Abstract
Dimensions of one kind of stainless steel plate before finish rolling were obtained through analysis of the rough rolling processes by finite element method and updated geometrical method. The FE models of finish rolling process with a front edge roll were built, and influences of the edge rolling reduction on the stress change in the plate edge during finish rolling were analyzed. The results show that when the edge rolling reduction is increased from 0 mm to 2 mm, the compressive stress in plate corner clearly increases in edge rolling process, and the zone of tensile stress during whole rolling decreases; when the edge rolling reduction is increased from 2 mm to 5 mm, the compressive stress in the plate corner seldom changes, and the compressive stress decreases after the horizontal rolling.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
JI Zhi-lei, SHI Rong-hua. Study on Formation Cause of Severe Cracked Edge of Stainless Steel Plate During Hot Continuous Rolling [J]. BaoSteel Technology, 2000, 18(1): 20 (in Chinese).
LIU Hui, GAO Cai-ru, WANG Guo-dong, et al. Affection of Edger Shape on the Plate Profile [J]. Journal of Plasticity Engineering, 2003, 10(5): 86 (in Chinese).
XIONG Shang-wu, LIU Xiang-hua, WANG Guo-dong, et al. A Three-Dimensional Finite Element Simulation of the Vertical-Horizontal Rolling Process in the Width Reduction of Plate [J]. J Mater Process Technol, 2000, 101(1): 146.
XIONG Shang-wu, ZHENG Gui-fang, LIU Xiang-hua, et al. Analysis of the Non-Steady State Vertical-Horizontal Rolling Process in Roughing Trains by the Three-Dimensional Finite Element Method [J]. J Mater Process Technol, 2002, 120(1–3): 53.
YU Hai-liang, LIU Xiang-hua, ZHAO Xian-ming, et al. FEM Analysis for V-H Rolling Process by Updating Geometric Method [J]. J Mater Process Technol, 2006, 180(1–3): 323.
YU Hai-liang, LIU Xiang-hua, LI Chang-sheng. Influence of Groove Fillet Radii of Edge Roll on Plate Deformation [J]. Iron and Steel, 2006, 41(6): 47 (in Chinese).
YU Hai-liang, LIU Xiang-hua, LI Chang-sheng, et al. Behavior of Transversal Crack on Plate Corner During V-H Rolling Processes [J]. J Iron Steel Res Int, 2006, 13(6): 31.
YU Hai-liang, LIU Xiang-hua, LI Chang-sheng, et al. Research on the Corner Stress of Dog-Bone Shaped Workpiece During Flat Spread Rolling [J]. Journal of Northeastern University (Natural Science), 2006, 27(11): 1228 (in Chinese).
Author information
Authors and Affiliations
Corresponding author
Additional information
Foundation Item: Item Sponsored by State Basic Research Key Projects (973) of China (2006CB605208-1); National Natural Science Foundation of China (50534020, 50634030)
Rights and permissions
About this article
Cite this article
Yu, Hl., Liu, Xh., Chen, Lq. et al. Influence of Edge Rolling Reduction on Plate-Edge Stress Distribution During Finish Rolling. J. Iron Steel Res. Int. 16, 22–26 (2009). https://doi.org/10.1016/S1006-706X(09)60005-4
Revised:
Published:
Issue Date:
DOI: https://doi.org/10.1016/S1006-706X(09)60005-4