Advertisement

Steel in Translation

, Volume 49, Issue 7, pp 454–459 | Cite as

Origins and Behavior of Dioxins and Furans in Zinc-Bearing Dust

  • L. M. Simonyan
  • N. V. DemidovaEmail author
Article
  • 13 Downloads

Abstract

The use of zinc-bearing (galvanized) scrap as a batch component in electrosmelting produces dust from which nonferrous metals may be extracted. However, the behavior of chlorine and its components in electrosmelting dust containing zinc and lead has not been adequately studied. Research shows that chlorine and its compounds in electrosmelting batch and hence in the arc-furnace emissions must be regarded as a hazard because they form highly toxic organic compounds: dioxins and furans. They are released to the atmosphere not only as gas but also as in adsorbed form on the surface of the dust particles. According to the available data, their concentration is 5–500 ng/kg of dust, depending on the smelting parameters. The formation of dioxins and furans in arc furnaces is analyzed, as well as their behavior in captured dust. With 1.3% chlorine in electrosmelting dust, 99.9% forms relatively safe compounds—mainly chlorides—but the remainder forms dioxins and furans. The quantity of dioxins and furans adsorbed on the surface of dust particles is 474 ng/kg of dust. Dioxins and furans are powerful environmental toxins (first hazard class) and therefore raise the hazard status of the dust from the fourth to the third class (or higher). That must be taken into account in handling the dust. In addition, the dioxins and furans are transported to the environment by dust particles, onto which the chemicals are sorbed. Therefore, electrosmelting dust whose surface contains adsorbed dioxins and furans may carry these toxic materials into living organisms. Means of decreasing dioxin and furan emissions in electrosteel production are considered. Methods of dust processing characterized by low environmental impact and resource conservation are also discussed. In particular, the possibility of using milk of lime to irrigate the exhaust gases from the arc furnace is analyzed. This method is found to lower the content of dioxins and furans to acceptable levels. The effectiveness of the proposed methods is assessed.

Keywords:

electrosmelting dust arc furnaces galvanized scrap zinc-bearing dust dust processing chlorine dioxins furans metal chlorides adsorption environmental impact 

Notes

ACKNOWLEDGMENTS

Financial support for this research was provided by the Fund for Innovative Activity, as part of the UMNIK program for the encouragement of young scientists (contract no. 12699GU/2017).

