# The use of percentage change from baseline as an outcome in a controlled trial is statistically inefficient: a simulation study

- 70k Downloads
- 158 Citations

## Abstract

### Background

Many randomized trials involve measuring a continuous outcome - such as pain, body weight or blood pressure - at baseline and after treatment. In this paper, I compare four possibilities for how such trials can be analyzed: post-treatment; change between baseline and post-treatment; percentage change between baseline and post-treatment and analysis of covariance (ANCOVA) with baseline score as a covariate. The statistical power of each method was determined for a hypothetical randomized trial under a range of correlations between baseline and post-treatment scores.

### Results

ANCOVA has the highest statistical power. Change from baseline has acceptable power when correlation between baseline and post-treatment scores is high;when correlation is low, analyzing only post-treatment scores has reasonable power. Percentage change from baseline has the lowest statistical power and was highly sensitive to changes in variance. Theoretical considerations suggest that percentage change from baseline will also fail to protect from bias in the case of baseline imbalance and will lead to an excess of trials with non-normally distributed outcome data.

### Conclusions

Percentage change from baseline should not be used in statistical analysis. Trialists wishing to report this statistic should use another method, such as ANCOVA, and convert the results to a percentage change by using mean baseline scores.

### Keywords

Percentage Change Pravastatin Baseline Score High Statistical Power Reasonable Power## Background

Many randomized trials involve measuring a continuous outcome at baseline and after treatment. Typical examples include trials of pravastatin for hypercholesterolemia [1], exercise and diet for obesity in osteoarthritis patients [2] and acupuncture for pain in athletes with shoulder injuries [3]. In each trial, the outcome measure used to determine the effectiveness of treatment - cholesterol, body weight or shoulder pain - was measured both before treatment had started and after it was complete.

Some trials assess outcome several times after treatment, a design known as "repeated measures." Each of the four methods described above can be used to analyze such trials by using a summary statistic such as a mean or an "area-under-curve" [4]. There are several more complex methods of analyzing such data including repeated measures analysis of variance and generalized linear estimation [5]. These methods are of particular value when the post-treatment scores have a predictable course over time (e.g. quality of life in late stage cancer patients) or when it is important to assess interactions between treatment and time (e.g. long-term symptomatic medication). This paper will concentrate on the simpler case where time in not an important independent variable.

The choice of which method to use can be determined by analysis of the statistical properties of each. An important criteria for a good statistical method is that it should reduce the rate of false negatives (β). The β of a statistical test is usually expressed in terms of statistical power (1-β). Power is normally fixed, typically at 0.8 or 0.9, and the required amount of data (e.g. number of evaluable patients) is calculated. A method that requires relatively fewer data to provide a certain level of statistical power is described as *efficient.*

The characteristics of the four methods - POST, CHANGE, FRACTION and ANCOVA - have been studied by statisticians for some time [6, 7, 8]. In this paper, I aim to provide statistical data that can guide clinical research yet is readily comprehensible by non-statisticians. Accordingly, I will compare the methods using a hypothetical trial and express results in terms of statistical power.

## Methods

All calculations and simulations were conducted using the statistical software Stata 6.0 (Stata Corp., College Station, Texas). I created a hypothetical pain trial with patients divided evenly between a treatment and a control group. The pain score for any individual patient was sampled from a normal distribution. The mean score at baseline was 50 mm on a visual analog scale of pain (VAS); after treatment, mean pain was expected to be 50 mm in controls and 45 mm in treated patients. The standard deviation of all scores was 10. The text of the simulation is given in the appendix (appendix.doc).

I calculated the statistical power of the different methods of analysis for this trial given a sample size of 100 patients. As power varies according to the correlation between baseline and follow-up scores, a range of different possible correlations were used. The power for POST, CHANGE and ANCOVA were calculated using the "sampsi" function of Stata. This derives power analytically using formula developed by Frison and Pocock [6]. The power for FRACTION was calculated by the simulation described above. The simulation was first validated against Stata's results for POST and CHANGE at a correlation of 0.5. It was then conducted using 1000 repetitions calculating ttests for FRACTION at a range of correlations between 0.2 and 0.8. The number of results in which p was less than 5% was calculated.

## Results and Discussion

Statistical power of each method of analysis

Correlation | ρ = 0.2 | ρ = 0.35 | ρ = 0.5 | ρ = 0.65 | ρ = 0.8 |
---|---|---|---|---|---|

POST | 70.5% | 70.5% | 70.5% | 70.5% | 70.5% |

FRACTION | 45.1% | 56.4% | 67.0% | 82.7% | 97.1% |

CHANGE | 50.7% | 59.2% | 70.5% | 84.8% | 97.7% |

ANCOVA | 72.3% | 76.1% | 82.3% | 90.8% | 98.6% |

Moreover, the power of FRACTION is sensitive to changes in the characteristics of the baseline distribution. If the range of baseline values is large, the variance of FRACTION increases disproportionately and power falls. Simulations were repeated with the standard deviations and difference between groups doubled. There was no difference in the power of POST, CHANGE or ANCOVA. The power of FRACTION fell dramatically: at correlations of 0.2, 0.35, 0.5, 0.65 and 0.8 respectively, power was 18%, 24%, 33%, 45% and 63%.

It is arguable that the method of simulation is biased against FRACTION because the treatment effect is additive, that is, the simulation models an absolute 5 mm difference between groups. In theory, the difference between FRACTION and CHANGE should decrease if the treatment effect is proportional. The simulation was therefore repeated with the treatment group experiencing an average 10% decrease from baseline. Correlation between baseline and follow-up scores was varied randomly between 0.2 and 0.8. The p values from a ttest of FRACTION and CHANGE were directly compared over 1000 simulations: p values were lower for CHANGE approximately 65% of the time.

