irradiance. The energy efficiency of parabolic trough solar collector (PTSC) running on four different fluids, aluminum oxide, ferrous oxide, glycerol, and therminol, increases from 52.53% to 79.29%, 52.2% to 78.65%, 52.53% to 79.15%, and 53.17% to 80.13%, respectively, with increase in solar irradiance from 400 W/m2 to 1100 W/m2. The exergy efficiency of PTSC for the tested fluids increases from 24.68% to 41.91%, 24.64% to 42.3%, 24.67% to 42%, and 24.72% to 41.33%, respectively, by increasing the solar irradiance. The net power produced by parabolic trough solar thermal power plant (PTSTPP) is found to be increasing from 76.55 to 81.51 kW, 74.25 to 79.17 kW, 76.08 to 81.03 kW, and 100.2 to 106.5 kW, respectively, with increase in ambient temperature from 275 to 325 K. The exergo-environmental impact index for the four fluids decreases from 3.379 to 3.072, 3.419 to 3.102, 3.388 to 3.079, and 2.435 to 2.202, respectively, by increasing the ambient temperature from 275 K to 325 K. It was observed that the use of nanofluid enhances the net power output of the solar thermal power plant. The analyses also show that increase in ambient temperature and solar irradiance considerably affects the exergetic efficiency and environmental impact of parabolic trough solar thermal power plant.

