Abstract
A model of microplastic deformation in surface layers of nitrided structural steels under the incoherent boundaries of nanodisperse reinforcing particles formed upon thermochemical treatment is considered, allowing the adaptive evolution of deformation without the accumulation of defects at the near-boundary zones, which provides high wear resistance of the material.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Semenov, M.Yu., Gavrilin, I.N., and Ryzhov, M.Yu., Computation-based analysis of the methods of hardening of gears from heat-resistant steels, Metal Sci. Heat Treat., 2014, vol. 56, pp. 45–49.
Gerasimov, S.A., Kuksenova, L.I., and Lapteva, V.G., Struktura i iznosostoikost’ azotirovannykh konstruktsionnykh stalei i splavov (Structure and Wear-resistance of Nitrated Structural Steels and Alloys), Moscow: Mos. Gos. Tekhn. Univ., 2012.
Alekhin, V.P., Fizika prochnosti i plastichnosti poverkhnostnykh sloev materialov (Physics of Strength and Plasticity of Surface Layers of Materials), Moscow: Nauka, 1983.
Rybakova, L.M. and Kuksenova, L.I., Struktura i iznosostoikost’ metalla (Structure and Wear-resistance of Metal), Moscow: Mashinostroenie, 1982.
Alekseev, N.M., Reguliarities of plastic flow and decomposition of metals at jamming of rubbing surfaces, Extended Abstract of Doctoral (Eng.) Dissertation, Moscow, 1983.
Bushe, N.A. and Kopyt’ko, V.V., Sovmestimost’ trushchikhsya poverkhnostei (Compatibility of Rubbing Surfaces), Moscow: Nauka, 1981.
Polyakov, S.A. and Kuksenova, L.I., “Mechanisms of deformation of near-surface layers of metals and possibility of self-organization in these processes,” Problemy Mashinostr. Nadezhnosti Mashin, 2006, no. 4, pp. 51–61.
Osnovy tribologii (trenie, iznos, smazka) (Foundations of Tribology (Friction, Wear, Lubrication)), ed. by Chichinadze, A.V., Moscow: Mashinostroenie, 2001.
Geguzin, Ya.E., Diffuzionnaya zona (Diffusion Zone), Moscow: Nauka, 1979.
Kosevich, A.M., Osnovy mekhaniki kristallicheskoi reshetki (Foundations of Crystal Lattice Mechanics), Moscow: Nauka, 1972.
Chumachenko, E.N., Smirnov, O.M., and Tsepin, M.A., Sverkhplastichnost’: materialy, teoriya, tekhnologii (Superplasticity: Materials, Theory, Technologies), Moscow: KomKniga, 2005.
Chuvil’deev, V.N., Nokhkin, A.N., Kopylov, V.I., Gryaznov, M., Pirozhnikova, O.E., and Lopatin, Yu., Effect of simultaneous increasing of strength and plasticity at room temperature of nano- and microcrystallic metals obtained by severe plastic deformation methods. Model of calculation of extreme strength and plasticity at room temperature, Materialovedenie, 2010, no. 12, pp. 4–11.
Nikolis, G. and Prigozhin, I., Self-organization in Nonequilibrium Systems. From Dissipative Structures to Order through Fluctuations New York:. Wiley, 1977; Moscow: Mir, 1979.
Kaibyshev, O.A. and Valiev, R.Z., Granitsy zeren i svoistva metallov (Boundaties of Grains and Properties of Metals), Moscow: Metallurgiya, 1987.
Lyubov, B.Ya., Diffuzionnye izmeneniya defektnoi struktury tverdykh tel (Defect Changes of Solid Defect Structure), Moscow: Metallurgiya, 1985.
Zil’bershmidt, V.V., Deformation behavior of materials in the conditions of superplasticity, in Problemy nelineinoi mekhaniki deformiruemogo tverdogo tela (Problems of Nonlinear Mechanics of Deformed Solid), Sverdlovsk: Ural. Otd. Akad. Nauk SSSR, 1990, pp. 59–69.
Polyakov, S.A., Samoorganizatsiya pri trenii i effekt bezyznosnosti (Self-organization at Friction and Effect of Non-Wear), Moscow: TSKhA, 2009.
Berezina, E.V., Michugina, M.S., Lapteva, V.G., and Kuksenova, L.I., Structure and Wear-resistance of steel after different methods of nitriding, Deform. Razrush. Mater., 2008, no. 4, pp. 29–37.
Gerasimov, S.A., Kraposhin, V.S., Lisotskii, I.V., Berezina, E.V., Lapteva, V.G., and Kuksenova, L.I., Effect of nanocrystallic phase of iron nitrides on wear resistance of nitridied steel 38Kh2MYuA, in Trudy Vserossiiskoi nauchno-tekhnicheskoi konferentsii “Mashinostroitel’nye tekhnologii”, posvyashchennoi 140-letiyu vysshego tekhnologicheskogo obrazovaniya v MGTU im. N.E. Baumana (Proc. All-Russia Sci.-Techn. Conf. “Machine Eng. Technol.”, dedicated to 140th Anniversary of Higher Technol. Education in Mos. Gos. Technol. Univ.), Moscow: Mos. Gos. Tekhn. Univ.), 2008, pp. 216–218.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © S.A. Polyakov, L.I. Kuksenova, V.G. Lapteva, M.S. Alekseyeva, 2016, published in Materialovedenie, 2016, No. 3, pp. 24–31.
Rights and permissions
About this article
Cite this article
Polyakov, S.A., Kuksenova, L.I., Lapteva, V.G. et al. Analysis of microplastic deformation processes of surface layers of nitrided structural steels. Inorg. Mater. Appl. Res. 7, 618–623 (2016). https://doi.org/10.1134/S2075113316040298
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S2075113316040298