Advertisement

Thermal Engineering

, Volume 65, Issue 13, pp 1009–1018 | Cite as

Combustion of Lean Hydrogen-Based Mixtures in a Spark Ignition Engine

  • V. M. Zaichenko
  • A. D. Kiverin
  • A. E. SmygalinaEmail author
  • A. I. Tsyplakov
Article
  • 6 Downloads

Abstract

In this paper, the results of an experimental and modeling study of the combustion of lean mixtures based on hydrogen in a spark ignition engine are presented. A hydrogen and a hydrogen (90 vol %)-methane (10 vol %) mixture with air excess coefficients of 1.4–3.0 were used as fuel. “Back flashes” in the intake manifold were experimentally observed when the hydrogen-air mixture was burned at the air excess coefficient of 1.4. At large air excess coefficients, the key indicators of the engine performance are determined by using the experimental indicator diagrams. The efficiency indicator for hydrogen-air mixtures was 30–32%. The highest efficiency of 37% was obtained by using an earlier ignition in mixtures with methane addition. A weak dependence of the efficiency on the air excess coefficient was found. The major qualitative relationships obtained experimentally were supported by the performed 2D numerical simulation of the dynamics and combustion of mixtures under experimental conditions. Incomplete hydrogen combustion of up to 60% is observed at an air excess factor of 3.0.

Keywords

hydrogen methane spark ignition engine indicator diagram lean mixtures experiment numerical simulation 

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

References

  1. 1.
    V. M. Batenin, V. M. Zaichenko, A. I. Leont’ev, and A. A. Chernyavskii, “The concept of development of distributed energy in Russia,” Izv. Ross. Akad. Nauk. Energ., No. 1, 3–18 (2017).Google Scholar
  2. 2.
    V. M. Zaichenko and A. A. Chernyavskii, “Comparative characteristics of distributed and centralized power supply schemes,” Prom. Energ., No. 1, 2–8 (2016).Google Scholar
  3. 3.
    A. V. Da Rosa, Fundamentals of Renewable Energy Processes (Academic, Oxford, 2013).Google Scholar
  4. 4.
    V. M. Zaichenko and A. A. Chernyavskii, Autonomous Power Supply Systems (Nedra, Moscow, 2015) [in Russian].Google Scholar
  5. 5.
    A. E. Smygalina, V. M. Zaichenko, M. F. Ivanov, and A. D. Kiverin, “Combustion of hydrogen-based mixtures in gas-fueled reciprocating engines,” Izv. Ross. Akad. Nauk. Energ., No. 2, 120–130 (2015).Google Scholar
  6. 6.
    M. F. Ivanov, A. D. Kiverin, A. E. Smygalina, and V. M. Zaichenko, “The use of hydrogen as a fuel for engines in the energy cycle of remote production facilities,” Tech. Phys. 88, 148–151 (2018).CrossRefGoogle Scholar
  7. 7.
    G. Morozov, “Hydrogen — Fuel of the future,” Katera Yakhty, No. 2, 4–7 (1984).Google Scholar
  8. 8.
    A. I. Mishchenko, The Use of Hydrogen for Automobile Engines (Naukova Dumka, Kiev, 1984) [in Russian].Google Scholar
  9. 9.
    Hydrogen Fuel Cell Engines and Related Technologies: Rev 0 (2001}). https://doi.org/www1.eere.energy.gov/hydrogenandfuelcells/tech_validation/pdfs/fcm01r0.pdf
  10. 10.
    L. E. Magidovich and V. V. Rumyantsev, “Combustion conditions of a hydrogen-air mixture in internal combustion engines,” Dvigatelestroenie, No. 5, 59–60 (1983).Google Scholar
  11. 11.
    A. M. Levterov and V. D. Savitskii, “Experimental sample of hydrogen car on the basis of the model GAZ-2705,” Avtomob. Transp., No. 22, 17–23 (2008).Google Scholar
  12. 12.
    T. Shudo, “Improving thermal efficiency by reducing cooling losses in hydrogen combustion engines,” Int. J. Hydrogen Energy 32, 4285–4293 (2007).CrossRefGoogle Scholar
  13. 13.
    M. F. Ivanov, A. D. Kiverin, I. S. Yakovenko, and M. A. Liberman, “Hydrogen-oxygen flame acceleration and deflagration-to-detonation transition in threedimensional rectangular channels with no-slip walls,” Int. J. Hydrogen Energy 38, 16427–16440 (2013).CrossRefGoogle Scholar
  14. 14.
    M. F. Ivanov, A. D. Kiverin, B. A. Klumov, and V. E. Fortov, “From combustion and detonation to nitrogen oxides,” Phys.-Usp. 57, 234–249 (2014).CrossRefGoogle Scholar
  15. 15.
    M. O. Conaire, H. J. Curran, J. M. Simmie, et al., “A comprehensive modeling study of hydrogen oxidation,” Int. J. Chem. Kinetics 36, 603–622 (2004).CrossRefGoogle Scholar
  16. 16.
    A. Kazakov and M. Frenklach, Reduced Reaction Sets based on GRI-Mech 1.2. https://doi.org/www.me.berkeley.edu/drm/.
  17. 17.
    J. B. Heywood, Internal Combustion Engine Fundamentals (Mc. Graw Hill, New York, 1988).Google Scholar
  18. 18.
    A. G. Korotkikh, Thermal Conductivity of Materials (Izd. Tomsk. Politekh. Univ., Tomsk, 2011) [in Russian].Google Scholar
  19. 19.
    S. P. M. Bane, J. L. Ziegler, and J. E. Shepherd, “Investigation of the effect of electrode geometry on spark ignition,” Combust. Flame 162, 462–469 (2015).CrossRefGoogle Scholar
  20. 20.
    A. N. Voinov, Combustion in High-Speed Piston Engines (Mashinostroenie, Moscow, 1977) [in Russian].Google Scholar
  21. 21.
    T. Shudo, “A new equation to describe cooling loss in hydrogen combustion engines which was developed from the equation for turbulent heat transfer of pipe flows,” in Proc. 6th World Conf. on Experimental Heat Transfer, Fluid Mechanics, and Thermodynamics, Matsushima, Miyagi, Japan, Apr. 17–21, 2005 (Matsushima, 2005).Google Scholar
  22. 22.
    A. I. Tsyplakov, Gas-Piston Power Installations Working on Generator Gas: Features of Construction, Operating Experience, Experimental Research Results, Preprint No. 3–512, OIVT RAN (Joint Inst. of High Temperatures of the Russian Academy of Sciences, Moscow, 2013).Google Scholar

Copyright information

© Pleiades Publishing, Inc. 2018

Authors and Affiliations

  • V. M. Zaichenko
    • 1
  • A. D. Kiverin
    • 1
  • A. E. Smygalina
    • 1
    Email author
  • A. I. Tsyplakov
    • 1
  1. 1.Joint Institute for High TemperaturesRussian Academy of SciencesMoscowRussia

Personalised recommendations