T-ARMS PCR genotyping of SNP rs445709131 using thermostable strand displacement polymerase
- 573 Downloads
In a recent publication, we reported the successful use of tetra primer-amplification refractory mutation system based polymerase chain reaction (T-ARMS-PCR) for genotyping of rs445709131-SNP responsible for the bovine leukocyte adhesion deficiency (BLAD) in cattle. The SNP is characterized by higher GC content of the surrounding region, hence, the previous protocol utilized dimethyl sulfoxide as PCR enhancer. Here, the reaction cocktail was modified with the use of thermostable strand displacement polymerase (SD polymerase) instead of commonly used Taq DNA Polymerase. The amplification efficiency, reaction sensitivity, specificity, and need of PCR enhancer in reactions containing SD polymerase and Taq polymerase were compared.
T-ARMS-PCR assay is influenced by multiple factors for the correct genotyping necessitating extensive optimization at the initial stages. The described modification enabled generation of all amplicons by 25 cycles whereas the assay with Taq polymerase needed a minimum of 35 cycles. The modified assay amplified all amplicons at a wider range of annealing temperature (50–60 °C), without the addition of dimethyl sulfoxide. The replacement of Taq polymerase with SD polymerase may be beneficial in the T-ARMS assay for development of user-friendly, faster assay which is less affected by the reaction and cyclic conditions.
KeywordsT-ARMS PCR BLAD SD polymerase Taq DNA polymerase SNP analysis
- T-ARMS PCR
tetra primer-amplification refractory mutation system-PCR
- SD Pol
strand displacement polymerase
high-resolution melting analysis
single strand conformation polymorphism
primer induced restriction analysis-PCR
bovine leukocyte adhesion deficiency
In spite of the potential use of T-ARMS PCR in faster, economical, and precise genotyping, the need for extensive standardization at the initial stages hampered its wide application [6, 11]. Also, some sequences  and the GC-rich regions are least accessible to this methodology . Identifying the potential of this technology and recognizing its pitfalls, Mesrian Tanha and co-workers  modified the outer primers to equalize the primer strengths and included an additional parameter of equal annealing temperature of specific fragments. The use of chimeric primer-based temperature switch PCR (TSP) strategy with T-ARMS primers enabled multiplexing of T-ARMS PCR .
Taq DNA polymerase is commonly used in T-ARMS PCR genotyping. The properties of SD polymerase and Taq polymerase are different and influence the T-ARMS PCR differently (Fig. 1a). The Taq DNA polymerase, used in the classical T-ARMS PCR, has 5′–3′ polymerase as well as 5′–3′ exonuclease activity. This 5′–3′ exonuclease activity could degrade the annealed IF and IR primers similar to the 5′ Nuclease Assay  by the Taq polymerase of the OF/OR while the 3′ end of IF and IR primers are been extended by another Taq polymerase molecule causing the noisy non-specific bands of varying sizes and intensity (Fig. 1a (i)). The SD polymerase is a variant of Taq polymerase with a 5′–3′ polymerase and 5′–3′ strand displacement activities but devoid of exonuclease activity . The strong displacement activity and lack of exonuclease activity of SD polymerase ensure no degradation of the IF and IR primers hence the chances of non-specific bands is reduced. We hypothesized that the properties of this SD polymerase will be useful for accurate and faster genotyping using T-ARMS PCR. It will be of great use for the faster genotyping and making T-ARMS PCR a preferable genotyping assay without the need of complex, laborious and lengthy standardization steps.
In T-ARMS PCR, the interaction of primers is a complex phenomenon and may partially depend on its sequence. In order to find the discriminating ability of four primers over all genotypes, it is hence important to have all the genotypes. The current study used a cloned mutant allele (Additional file 1) as mutant genotype.
Optimization of different parameters in SD polymerase based and Taq DNA polymerase-based T-ARMS PCR genotyping
SD polymerase based T-ARMS (SNP rs445709131)
Taq DNA polymerase based T-ARMS PCR (SNP rs445709131)
Outer: inner primer ratio
Annealing temperature (°C)
Genomic DNA quantity (ng)
Need of PCR enhancers
No. of PCR cycles
Each assay is assessed at various PCR cycles viz. 15, 20, 25, 30 and 35 cycles for the generation of all amplicons of sufficient intensity. Assessment is made by visualization on a 1.5% agarose gel. The correct genotyping ability of each protocol without non-specific band formation is also assessed by visualization on a 1.5% agarose gel. Temperature sensitivity of each protocol is measured by gradient PCR from 50 to 60 °C with an increment of 2 °C. DMSO used as PCR enhancer in the Taq polymerase based genotyping assay at a five percentage optimized level .
Results and discussion
T-ARMS PCR using both the Taq DNA polymerase and SD polymerase generated expected genotype pattern, hence have similar specificity; normal genotype for rs445709131 showed a 354 and 179 bp amplicons while the carriers showed an additional band of 230 bp (Fig. 1b). The mutant allele showed an expected genotyping pattern of only 354 and 230 bp amplicons indicating the discretionary ability of the primers on all genotypes (Additional file 1: Figure S2).
A higher concentration of outer primers found beneficial in case of SD Polymerase. It may be due to the fact that the outer primers are required for both outer–outer fragment generation as well as outer–inner fragment generation. In the case of Taq DNA polymerase, the 5′–3′ exonuclease activity may degrade the inner attached primers . Hence, it is sometimes needed to add more inner primers compared to outer primers . This property of Taq DNA polymerase may cause non-specific band formation . The optimum required unit of SD polymerase is tested for the amplification of all the amplicons. While 1U of SD polymerase generated low-intense outer amplicons, use of 2U of SD polymerase gave good amplification of both outer and inner amplicons (Additional file 1: Figure S3). In the case of Taq Polymerase, increasing the quantity of enzyme from 1U to 2U didn’t show any beneficial effect in T-ARMS PCR genotyping (Additional file 1: Figure S3). A comparison of the use of Taq polymerase and SD polymerase in polymerase chain displacement reaction (PCDR) reported a significant higher efficiency of SD polymerase while Taq polymerase fails to give successful pattern in four and six primer PCDR . It might be due to the fact that complex PCR with Taq polymerase need more optimization for the correct genotype pattern as shown in case of T-ARMS PCR for the rs445709131 .