REFERENCES

  1. 1.
    Osnovnye pokazateli okhrany okruzhayushchei sredy, 2017: Statisticheskii sbornik (General Indicators of Environmental Protection, 2017: Statistical Handbook), Moscow: Rosstat, 2017.Google Scholar
  2. 2.
    Promyshlennoe proizvodstvo v Rossii, 2016: Statisticheskii sbornik (Industrial Production in Russia, 2016: Statistical Handbook), Moscow: Rosstat, 2016.Google Scholar
  3. 3.
    Pan’shin, A.M., Leont’ev, L.I., Kozlov, P.A., et al., Processing technology of EAF-dust from JSC Severstal in Welz-complex of JSC Chelyabinsk zinc plant, Ekol. Prom. Ross., 2012, no. 11, pp. 4–6.Google Scholar
  4. 4.
    Stovpchenko, A.P. and Kamkina, L.V., Processes of EAF-dust recycling, Part 2. Industrial processes of dust processing in medium power units, Elektrometallurgiya, 2010, no. 2, pp. 42–43.Google Scholar
  5. 5.
    Zunkel, D., What to do with your EAF dust, Steel Times Int., 1996, no. 7, pp. 46, 48–50.Google Scholar
  6. 6.
    Pickles, C.A., Thermodynamic analysis of the selective chlorination of electric arc furnace dust, J. Hazard. Mater., 2009, vol. 166, nos. 2–3, pp. 1030–1042.CrossRefGoogle Scholar
  7. 7.
    de Buzin, P.J.W.K., Heck, N.C., and Vilela, A.C.F., EAF dust: An overview on the influences of physical, chemical and mineral features in its recycling and waste incorporation routes, J. Mater. Res. Technol., 2017, vol. 6, no. 2, pp. 194–202.CrossRefGoogle Scholar
  8. 8.
    Lohmann, R., Lee, R.G.M., Green, N.J.L., and Jones, K.C., Gas-particle partitioning of PCDD/Fs in daily air samples, Atmos. Environ., 2000, vol. 34, no. 16, pp. 2529–2537.CrossRefGoogle Scholar
  9. 9.
    Mukherjee, A., Debnath, B., and Sadhan Kumar Ghosh, A review on technologies of removal of dioxins and furans from incinerator flue gas, Procedia Environ. Sci., 2016, vol. 35, pp. 528–540.CrossRefGoogle Scholar
  10. 10.
    Freeman, R.A., Hileman, F.D., Noble, R.W., and Schroy, J.M., Experiments on the mobility of 2,3,7,8-tetrachlorodibenzo-p-dioxin at Times Beach, Missouri, in Solving Hazardous Waste Problems, ACS Symposium Series no. 338, Exner, J.H., Ed., Washington, 1987, ch. 9.Google Scholar
  11. 11.
    Puri, R.K., Clevenger, R.K., Kapila, S., Yanders, A.F., and Malhotra, A.F., Studies of parameters affecting translocation of tetrachlorodibenzo-p-dioxin in soil, Chemosphere, 1989, vol. 18, nos. 1–6, pp. 1291–1296.CrossRefGoogle Scholar
  12. 12.
    Puri, R.K., Kapila, S., Lo, Y.H., Orazio, C., Clevenger, T.E., and Yanders, A.F., Effect of co-contaminants on the disposition of polychlorinated dibenzofurans in saturated soils, Chemosphere, 1990, vol. 20, nos. 10–12, pp. 1589–1596.CrossRefGoogle Scholar
  13. 13.
    Rezaei, E., Farahani, A., Buekens, A., Chen, T., Lu, S.Y., Habibinejad, M., Damercheli, F., Andalib Moghadam, S.H., Gandomkar, M., and Bahmani, A., Dioxins and furans releases in Iranian mineral industries, Chemosphere, 2013, vol. 91, no. 6, pp. 838–843.CrossRefGoogle Scholar
  14. 14.
    Petrosyan, V.S., Dioxins: scarecrow or real threat? Teor. Prikl. Ekol., 2009, no. 1, pp. 41–47.Google Scholar
  15. 15.
    Eskenazi, B., Warner, M., Brambilla, P., Signorini, S., Ames, J., and Mocarelli, P., The Seveso accident: a look at 40 years of health research and beyond, Environ. Int., 2018, vol. 121, pp. 71–84.CrossRefGoogle Scholar
  16. 16.
    Antunes, P., Viana, P., Vinhas, T., Rivera, J., and Gaspar, E.M.S.M., Emission profiles of polychlorinated dibenzodioxins, polychlorinated dibenzofurans (PCDD/Fs), dioxin-like PCBs and hexachlorobenzene (HCB) from secondary metallurgy industries in Portugal, Chemosphere, 2012, vol. 88, no. 11, pp. 1332–1339.CrossRefGoogle Scholar
  17. 17.
    Vehlow, J., Thermische Behandlungsverfahren fuer Hausmuellim Vergleich, Graz: Forschungszentrum Karlsruhe, Inst. Tech. Chem., 1998.Google Scholar
  18. 18.
    Aksel’rod, L.M., Fedosov, I.B., Baranov, A.P., et al., Processing of zinc-containing EAF-dusts at Ural-Recycling company (JSC Magnesite Plant), Materialy IV Mezhdunarodnoi konferentsii “Metallurgiya–INTEKhEKO–2011” (Proc. IV Int. Conf. “Metallurgy–INTEKHEHKO–2011,” Moscow, March 29–30, 2011), Moscow, 2011, pp. 136–139.Google Scholar
  19. 19.
    Lisin, V.S. and Yusfin, Yu.S., Resurso-ekologicheskie problemy XXI veka i metallurgiya (Resource and Environmental Problems of the 21st Century and Metallurgy), Moscow: Vysshaya Shkola, 1998.Google Scholar
  20. 20.
    Exposure and Human Health Reassessment of 2,3,7,8-Tetrachlorodibenzo-p-Dioxin (TCDD) and Related Compounds, Part 1: Estimating Exposure to Dioxin-Like Compounds, Vol. 2: Properties, Environmental Levels, and Background Exposures, Washington, DC: U.S. Environ. Prot. Agency, 2000.Google Scholar
  21. 21.
    Hofstadler, K., Lanzerstorfer, C., and Gebert, W., Dépoussiérage et épuration des fumées des chaînes d’agglomération de minerai par le procédé AIRFINE®, Rev. Met. Paris, 1999, vol. 96, no. 10, pp. 1191–1196.CrossRefGoogle Scholar
  22. 22.
    Elanskii, G.N. and Medvedev, M.N., Environmental danger of dioxins, Stal’, 2000, no. 2, pp. 82–86.Google Scholar
  23. 23.
    Ivanov, A.I., Lyandres, M.B., and Prokof’ev, O.V., Proizvodstvo magniya (Magnesium Production), Moscow: Metallurgiya, 1979.Google Scholar

Copyright information

© Allerton Press, Inc. 2019

Authors and Affiliations

  1. 1.Moscow Institute of Steel and AlloysMoscowRussia

Personalised recommendations