Advertisement

Russian Engineering Research

, Volume 39, Issue 3, pp 237–241 | Cite as

Tools with Redesigned Cutting Inserts for Intermittent Cutting

  • E. A. KudryashovEmail author
  • I. M. Smirnov
  • N. A. Khizhnyak
Article

Abstract—The design of cutting inserts for tools used in intermittent turning is considered. As an example, it is established that a cycloid front surface of the insert is required to improve the distribution of the impact load when turning a helical rotor surface.

Keywords:

intermittent turning continuous cutter indexable inserts complex cutting inserts durability 

Notes

REFERENCES

  1. 1.
    Andreev, V.N., Borovskii, G.V., Borovskii, V.G., and Grigor’ev, S.N., Instrument dlya vysokoproizvoditel’nogo i ekologicheski chistogo rezaniya (Tools for High-Performance and Environmentally Friendly Cutting), Moscow: Mashinostroenie, 2010.Google Scholar
  2. 2.
    Özel, T., Modeling of hard part machining: effect of insert edge preparation in CBN cutting tools, J. Mater. Process. Technol., 2003, vol. 141, no. 2, pp. 284–293.CrossRefGoogle Scholar
  3. 3.
    Dogra, M., Sharma, V., Sachdeva, A., and Suri, N., Tool wear, chip formation and workpiece surface issues in CBN hard turning: a review, Int. J. Precis. Eng. Manuf., 2010, vol. 11, no. 2, pp. 341–358.CrossRefGoogle Scholar
  4. 4.
    Ståhl, J.E., Metal Cutting. Theories and Models, Lund: SECO TOOLS, 2012.Google Scholar
  5. 5.
    Zhou, J., Mechanical Load Identification for Spontaneous Tool Failure Monitoring, Lund: Lund Univ., 1996.Google Scholar
  6. 6.
    Kudryashov, E.A., Smirnov, I.M., Yatsun, E.I., and Pavlov, E.V., Improved tools for the turning of complex surfaces, Russ. Eng. Res., 2018, vol. 38, no. 3, pp. 223–228.CrossRefGoogle Scholar
  7. 7.
    Kudryashov, E.A. and Smirnov, I.M., Creating rational conditions for turning surfaces of dissimilar structural materials by brittle superhard cutters, Izv. Vyssh. Uchebn. Zaved., Mashinostr., 2018, no. 2 (695), pp. 75–85.Google Scholar
  8. 8.
    Kudryashov, E.A., Smirnov, I.M., and Khizhnyak, N.A., Turning surface assembly units consisting of combinations of dissimilar materials, Vestn. Mosk. Gos. Tekh. Univ., Stankin, 2017, no. 3 (42), pp. 48–51.Google Scholar

Copyright information

© Allerton Press, Inc. 2019

Authors and Affiliations

  • E. A. Kudryashov
    • 1
    Email author
  • I. M. Smirnov
    • 1
  • N. A. Khizhnyak
    • 1
  1. 1.AO Scientific-Research Engineering InstituteBalashikhaRussia

Personalised recommendations