Advertisement

Polymer Science, Series D

, Volume 12, Issue 1, pp 77–79 | Cite as

Evaluation of Structural Defects of Articles Obtained in Various Modes of 3D Printing

  • I. S. Nefelov
  • N. I. BaurovaEmail author
Article
  • 10 Downloads

Abstract

The influence of various technological modes of 3D printing on the microstructure of an article fabricated via the fused deposition modeling printing methods has been studied. The optimal combination of printing parameters allowing pronounced reduction of structural defects has been established as well.

Keywords:

additive technologies 3D printers fused deposition modeling technology quality control technological modes print rate layer thickness feed rate filling 

Notes

REFERENCES

  1. 1.
    V. A. Valetov, Additive Technologies (State and Prospects). Textbook (Universitet ITMO, St. Petersburg, 2015) [in Russian].Google Scholar
  2. 2.
    M. A. Zlenko, A. A. Popovich, and I. N. Mutylina, Additive Technologies in Mechanical Engineering. Textbook (S.-Peterb. Gos. Univ., St. Petersburg, 2013) [in Russian].Google Scholar
  3. 3.
    N. I. Baurova and A. Y. Sergeev, “Structural studies of fracture patterns in adhesive joints after pullout testing,” Polym. Sci., Ser. D 7 (4), 298–302 (2014).Google Scholar
  4. 4.
    V. A. Nelyub, “A study of the microstructure of dressed glass fibers,” Polym. Sci., Ser. D 9 (1), 96–100 (2016).Google Scholar
  5. 5.
    A. P. Pavlov and E. V. Polukhin, “Methods to ensure the efficiency of performance of 3D-printers in a production environment,” Remont Vosstanov. Modernizatsiya, No. 3, 16–20 (2017).Google Scholar
  6. 6.
    I. S. Nefelov and N. I. Baurova, “Formation of threaded surfaces in the components produced by 3D printing,” Russ. Metall. (Metally), No. 13, 72–74 (2017).Google Scholar
  7. 7.
    B. Evans, Practical 3D Printers: The Science and Art of 3D Printing (Apress, 2012).CrossRefGoogle Scholar
  8. 8.
    I. S. Nefelov, M. I. Timchenko, N. I. Baurova, and V. A. Zorin, “Study of the influence of technological modes of 3D printing on the strength parameters of parts,” Mekh. Stroit. 79 (2), 25–30 (2018).Google Scholar
  9. 9.
    I. S. Nefelov, “Analysis of defects of parts manufactured by the method of layer-by-layer thread fusion on a 3D printer,” Vse Mater., Entsikl. Sprav., No. 9, 76– 80 (2016).Google Scholar
  10. 10.
    N. I. Baurova, V. A. Zorin, and V. M. Prikhodko, “Manifestation of a synergistic effect in technological heredity,” Polym. Sci., Ser. D 9 (2), 209–211 (2016).Google Scholar

Copyright information

© Pleiades Publishing, Ltd. 2019

Authors and Affiliations

  1. 1.Moscow Automobile and Road Construction State Technical University (MADI)MoscowRussia

Personalised recommendations