Advertisement

Experimental Evaluation of Magnetostrictive Strain of Electrical Steel

  • António Vieira
  • João Espírito SantoEmail author
  • Cristiano P. Coutinho
  • Sérgio M. O. Tavares
  • Marta Pinto
  • Cassiano C. Linhares
  • Hélder Mendes
Conference paper
Part of the Lecture Notes of the Institute for Computer Sciences, Social Informatics and Telecommunications Engineering book series (LNICST, volume 269)

Abstract

Environmental noise pollution has gained increasing importance, over the past few years. Due to population growth along with a rapid urbanization and the increasing power supply needs, more and more electrical power transformers are set near or inside of urban agglomerations. This fact has generated several complaints regarding the noise produced by this equipment, forcing manufacturers to develop low noise solutions. As it is known, magnetostriction is one of the main sources of electrical machines noise. This research presents an experimental study in which magnetostriction properties of electrical steel are evaluated and analyzed. The magnetic flux density influence on the hysteretic strain behavior of magnetostriction was addressed, as well as the effect of a clamping load on the core joints. This study was addressed by means of an Epstein frame and a data acquisition system, where strain, current and voltage data is obtained and then processed in a data logging software. These measurements gave essential inputs for numerical models which simulate the power transformer core behavior, allowing a faster evaluation of noise mitigation solutions.

Keywords

Magnetostriction Epstein frame Power transformer Noise 

Notes

Acknowledgements

This work is supported by the project POCI-01-0247-FEDER-024035, with the acronym Quiet Transformer 2, co-funded by the European Regional Development Fund (ERDF) through COMPETE2020 - Programa Operacional de Competitividade e Internacionalização (POCI) under the “Portugal 2020” Programme.

References

  1. 1.
    Anderson, P., Moses, A., Stanbury, H.: An automated system for the measurement of magnetostriction in electrical steel sheet under applied stress. J. Magn. Magn. Mater. 215, 714–716 (2000)CrossRefGoogle Scholar
  2. 2.
    Belahcen, A.: Magnetoelasticity, Magnetic Forces and Magnetostriction in Electrical Machines. Ph.D. thesis, Helsinki University of Technology (2004)Google Scholar
  3. 3.
    Braña, L.F., Campelo, H.M., López-Fernández, X.M.: Quiet transformers: design issues. In: Advanced Research Workshop on Transformers (ARWtr) (2013)Google Scholar
  4. 4.
    European Comission: Special Eurobarometer 468: Attitudes of European citizens towards the environment, November 2017Google Scholar
  5. 5.
    Foster, S.L., Reiplinger, E.: Charcteristics and control of transformer sound. IEEE Trans. Power Appar. Syst. PAS–100(3), 1072–1077 (1981)CrossRefGoogle Scholar
  6. 6.
    Ghalamestani, S.G.: Magnetostriction in electrical steel: numerical modelling and development of an optical measurement method. Ph.D. thesis, Ghent University (2013)Google Scholar
  7. 7.
    Girgis, R.S., Bernesjo, M., Anger, J.: Comprehensive analysis of load noise of power transformers. In: Power & Energy Society General Meeting, PES 2009, pp. 1–7. IEEE (2009)Google Scholar
  8. 8.
    IEC/60404-2: Methods of measurement of the magnetic properties of electrical steel strip and sheet by means of an epstein frame, June 2008Google Scholar
  9. 9.
    IEC/TR-62581: Electrical steel-methods of measurements of the magnetostriction characteristics by means of single sheet and epstein test specimens. Technical report, International Electrotechnical Commission (2010)Google Scholar
  10. 10.
    Javorski, M., Čepon, G., Slavič, J., Boltežar, M.: A generalized magnetostrictive-forces approach to the computation of the magnetostriction-induced vibration of laminated steel structures. IEEE Trans. Magn. 49, 5446–5453 (2013)CrossRefGoogle Scholar
  11. 11.
    Javorski, M., Slavič, J., Boltežar, M.: Frequency characteristics of magnetostriction in electrical steel related to the structural vibrations. IEEE Trans. Magn. 48, 4727–4734 (2012)CrossRefGoogle Scholar
  12. 12.
    Kaltenbacher, M., Volk, A., Ertl, M.: Anisotropic model for the numerical computation of magnetostriction in grain-oriented electrical steel sheets. COMPEL - Int. J. Comput. Math. Electr. Electron. Eng. 32(5), 1620–1630 (2013)CrossRefGoogle Scholar
  13. 13.
    Kis, P., Kuczmann, M., Füzi, J., Iványi, A.: Hysteresis measurement in labview. Physica B: Condens. Matter 343, 357–363 (2004)CrossRefGoogle Scholar
  14. 14.
    Klimczyk, P.: Novel techniques for characterisation and control of magnetostriction in GOSS. Ph.D. thesis, Cardiff University (2012)Google Scholar
  15. 15.
    Kulkarni, S.V., Khaparde, S.: Transformer Engineering: Design, Technology, and Diagnostics. CRC Press, Boca Raton (2013)Google Scholar

Copyright information

© ICST Institute for Computer Sciences, Social Informatics and Telecommunications Engineering 2019

Authors and Affiliations

  • António Vieira
    • 1
  • João Espírito Santo
    • 1
    Email author
  • Cristiano P. Coutinho
    • 1
  • Sérgio M. O. Tavares
    • 1
  • Marta Pinto
    • 1
  • Cassiano C. Linhares
    • 1
  • Hélder Mendes
    • 1
  1. 1.Efacec Energia, Máquinas e Equipamentos Eléctricos, S.A.PortoPortugal

Personalised recommendations