Advertisement

Russian Metallurgy (Metally)

, Volume 2019, Issue 13, pp 1483–1486 | Cite as

Effect of Machining of the Edge of a Blank Made of a Polymer Composite Material on Its Water Resistance

  • R. Ch. Ikhuaen’i
  • N. I. BaurovaEmail author
MACHINING OF BLANKS AND ASSEMBLY
  • 4 Downloads

Abstract

The influence of the method of machining of the edges of carbon-filled plastics on their water absorption is experimentally studied. The water absorption of composite materials is shown to depend on both the method of machining of the edges and the plastic material. The results of structural investigations demonstrate that milling is the most suitable method for machining the edges of the polymer composite material parts produced by vacuum infusion.

Keywords:

water absorption machining polymer composite material carbon-filled plastic 

Notes

REFERENCES

  1. 1.
    V. A. Nelyub, “Application of polymer composite materials in shipbuilding for the repair of ship superstructure,” Remont, Vosstanovlenie, Modernizatsiya, No. 5, 21–24 (2013).Google Scholar
  2. 2.
    A. I. Rudskoi, A. A. Popovich, and A. V. Grigor’ev, Composite Materials and Coatings (St. Petersburg, 2017).Google Scholar
  3. 3.
    N. V. Lapina and N. I. Baurova, “Feature of processing machinery parts for workability when transiting to new construction materials,” Polym. Sci., Ser. D 9 (3), 326–330 (2016).Google Scholar
  4. 4.
    N. I. Baurova and K. A. Makarov, “Machining of machine elements made of polymer composite materials,” Russ. Metall. (Metally), No. 13, 1141–1144 (2017).CrossRefGoogle Scholar
  5. 5.
    A. P. Petrova and G. V. Malysheva, Glues, Glue Binders, and Glue Prepregs, Ed. by E. N. Kablov (VIAM, Moscow, 2017).Google Scholar
  6. 6.
    V. A. Skryabin, “Manufacturability of polymer materials by blade processing methods,” Vse Mater. Entsiklop. Spravochnik, No. 5, 41–48 (2016).Google Scholar
  7. 7.
    N. I. Baurova, V. A. Zorin, and V. M. Prikhodko, “Manifestation of a synergistic effect in technological heredity,” Polym. Sci., Ser. D 9 (2), 209–211 (2016).Google Scholar
  8. 8.
    A. G. Skhirtladze and V. A. Timiryazev, “Restoration of worn hole surfaces in technological components,” Remont, Vosstanovlenie, Modernizatsiya, No. 5, 3–9 (2016).Google Scholar
  9. 9.
    V. A. Skryabin, “Improvement of the process of finishing treatment of flat article surfaces by densified fine abrasive media,” Tekhn. Metallov, No. 6, 26–36 (2016).Google Scholar

Copyright information

© Pleiades Publishing, Ltd. 2019

Authors and Affiliations

  1. 1.Moscow Automobile and Road Construction UniversityMoscowRussia

Personalised recommendations