Alternative proposals for reducing substrate noise

  • Xavier Aragonès
  • José Luis González
  • Antonio Rubio
Chapter

Abstract

The focus up to now has been on studying guard rings and substrate bias optimization for reducing noise. We will now analyze the viability of three alternative measures for reducing noise, which may not be advisable for general use due to their cost or drawbacks, but which may be useful in particular cases. First, the use of buried layer in providing a noise return path will be examined. The conditions necessary for maximum efficacy, and the increase in process complexity will be evaluated. Next, we will consider the possibility of producing complementary peaks so they cancel each other out. This technique involves duplicating some circuits — adding dummy circuitry- but even so it would be advisable in the event of noise being produced by a few localized elements. Lastly, we study the viability of using active guards. The technique is similar to the canceling method, but in this case noisy elements are not duplicated, adding instead a circuit which senses noise and creates compensating noise, thus annulling the first one, for instance through negative feedback.

Keywords

Noise Reduction Supply Line Noise Cancellation Alternative Proposal Substrate Noise 
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

References

  1. [1]
    BiCMOS Technology and Applications, 2nd edition, A. R. Alvarez editor, Kluwer Academic Publishers, 1993.Google Scholar
  2. [2]
    M. Zuffada, R. Alini, M. Demicheli, M. Gregori, D. Moloney, S. Portulan, F. Sacchi, S.O. Arf, V. Condito, R. Castello, “A Single-Chip 9–32 Mb/s Read/Write Channel for Disk-Drive Applications”, IEEE J. Solid-State Circuits, vol. 30, no. 6, pp. 650–659, June 1995.CrossRefGoogle Scholar
  3. [3]
    Atlas of IC Technologies: An Introduction to VLSI Processes, W. Maly, The Benjamin/Cummings Publishing Company, 1987.Google Scholar
  4. [4]
    R. Senthinathan, J.L. Prince, “Application Specific CMOS Output Driver Circuit Design Techniques to Reduce Simultaneous Switching Noise”, IEEE J. Solid-State Circuits, vol. 28, no. 12, pp. 1383–1388, December 1993.CrossRefGoogle Scholar
  5. [5]
    T. Sekiguchi, M. Horiguchi, T. Sakata, Y. Nakagome, S. Ueda, M. Aoki, “Low-Noise, High-Speed Data Transmission Using a Ringing-Canceling Output Buffer”, IEEE J. Solid-State Circuits, vol. 30, no. 12, pp. 1569–11574, December 1995.CrossRefGoogle Scholar
  6. [6]
    K. Makie-Fukuda, S. Maeda, T. Tsukada, T. Matsuura, “Substrate Noise Reduction Using Active Guard Band Filters in Mixed-Signal Integrated Circuits”, Symposium on VLSI Circuits Digest of Technical Papers, pp 33–34, 1995.Google Scholar

Copyright information

© Springer Science+Business Media New York 1999

Authors and Affiliations

  • Xavier Aragonès
    • 1
  • José Luis González
    • 1
  • Antonio Rubio
    • 1
  1. 1.Universitat Politècnica de Catalunya (UPC)Spain

Personalised recommendations