Thermal Energy Recovery System for Upgrading Waste Heat by an Absorption Heat Pump
An innovative absorption heat pump (AHP) system is proposed to increase the temperature from waste heat to a level of 80 °C and to produce hot air over 120 °C for drying or simultaneously generating steam of 100–115 °C. Air is heated up directly by heat exchange in the absorber working in the heating mode of a LiBr/H2O AHP system. Steam is sequentially produced by heat exchange, with the absorption solution still maintaining a high temperature. An examination was carried out continuously to evaluate the performance of a bench-scale of the AHP. In the proposed AHP, the temperature of hot air at the outlet of the absorber was typically above 120 °C and, steam up to 115 °C was simultaneously generated by recovering the heat of the hot water at 80 °C. The coefficient of performance, defined by the ratio of heat generated to the power consumed for pumps of fluid flow, exceeded 20. It was also found that the fine particle slurry of LiBr crystals is formed stably in the solution under a supersaturation condition when zeolite powder is suspended. Then an almost saturated concentration is maintained as a result of the dissolution of the crystal, even if the solution is diluted by absorption of water vapor in the absorber. The theoretical analysis based on a heat and mass transfer model predicted that the output power of the AHP improved by almost 100 % compared with the conventional solution at concentrations lower than saturation solubility. Measurement of the slurry properties and an experiment on the absorption performance of the slurry were carried out, and the effectiveness of the slurry was confirmed. This chapter reviews a series of works done by the present author.
KeywordsAbsorption heat pump Heating mode Exhaust heat recovery LiBr crystal slurry Hot air Steam
The author acknowledges the support of the New Energy and Industrial Technology Development Organization (NEDO) in Japan for part of this research by the Research and Development Program for Innovative Energy-Efficiency Technology.
- 3.Herold KE, Radermacher R, Klein SA (1996) Adsorption chillers and heat pumps. CRC, Boca RatonGoogle Scholar
- 5.Grossman G, Childs KW (1983) Computer simulation of a lithium bromide-water absorption heat pump for temperature boosting. ASHRAE Trans 89-1:240–248Google Scholar
- 6.Fujii T (2010) Development activities of low temperature waste heat recovery appliances using absorption heat pumps. In: International symposium on next-generation air conditioning and refrigeration technology, Tokyo, 17–19 Feb 2010Google Scholar
- 7.Kawakami Y, Abe Y, Ito K, Marumo K, Aoyama T, Tanino M, Nakaso K, Nakagawa T, Itaya Y, Fukai J (2013) Development of bench-scaled adsorption type steam recovery system for generating high temperature steam from hot waste water. In: 2013 AIChE annual meeting, San Francisco, 3–8 Nov 2013Google Scholar
- 8.Nakaso K, Nakashima K, Tanaka Y, Iwama Y, Fukai J (2013) Study on performance of the novel steam generation system using water-zeolite pair. In: 2013 AIChE annual meeting, San Francisco, 3–8 Nov 2013Google Scholar
- 13.Marumo K, Kobayashi N, Itaya Y (2014) Development of lithium bromide-water absorption heat pump system for simultaneous production of heated-up air and steam from waste heat. In: Tenth international conference on heat transfer, fluid mechanics and thermodynamics (HEFAT2014), Orlando, 14–26 July 2014Google Scholar
- 15.Itaya Y, Marumo K, Masui T, Nagatani K, Takanao S, Kobayashi N (2016) Formation and vapor absorption characteristics of a LiBr crystal fine-particle slurry. J Chem Eng Japan, to be publishedGoogle Scholar
Open Access This chapter is licensed under the terms of the Creative Commons Attribution-NonCommercial 2.5 International License (http://creativecommons.org/licenses/by-nc/2.5/), which permits any noncommercial use, sharing, adaptation, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons license and indicate if changes were made.
The images or other third party material in this chapter are included in the chapter's Creative Commons license, unless indicated otherwise in a credit line to the material. If material is not included in the chapter's Creative Commons license and your intended use is not permitted by statutory regulation or exceeds the permitted use, you will need to obtain permission directly from the copyright holder.