Abstract
The performance degradation of proton exchange membrane or polymer electrolyte membrane fuel cell (PEMFC) stems from air starvation and water flooding. In the mathematical modeling, the conservation equations were applied for momentum, mass, species, charge, and energy, to investigate the heat transfer and temperature distribution in the cathode along with the multiphase and multi-species transport under the steady-state condition. This model shows the effect of stoichiometry of reactants and relative humidity on the water saturation. The back-diffusion of water from the cathode to the anode is considered to reduce possible flooding. The feedback controls are used to address the transient water, pressure, and temperature management problems of a PEMFC system. An anode recirculation system measures the feedback signals to regulate the anode and cathode humidities and the pressure difference between the anode and cathode compartments. It was found that the robust nonlinear controller is insensitive to parametric uncertainty, maintaining performance around any equilibrium point.
Author Contributions
Zhaohui Wang is solely responsible for this review on the modeling analysis of the PEM fuel cell.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
References
M. Schultze, J. Horn, Modeling, state estimation and nonlinear model predictive control of cathode exhaust gas mass flow for PEM fuel cells. Control. Eng. Pract. 49, 76–86 (2016)
R.T. Meyer, B. Yao, Modeling and simulation of a modern PEM fuel cell system, in ASME 2006 4th International Conference on Fuel Cell Science, Engineering and Technology (American Society of Mechanical Engineers, 2006), pp. 133–150
A.Y. Karnik, J. Sun, A.G. Stefanopoulou, J.H. Buckland, Humidity and pressure regulation in a PEM fuel cell using a gain-scheduled static feedback controller. IEEE Trans. Control Syst Technol 17(2), 283–297 (2009)
Peraza, C., Diaz, J. G., Arteaga-Bravo, F. J., Villanueva, C., Francisco Gonzalez-Longatt, F., Modeling and simulation of PEM fuel cell with bond graph and 20sim, in American Control Conference (2008), pp. 5104–5108
R. Urbanczyk, S. Peil, D. Bathen, C. Heßke, J. Burfeind, K. Hauschild, M. Felderhoff, F. Schüth, HT-PEM fuel cell system with integrated complex metal hydride storage tank. Fuel Cells 11(6), 911–920 (2011)
Y.B. Kim, Study on the effect of humidity and stoichiometry on the water saturation of PEM fuel cells. Int. J. Energy Res. 36, 509–522 (2012)
Z. Shi, X. Wang (2008). Two-dimensional PEM fuel cells modeling using COMSOL Multiphysics, in Modelling and Simulation, ed. by G. Petrone, G. Cammarata, pp. 677–688. Retrieved from: http://www.intechopen.com/books/modelling_ and_simulation/twodimensional_pem_fuel_cells_modeling_using_comsol_multiphysics
E. Robalinho, Z. Ahmed, E. Cekinski, M. Linardi, Advances in PEM fuel cells with CFD techniques, in Proceedings of the 5th International Workshop on Hydrogen and Fuel Cells (2010)
C. Siegel, G. Bandlamudi, A. Heinzel, Systematic characterization of a PBI/H 3 PO 4 sol–gel membrane–modeling and simulation. J. Power Sources 196(5), 2735–2749 (2011)
T. Sousa, M. Mamlouk, K. Scott, An isothermal model of a laboratory intermediate temperature fuel cell using PBI doped phosphoric acid membranes. Chem. Eng. Sci. 65(8), 2513–2530 (2010)
K. Klinedinst, J.A.S. Bett, J. Macdonald, P. Stonehart, Oxygen solubility and diffusivity in hot concentrated H3PO4. J. Electroanal. Chem. Interfacial Electrochem. 57(3), 281–289 (1974)
A.A. Kulikovsky, H.F. Oetjen, C. Wannek, A simple and accurate method for high-temperature PEM fuel cell characterization. Fuel Cells 10(3), 363–368 (2010)
N. Zamel, X. Li, Non-isothermal multi-phase modeling of PEM fuel cell cathode. Int. J. Energy Res. 34, 568–584 (2010)
E.L. Cussler, Diffusion-Mass Transfer in Fluid Systems (Cambridge University Press, London, 1969)
T. Henriques, B. César, P.C. Branco, Increasing the efficiency of a portable PEM fuel cell by altering the cathode channel geometry: a numerical and experimental study. Appl. Energy 87(4), 1400–1409 (2010)
