A Novel Experimental Setup to Measure the Changes in Electrical Conductivity of Hydrating Cementitious Materials

Abstract

One of the alternative ways to fabricate shaped bodies from cementious materials would be to press the loose powder of materials (in steel dies, or isostatically) and to infiltrate them with liquids using the natural capillary forces of porous bodies [1,2].

This is a preview of subscription content, access via your institution.

References

  1. 1

    D.M. Roy and G.R. Gouda, Cem. Concr. Res. 3, 807–820 (1973).

    CAS  Article  Google Scholar 

  2. 2

    F.D. Tamas, E. Farkas, M. Voros, and D.M. Roy, Cem. Concr. Res. 17, 340–348 (1987).

    CAS  Article  Google Scholar 

  3. 3.

    M. Perez-Pena, Electrical Conductivity and Dielectric Studies of Hydraulic Cements, Ph.D. Thesis, The Pennsylvania State University, University Park, PA (1986).

  4. 5

    S.J. Glass and D.J. Green, Adv. Ceram. Mater. 2(2), 129–131 (1987).

    CAS  Article  Google Scholar 

  5. 6

    T.M. Shaw, Mater. Res. Soc. Symp. Proc., Vol. 73, 215–223 (1986).

    CAS  Article  Google Scholar 

  6. 7

    M. Murat, A.E.I. Hajjouji, and C. Cornel, Cem. Concr. Res. 17, 633–639 (1987).

    CAS  Article  Google Scholar 

Download references

Author information

Affiliations

Authors

Corresponding author

Correspondence to J. Majling.

Rights and permissions

Reprints and Permissions

About this article

Cite this article

Majling, J., Moses, P., Perez-Pena, M. et al. A Novel Experimental Setup to Measure the Changes in Electrical Conductivity of Hydrating Cementitious Materials. MRS Online Proceedings Library 114, 285 (1987). https://doi.org/10.1557/PROC-114-285

Download citation