Applying Paints with Nitrogen
- 35 Downloads
Companies in some countries already have experience of atomising paints using nitrogen. Tests carried out in one machinery manufacturer’s technical centre have produced very positive results and these have now been reinforced by the successful use of the process in volume production.
Oltrogge has been carrying out detailed studies into the atomisation of paints and other liquids with nitrogen for around two years. The nitrogen is produced from the existing compressed air network using a membrane system. Because of the concentrations and volume at which it is used, it presents no hazards to health. A nitrogen generator can be installed on a plug-and-play basis with very little assembly work needed.
Major benefits in the lab
A number of complex tests of automatic atomisation were carried out in Oltrogge’s technical centre to demonstrate the effects of nitrogen in different concentrations and levels of purity, combined with heat and ionisation, on the results of the painting process. These showed that the amount of materials used can be reduced significantly, regardless of whether solvents, water-based paints, high-solid products or release agents are being applied. The savings ranged between 5% and 45%.
Nitrogen (left) versus compressed air (right): The picture on the left shows the first spraying attempt with the atomiser pressure reduced by half and without fine-tuning the application parameters. The coating applied was around 40% thicker.
Successful implementation in practice
Following on from these findings, the first field tests were carried out in early 2012 with users who require high-quality painted finishes. A number of interesting projects took place which often produced even better results in practice than those achieved during the course of testing.
It repeatedly became clear that, although the reduction in paint consumption is a positive development, the other advantages of the new system were the decisive factor in its introduction. References, in particular from the automotive supply industry, demonstrate the success of the nitrogen application process in volume production.