H. Wu, X. Li, P. Berg, Numerical analysis of dynamic processes in fully humidified PEM fuel cells. Int. J. Hydrog. Energy 32(12), 2022–2031 (2007)
I. Matraji, S. Laghrouche, M. Wack, Pressure control in a PEM fuel cell via second order sliding mode. Int. J. Hydrog. Energy 37(21), 16104–16116 (2012)
Z. Shi, X. Wang, Comparison of Darcy’s law, the Brinkman equation, the modified NS equation and the pure diffusion equation in PEM fuel cell modeling, in COMSOL Conference, (2007)
N. Zamel, X. Li, A parametric study of multi-phase and multi-species transport in the cathode of PEM fuel cells. Int. J. Energy Res. 32, 698–721 (2008)
R.K. Shah, A.L. London, Laminar Flow Forced Convection in Ducts (Academic, New York, 1978)
P.C. Chen, The dynamics analysis and controller design for the PEM fuel cell under gas flow rate constraints. Int. J. Hydrog. Energy 36, 3110–3122 (2011)
P.C. Chen, Output-feedback voltage tracking control for input-constrained PEM fuel cell systems. Int. J. Hydrog. Energy 36(22), 14608–14621 (2011)
J. Liu, W. Lin, F. Alsaadi, T. Hayat, Nonlinear observer design for PEM fuel cell power systems via second order sliding mode technique. Neurocomputing 168, 145–151 (2015)
A.J. Real, A. Arce, C. Bordons, Development and experimental validation of a PEM fuel cell dynamic model. J. Power Sources 173, 310–324 (2007)
D. Li, C. Li, Z. Gao, Q. Jin, On active disturbance rejection in temperature regulation of the proton exchange membrane fuel cells. J. Power Sources 283, 452–463 (2015)
I.S. Hussaini, C.Y. Wang, Dynamic water management of polymer electrolyte membrane fuel cells using intermittent RH control. J. Power Sources 195(12), 3822–3829 (2010)
M. Coppo, N.P. Siegel, M.R. Spakovsky, On the influence of temperature on PEM fuel cell operation. J. Power Sources 159(1), 560–569 (2006)
M. Cai, M.S. Ruthkosky, B. Merzougui, S. Swathirajan, M.P. Balogh, S.H. Oh, Investigation of thermal and electrochemical degradation of fuel cell catalysts. J. Power Sources 160(2), 977–986 (2006)
Z. Lua, S.G. Kandlikara, C. Ratha, M. Grimma, W. Domigana, A.D. Whitea, M. Hardbargera, J.P. Owejanb, T.A. Traboldb, Water management studies in PEM fuel cells, part II: Ex situ investigation of flow maldistribution, pressure drop and two-phase flow pattern in gas channels. Int. J. Hydrog. Energy 34, 3445–3456 (2009)
P. Concus, R. Finn, On the behavior of a capillary surface in a wedge. Appl. Math. Sci. 63, 292–299 (1969)
R.W. Lockhart, R.C. Martinelli, Proposed correlation of data for isothermal two-phase, two-component flow in pipes. Chem. Eng. Prog. 45, 39–48 (1949)
C. Lee, W. Mérida, Gas diffusion layer durability under steady-state and freezing conditions. J. Power Sources 164, 141–153 (2007)
W.K. Lee, C.H. Ho, J.W.V. Zee, M. Murthy, The effects of compression and gas diffusion layers on the performance of a PEM fuel cell. J. Power Sources 84, 45–51 (1999)
I. Nitta, O. Himanen, M. Mikkola, Thermal conductivity and contact resistance of compressed gas diffusion layer of PEM fuel cell. Fuel Cells 8(2), 111–119 (2008)
F. Barbir, PEM Fuel Cells Theory and Practice (Academic Press, 2012)
V. Gurau, H. Liu, S. Kakac, A two-dimensional model for proton exchange membrane fuel cells. AIChE J. 44(11), 2410–2422 (1998)
Acknowledgment
The author thanks Dr. Jingbo Liu and Dr. Bashir for their support and encouragement to finish this review chapter.
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2018 Springer-Verlag GmbH Germany, part of Springer Nature
About this chapter
Cite this chapter
Wang, Z. (2018). Modeling Analysis for Species, Pressure, and Temperature Regulation in Proton Exchange Membrane Fuel Cells. In: Li, F., Bashir, S., Liu, J. (eds) Nanostructured Materials for Next-Generation Energy Storage and Conversion. Springer, Berlin, Heidelberg. https://doi.org/10.1007/978-3-662-56364-9_9
Download citation
DOI: https://doi.org/10.1007/978-3-662-56364-9_9
Published:
Publisher Name: Springer, Berlin, Heidelberg
Print ISBN: 978-3-662-56363-2
Online ISBN: 978-3-662-56364-9
eBook Packages: Chemistry and Materials ScienceChemistry and Material Science (R0)