The T-ARMS genotyping using SD polymerase generated good amplification at 25 cycles, making this protocol faster than Taq Polymerase-based genotyping which otherwise required 35 cycles to generate visible gel resolvable amplicons (Fig. 2a). Similarly, the higher efficiency of SD polymerase was reported in the case of long-range PCR and loop-mediated isothermal amplification (LAMP) . The strong displacement activity of SD polymerases like Bst polymerase and its high thermostability like Taq DNA polymerase enabled the SD polymerase a suitable polymerase in complex PCR like T-ARMS PCR.
The role of annealing temperature in T-ARMS PCR is reported [6, 11]. The SD polymerase showed good amplification in annealing temperatures varied from 50 to 60 °C (Fig. 2b (i)) whereas the Taq polymerase gave amplification of all amplicons only at 55 °C with optimized conditions of DMSO (5%) and MgCl2 (2 mM) (Fig. 2b (ii)). This higher susceptibility of Taq polymerase necessitates finding of the right annealing temperature with a right combination of MgCl2 and DMSO. It may indicate that Taq polymerase based T-ARMS PCR is sensitive to the changes in annealing temperature and reaction conditions which may be one of the reasons why T-ARMS PCR needed higher initial standardization as reported .
Modified assay with SD polymerase successfully generated correct genotype pattern with absences of DMSO while it was needed in case Taq DNA polymerase for genotyping of rs445709131 (Fig. 1b). The higher GC content of the region surrounding the rs445709131 (60.3%) or the difference in the GC content of the primers viz. OF (53.6%), OR (53.6%), IF (61.9%), IR (51.7%) necessitate the need of addition of DMSO in the reaction mix with Taq polymerase . The properties of DMSO is useful in bringing down the melting temperature of the primers [18, 19], hence important for the amplification moderate to high GC rich regions . The strong displacement activities of SD polymerase lead to better amplification of GC-rich regions , hence PCR enhancer like DMSO is not added to the reaction mix with SD polymerase. Hence, use of SD polymerase can generate amplicons in 25 PCR cycles in broad range of annealing temperature (50–60 °C) without need of addition of PCR enhancer like DMSO while the Taq Polymerase based T-ARMS required 35 cycles, needed DMSO addition and amplified in a specific narrow range of annealing temperature (55 °C).
SD polymerase based T-ARMS PCR genotyping is faster as the assay can be completed in 25 cycles compared to that of Taq polymerase based assay. It is less affected by the annealing temperature and reaction mix. The specificity of T-ARMS with SD Polymerase is same or better than the Taq DNA polymerase. In order to generate resolvable amplicons using Taq DNA polymerase extensive standardization with respect to the annealing temperature, salt (MgCl2) concentration, DMSO was needed. The SD polymerase, on the other hand, generated a T-ARMS genotyping pattern with less optimization. Hence, replacing the Taq DNA polymerase with SD polymerase can complete the T-ARMS PCR faster. The broader annealing temperature and lack of DMSO usage in SD polymerase may reduce the need for extensive standardization and may give better genotyping of GC-rich regions.
This study demonstrates the use of SD polymerase over Taq polymerase in T-ARMS PCR based genotyping of a single SNP. Hence, concluding the use of SD polymerase in T-ARMS PCR needs validation on more numbers of SNP. If can be validated, the major drawback of the T-ARMS PCR- extensive standardization and lack of GC rich amplification—can be overcome making the T-ARMS assay very user-friendly.
RRA planning and designing of the project, TVR, US and SK carried manuscript drafting, RD and RA carried sample collection, PCR–RFLP, GS and laboratory execution of work and BP carried manuscript editing, correction and overall monitoring of the project. All authors read and approved the final manuscript.
The authors are thankful to Director, Central Institute for Research on Cattle, Meerut, India for providing necessary facilities for conducting the study. We also acknowledge Director, Frieswal for providing the biological samples.
The authors declare that they have no competing interests.
Availability of data and materials
Data is been presented within the manuscript. The datasets used and/or analyzed during the current study also available from the corresponding author on reasonable request.
Consent to publish
Consent to participate
Ethics approval and consent to participate
Research has been approved by Institute Animal Ethics Committee (IAEC) of the ICAR-Central Institute for Research on Cattle, Meerut, UP, India under CPCSEA guidelines.
The research was supported by the ICAR under Institutional funding (IXX12180).
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
- 14.Butler JM. Advanced topics in forensic DNA typing: methodology. Walthan: Academic Press; 2011.Google Scholar
- 16.Alyethodi RR, Alex R, Deb R, Kumar S, Singh U, Sharma S, Gyanendra SS, Tyagi S, Prakash B. Prevalence of genetic diseases in Holstein crossbred (Frieswal) bulls in India. Indian J Anim Sci. 2016;86(9):1088–91.Google Scholar
- 18.Frackman S, Kobs G, Simpson D, Storts D. Betaine and DMSO: enhancing agents for PCR. Promega Notes. 1998;65:27–9.Google Scholar
Open AccessThis article is distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution, and reproduction in any medium, provided you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons license, and indicate if changes were made. The Creative Commons Public Domain Dedication waiver (http://creativecommons.org/publicdomain/zero/1.0/) applies to the data made available in this article, unless otherwise stated.