Abstract
A theory of plastic bending of single crystal beam with two active slip systems accounting for continuously distributed excess dislocations is proposed. If the resistance to dislocation motion is negligibly small, then excess dislocations pile up against the beam’s neutral line, leaving two small layers near the lateral faces dislocation-free. The threshold value at the onset of plastic yielding, the dislocation density, as well as the moment-curvature curve are found. If the energy dissipation is taken into account, excess dislocations at the beginning of plastic yielding occupy two thin layers, leaving the zone near the middle line as well as two layers near the beam’s lateral faces dislocation-free. The threshold bending moment at the dislocation nucleation and the hardening rate are higher than those in the case of zero dissipation.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
Preview
Unable to display preview. Download preview PDF.
References
Ashby MF (1970) The deformation of plastically non-homogeneous materials. The Philosophical Magazine: A Journal of Theoretical Experimental and Applied Physics 21(170):399–424
Berdichevsky VL (1983) Variational Principles of Continuum Mechanics (in Russ.). Nauka, Moscow
Berdichevsky VL (2006a) Continuum theory of dislocations revisited. Continuum Mechanics and Thermodynamics 18(3):195–222
Berdichevsky VL (2006b) On thermodynamics of crystal plasticity. Scripta Materialia 54(5):711–716
Berdichevsky VL, Le KC (2007) Dislocation nucleation and work hardening in anti-plane constrained shear. Continuum Mechanics and Thermodynamics 18(7):455–467
Bilby BA (1955) Types of dislocation source. In: Defects in crystalline solids. Report of 1954 Bristol conference, The Physical Society, London, pp 123–133
Bilby BA, Gardner LRT, Smith E (1958) The relation between dislocation density and stress. Acta Metallurgica 6(1):29–33
Cleveringa HHM, van der Giessen E, Needleman A (1999) A discrete dislocation analysis of bending. International Journal of Plasticity 15(8):837–868
Evans JT (1995) Bending produced by dislocations in a beam. International Journal of Engineering Science 33:1321–1329
Gurtin ME (2002) A gradient theory of single-crystal viscoplasticity that accounts for geometrically necessary dislocations. Journal of the Mechanics and Physics of Solids 50(1):5–32
Gurtin ME, Anand L, Lele SP (2007) Gradient single-crystal plasticity with free energy dependent on dislocation densities. Journal of the Mechanics and Physics of Solids 55(9):1853–1878
Kaluza M, Le KC (2011) On torsion of a single crystal rod. International Journal of Plasticity 27(3):460–469
Kochmann DM, Le KC (2008) Dislocation pile-ups in bicrystals within continuum dislocation theory. International Journal of Plasticity 24(11):2125–2147
Kochmann DM, Le KC (2009a) A continuum model for initiation and evolution of deformation twinning. Journal of the Mechanics and Physics of Solids 57(6):987–1002
Kochmann DM, Le KC (2009b) Plastic deformation of bicrystals within continuum dislocation theory. Mathematics and Mechanics of Solids 14(6):540–563
Kröner E (1955) Der fundamentale Zusammenhang zwischen Versetzungsdichte und Spannungsfunktionen. Zeitschrift für Physik 142(4):463–475
Kysar JW, Saito Y, Oztop MS, Lee D, Huh WT (2010) Experimental lower bounds on geometrically necessary dislocation density. International Journal of Plasticity 26(8):1097–1123
Le KC (1999) Vibrations of Shells and Rods. Springer, Berlin
Le KC, Nguyen BD (2012) Polygonization: Theory and comparison with experiments. International Journal of Engineering Science 59:211–218
Le KC, Nguyen BD (2013) On bending of single crystal beam with continuously distributed dislocations. International Journal of Plasticity 48:152–167
Le KC, Nguyen QS (2010) Polygonization as low energy dislocation structure. Continuum Mechanics and Thermodynamics 22(4):291–298
Le KC, Sembiring P (2008a) Analytical solution of plane constrained shear problem for single crystals within continuum dislocation theory. Archive of Applied Mechanics 78(8):587–597
Le KC, Sembiring P (2008b) Plane constrained shear of single crystal strip with two active slip systems. Journal of the Mechanics and Physics of Solids 56(8):2541–2554
Le KC, Sembiring P (2009) Plane constrained uniaxial extension of a single crystal strip. International Journal of Plasticity 25(10):1950–1969
Maugin GA (1990) Infernal variables and dissipative structures. Journal of Non-Equilibrium Thermodynamics 15(2):173–192
Maugin GA (1992) The Thermomechanics of Plasticity and Fracture, Cambridge Texts in Applied Mathematics, vol 7. Cambridge University Press, Cambridge
Motz C, Weygand D, Senger J, Gumbsch P (2008) Micro-bending tests: A comparison between three-dimensional discrete dislocation dynamics simulations and experiments. Acta Materialia 56(9):1942–1955
Mura T (1987) Micromechanics of Defects in Solids. Kluwer Academic Publishers, Oxford
Nye JF (1953) Some geometrical relations in dislocated crystals. Acta Metallurgica 1(2):153–162
Ortiz M, Repetto EA (1999) Nonconvex energy minimization and dislocation structures in ductile single crystals. Journal of the Mechanics and Physics of Solids 47(2):397–462
Read WT (1957) Dislocation theory of plastic bending. Acta Metallurgica 5(2):83–88
Sandfeld S, Hochrainer T, Gumbsch P, Zaiser M (2010) Numerical implementation of a 3D continuum theory of dislocation dynamics and application to micro-bending. Philosophical Magazine 90(27–28):3697–3728
Sedov LI (1965) Mathematical methods of constructing models of continuum media (in Russ.). Usp Matem Nauk 20:123–182
Wang W, Huang Y, Hsia KJ, Hu KX, Chandra A (2003) A study of microbend test by strain gradient plasticity. International Journal of Plasticity 19(3):365–382
Acknowledgements
The financial support by the German Science Foundation (DFG) through the research project LE 1216/4-2 is gratefully acknowledged.
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2018 Springer International Publishing AG, part of Springer Nature
About this chapter
Cite this chapter
Cui, X., Le, K.C. (2018). A Single Crystal Beam Bent in Double Slip. In: Altenbach, H., Pouget, J., Rousseau, M., Collet, B., Michelitsch, T. (eds) Generalized Models and Non-classical Approaches in Complex Materials 1. Advanced Structured Materials, vol 89. Springer, Cham. https://doi.org/10.1007/978-3-319-72440-9_11
Download citation
DOI: https://doi.org/10.1007/978-3-319-72440-9_11
Published:
Publisher Name: Springer, Cham
Print ISBN: 978-3-319-72439-3
Online ISBN: 978-3-319-72440-9
eBook Packages: EngineeringEngineering (R0)