Advertisement

Performance of a Copper-Clad Nb-40%Ti in a High-Current-Density 50-kG Superconducting Solenoid

  • A. El Bindari
  • R. E. Bernert
  • L. O. Hoppie
Conference paper
Part of the Advances in Cryogenic Engineering book series (ACRE, volume 13)

Abstract

Coffey et al. [1] reported the operation of a 100-kG superconducting solenoid using Nb-Zr and Nb-Ti superconducting wire. The Nb-Zr was used in the outer section of the coil, while Nb-Ti wire was used in the inside section. Since then, some of the attempts to use Nb-Ti wire have not been successful, The reason became apparent when it was discovered that Nb-Ti wire was supplied in a heat-treated condition with a thin copper coating. As with Nh-Zr, a heat treatment of the materials will increase the current carrying capacity, but at the same time will lead to instabilities which make them unsuitable for particular applications unless they are fully stabilized [2]. This paper reports on the stabilization of Nb-Ti superconducting wire, its heat treatment and its use in an operating coil.

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

References

  1. 1.
    H. T. Coffey, J. K. Hulm, W. T. Reynolds, D. K. Fox, and R. E. Span, J. Appl. Phys., 36:128 (1965).CrossRefGoogle Scholar
  2. 2.
    A. R. Kantrowitz and Z. J. J. Stekly, Appl. Phys, Letters, 6:56 (1965).CrossRefGoogle Scholar
  3. 3.
    A. El Bindari and E. D. Hoag, Bull Am. Phys. Soc., Series II, 10:60 (1966).Google Scholar
  4. 4.
    E. G. Brentari, P. G. Giarratano, and R. V. Smith, N.B.S. Tech. Note No. 317 (Sept. 1965), p. 5.Google Scholar

Copyright information

© Springer Science+Business Media New York 1995

Authors and Affiliations

  • A. El Bindari
    • 1
  • R. E. Bernert
    • 1
  • L. O. Hoppie
    • 1
  1. 1.Avco Everett Research LaboratoryEverettUSA

Personalised recommendations