Theoretical considerations suggestion two further disadvantages to FRACTION. First, because it incorporates both baseline and post-treatment scores, it would appear to control for any chance baseline imbalance between groups. However, this is not the case because of regression to the mean: FRACTION will create a bias towards the group with poorer baseline scores (the same is true for CHANGE; POST causes bias in the opposite direction). Second, because it is calculated using a ratio, it may cause outcome data to be non-normally distributed. In a bivariate normal distribution (such as a baseline and post-treatment score) any statistic using either variable alone or combining both by addition or subtraction will be normally distributed. There is no analytic reason why a statistic created by multiplying or dividing one variable by the other should necessarily have a normal distribution.

## Conclusion

Reporting a percentage change from baseline gives the results of a randomized trial in clinically relevant terms immediately accessible to patients and clinicians alike. This is presumably why researchers investigating issues such as the effects of medication on hot flashes [9], or of different chemotherapy regimes on quality of life [10], report this statistic.

However, percentage change from baseline is statistically inefficient. Perhaps counterintuitively, it does not correct for imbalance between groups at baseline. It may also create a non-normally distributed statistic from normally distributed data. Percentage change from baseline should therefore not be used in statistical analysis. Trialists wishing to report percentage change should first use another method, preferably ANCOVA, to test significance and calculate confidence intervals. They should then convert results to percentage change by using mean baseline and post-treatment scores. For an example of this approach, see Crouse et al. [11].

The findings presented here reconfirm previously reported data suggesting that ANCOVA is the method of choice for analyzing the results of trials with baseline and post treatment measurement. In cases where ANCOVA cannot be used, such as with small samples or where the assumptions underlying ANCOVA modeling do not hold, CHANGE or POST are acceptable alternatives, especially baseline variables are comparable between groups (perhaps ensured by stratification) and if correlation between baseline and post-treatment scores are either high (for CHANGE) or low (for POST). The use of FRACTION should be avoided.

## Notes

## Supplementary material

### References

- 1.Glorioso N, Troffa C, Filigheddu F, Dettori F, Soro A, Parpaglia PP, Collatina S, Pahor M: Effect of the HMG-CoA reductase inhibitors on blood pressure in patients with essential hypertension and primary hypercholesterolemia. Hypertension. 1999, 34: 1281-1286.CrossRefPubMedGoogle Scholar
- 2.Messier SP, Loeser RF, Mitchell MN, Valle G, Morgan TP, Rejeski WJ, Ettinger WH: Exercise and weight loss in obese older adults with knee osteoarthritis: a preliminary study. J Am Geriatr Soc. 2000, 48: 1062-1072.CrossRefPubMedGoogle Scholar
- 3.Kleinhenz J, Streitberger K, Windeler J, Gussbacher A, Mavridis G, Martin E: Randomised clinical trial comparing the effects of acupuncture and a newly designed placebo needle in rotator cuff tendinitis. Pain. 1999, 83: 235-241. 10.1016/S0304-3959(99)00107-4.CrossRefPubMedGoogle Scholar
- 4.Matthews JNS, Altman D, Campbell MJ, Royston P: Analysis of serial measurements in medical research. BMJ. 1990, 300: 230-235.CrossRefPubMedPubMedCentralGoogle Scholar
- 5.Omar RZ, Wright EM, Turner RM, Thompson SG: Analysing repeated measurements data: a practical comparison of methods. Stat Med. 1999, 18: 1587-1603. 10.1002/(SICI)1097-0258(19990715)18:13<1587::AID-SIM141>3.0.CO;2-Z.CrossRefPubMedGoogle Scholar
- 6.Harris CW: Problems in measuring change. Madison: University of Wisconsin Press. 1967Google Scholar
- 7.Frison L, Pocock SJ: Repeated measures in clinical trials: analysis using mean summary statistics and its implications for design. Stat Med. 1992, 11: 1685-1704.CrossRefPubMedGoogle Scholar
- 8.S Senn: Statistical Issues in Drug Development. Chichester: John Wiley. 1997Google Scholar
- 9.Loprinzi CL, Michalak JC, Quella SK, O'Fallon JR, Hatfield AK, Nelimark RA, Dose AM, Fischer T, Johnson C, Klatt NE, et al: Megestrol acetate for the prevention of hot flashes. N Engi J Med. 1994, 331: 347-352. 10.1056/NEJM199408113310602.CrossRefGoogle Scholar
- 10.Anderson H, Hopwood P, Stephens RJ, Thatcher N, Cottier B, Nicholson M, Milroy R, Maughan TS, Falk SJ, Bond MG, Burt PA, Connolly CK, Mclllmurray MB, Carmichael J: Gemcitabine plus best supportive care (BSC) vs BSC in inoperable non-small cell lung cancer - a randomized trial with quality of life as the primary outcome. UK NSCLC Gemcitabine Group. Non-Small Cell Lung Cancer. Br J Cancer. 2000, 83: 447-453. 10.1054/bjoc.2000.1307.CrossRefPubMedPubMedCentralGoogle Scholar
- 11.Crouse JR, Morgan T, Terry JG, Ellis J, Vitolins M, Burke GL: A randomized trial comparing the effect of casein with that of soy protein containing varying amounts of isoflavones on plasma concentrations of lipids and lipoproteins. Arch Intern Med. 1999, 159: A2070-2076. 10.1001/archinte.159.17.2070.CrossRefGoogle Scholar

### Pre-publication history

- The pre-publication history for this paper can be accessed here:http://www.biomedcentral.com/content/backmatter/1471-2288-1-6-b1.pdf

## Copyright information

This article is published under license to BioMed Central Ltd. This is an Open Access article: verbatim copying and redistribution of this article are permitted in all media for any purpose, provided this notice is preserved along with the article's original URL.