Producing Parts of Uniform Thickness from Sheet of Variable Thickness


The shaping of axisymmetric parts of uniform thickness such as caps from sheet of variable thickness is considered.

This is a preview of subscription content, log in to check access.

Fig. 1.
Fig. 2.
Fig. 3.
Fig. 4.
Fig. 5.
Fig. 6.


  1. 1

    Chumadin, A.S., Improvement of pipe distribution process, Kuznechno-Shtampovochnoe Proizvod., 1990, no. 8, pp. 29–30.

  2. 2

    Baburin, M.A., Baskakov, V.D., Tarasov, V.A., and Zarubina, O.V., The evaluation of the maximum degree hood of cylindrical parts from the disk blanks with variable thickness, Kuznechno-Shtampovochnoe Proizvod.–Obrab. Mater. Davleniem, 2015, no. 1, pp. 3–6.

  3. 3

    Greditor, M.A., Davitel’nye raboty i rotatsionnoe vydavlivanie (Pressing and Rotary Extrusion), Moscow: Mashinostroenie, 1971.

  4. 4

    Popov, O.V., Izgotovlenie tsel’noshtampovannykh tonkostennykh detalei peremennogo secheniya (Production of Whole-Presses Thin-Wall Parts with Variable Section), Moscow: Mashinostroenie, 1974.

  5. 5

    Titlyanov, A.E. and Radyuk, A.G., Calculation of sheet blank thickness for axisymmetric molding, Izv. Vyssh. Uchebn. Zaved., Chern. Metall., 1968, no. 11, pp. 154–155.

  6. 6

    Chumadin, A.S. and Ershov, V.I., Axisymmetric molding of bottom-like parts from sheet material, Izv. Vyssh. Uchebn. Zaved., Aviats. Tekh., 1988, no. 3, pp. 56–60.

  7. 7

    Chumadin, A.S., Teoriya i raschety protsessov listovoi shtampovki (dlya inzhenerov) (Theory and Calculations of Sheet Pressing: For Engineers), Moscow: Mosk. Aviats. Tekhnol. Inst., 2014.

Download references

Author information



Corresponding authors

Correspondence to A. S. Chumadin or E. S. Shemonaeva.

Additional information

Translated by B. Gilbert

About this article

Verify currency and authenticity via CrossMark

Cite this article

Chumadin, A.S., Shemonaeva, E.S. Producing Parts of Uniform Thickness from Sheet of Variable Thickness. Russ. Engin. Res. 40, 522–525 (2020).

Download citation


  • sheet stamping
  • shaping
  • workpiece thickness