Keywords

Energy Exergy Nanofluids Environmental impact Parabolic trough 

References

  1. Ahmadi, P., Dincer, I., Rosen, M.A.: Exergo-environmental analysis of an integrated organic Rankine cycle for trigeneration. Energy Convers. Manag. 64, 447–453 (2012)CrossRefGoogle Scholar
  2. Choi, S.U.S., Eastman, J. A.: Enhanced heat transfer using nanofluids. U.S. Patent. 6221, 275, 2001Google Scholar
  3. Dincer, I. and Ratlamwala, T. A. H.: Solar thermal power systems. Earth Systems and Environmental Sciences, 05931 (2013)Google Scholar
  4. Dincer, I., Rosen, M.A.: Exergy, Energy, Environment and Sustainable Development. Elsevier, Oxford (2007)Google Scholar
  5. Fan, X., Tan, J., Zhang, G., Zhang, F.: Isolation of carbon nanohorns assemblies and their potential for intracellular delivery. Nanotechnology. 18(195103), 1–6 (2007)Google Scholar
  6. Grimm, A.: Powdered aluminum-containing heat transfer fluids. German patent DE 4131516 A1, 1993Google Scholar
  7. Iijima, S., Yudasaka, M., Yamada, R., Bandow, S., Suenaga, K., Kokai, F., Takahashi, K.: Nano-aggregates of single-walled graphitic carbon nano-horns. Chem. Phys. Lett. 309(3–4), 165–170 (1999)CrossRefGoogle Scholar
  8. Kalogirou, S.A.: Solar Energy Engineering: Processes and Systems. Elsevier Inc, London (2009)Google Scholar
  9. Klein S. A. F-Chart Software (1975): engineering equation solver. http://www.fchart.com/ees/ (1975).
  10. Lenert, A., Wang, E.N.: Optimization of nanofluid volumetric receivers for solar thermal energy conversion. Sol. Energy. 86, 253–265 (2012)CrossRefGoogle Scholar
  11. Li, Y., Zhou, J., Tung, S., Schneider, E., Xi, S.: A review on development of nanofluid preparation and characterization. Powder Technol. 196, 89–101 (2009)CrossRefGoogle Scholar
  12. Masuda, H., Ebata, A., Teramae, K., Hishinuma, N.: Alteration of thermal conductivity and viscosity of liquid by dispersing ultra-fine particles (dispersion of g- Al2O3, SiO2 and TiO2 ultra-fine particles). Netsu Bussei (Japan). 7, 227–233 (1993)CrossRefGoogle Scholar
  13. Mercatelli, L., Sani, E., Zaccanti, G., Martelli, F., Ninni, D.P., Barison, S., Pagura, C., Agresti, F., Jafrancesco, D.: Absorption and scattering properties of carbon nanohorn-based nanofluid for direct sunlight absorbers. Nanoscale Res. Lett. 6(1), 282 (2011)CrossRefGoogle Scholar
  14. Natarajan, E., Sathish, R.: Role of nanofluids in solar water heater. Int. J. Adv. Manuf. Technol. (2009). doi:10.1007/S00170-008-1876-8Google Scholar
  15. Otanicar, T., Phelan, P.E., Prasher, R.S., Rosengarten, G., Taylor, R.A.: Nanofluid based direct absorption solar collector. J. Renew. Sust. Energy. 2, 033102 (2010)CrossRefGoogle Scholar
  16. Otanicar, T., Golden, J.: Comparative environmental and economic analysis of conventional and nanofluid solar hot water technologies. Environ. Sci. Technol. 43, 6082–6087 (2009)CrossRefGoogle Scholar
  17. Ratlamwala, T.A.H., Dincer, I.: performance assessment of solar-based integrated Cu–Cl systems for hydrogen production. Sol. Energy. 95, 345–356 (2013)CrossRefGoogle Scholar
  18. Ratlamwala, T.A.H., Dincer, I., Aydin, M.: Energy and exergy analyses and optimization study of an integrated solar heliostat field system for hydrogen production. Int. J. Hydrog. Energy. 37, 18704–18712 (2012)CrossRefGoogle Scholar
  19. Ratlamwala, T.A.H., Dincer, I., Reddy, V.B.: Exergetic and Environmental Impact Assessment of an Integrated System for Utilization of Excess Power from Thermal Power Plant. Springer Science+Business Media, New York (2013)CrossRefGoogle Scholar
  20. Rosen, M.A., Dincer, I., Kanoglu, M.: Role of exergy in increasing efficiency and sustainability and reducing environmental impact. Energy Policy. 36(1), 128–137 (2008)CrossRefGoogle Scholar
  21. Saidur, R., Leong, K.Y., Mohammad, H.A.: A review on applications and challenges of nanofluids. Renew. Sust. Energ. Rev. 15, 1646–1668 (2011b)CrossRefGoogle Scholar
  22. Saidur, R., Kazi, S.N., Hossain, M.S., Rahman, M.M., Mohammed, H.A.: A review on the performance of nanoparticles suspended with refrigerants and lubricating oils in refrigeration systems. Renew. Sust. Energy Rev. 15, 310–323 (2011a)CrossRefGoogle Scholar
  23. Sani, E., Barison, S., Pagura, C., Mercatelli, L., Sansoni, P., Fontani, D.: Carbon nanohorns-based nanofluids as direct sunlight absorbers. Opt. Express. 18(5), 5180–5187 (2010)CrossRefGoogle Scholar
  24. Taylor, R.A., Phelan, P.E., Otanicar, T.P., Adrian, R., Prasher, R.: Nanofluid optical property characterization: towards efficient direct absorption solar collectors. Nanoscale Res. Lett. 6(1), 1–11 (2011)CrossRefGoogle Scholar
  25. Thomas, S., Sobhan, C.: A review of experimental investigations on thermal phenomena in nanofluids. Nanoscale Res. Lett. 6, 377 (2011)CrossRefGoogle Scholar
  26. Tyagi, H., Phelan, P., Prasher, R.: Predicted efficiency of a low-temperature nanofluid based direct absorption solar collector. J. Sol. Energy Eng. 131, 041004–041001 (2009)CrossRefGoogle Scholar
  27. Yousefi, T., Veisy, F., Shojaeizadeh, E., Zinadini, S.: An experimental investigation on the effect of MWCNT–H2O nanofluid on the efficiency of flat-plate solar collectors. Exp. Thermal. Fluid Sci. 39, 207–212 (2012a)CrossRefGoogle Scholar
  28. Yousefi, T., Veysi, F., Shojaeizadeh, E., Zinadini, S.: An experimental investigation on the effect of Al2O3–H2O nanofluid on the efficiency of flat-plate solar collectors. Renew. Energy. 39, 293–298 (2012b)CrossRefGoogle Scholar

Copyright information

© Springer International Publishing AG, part of Springer Nature 2018

Authors and Affiliations

  • Abid Muhammad
    • 1
  • T. A. H. Ratlamwala
    • 2
  • Atikol Ugur
    • 3
  1. 1.Faculty of Engineering, Department of Energy Systems EngineeringCyprus International UniversityNicosiaTurkey
  2. 2.Shaheed Zulfikar Ali Bhutto Institute of Science and TechnologyClifton CampusKarachiPakistan
  3. 3.Faculty of Engineering, Department of Mechanical EngineeringEastern Mediterranean UniversityFamagustaTurkey

Personalised recommendations